Sharif Digital Repository

A new small array of Cherenkov detectors has been deployed in Tehran, 1200 m above sea level. This array contains four tanks of distilled water with a diameter of 64 cm and a height of 130 cm. The effective area of each tank is about 1382 cm2. They are used to detect air showers and to record the arrival time of the secondary particles. We have collected about 640 000 extensive air showers (EAS) in 8298 h of observation time from November 2006 to October 2007. The distribution of air showers in zenith and azimuth angles has been studied and a cosn distribution with n = 6.02 0.01 was obtained for the zenith angle distribution. An asymmetry has been observed in the azimuthal distribution of... 

Over the past few decades, industrial development has caused a dramatic increment in greenhouse gas (GHG) emissions, as a leading cause of climate change. Modifying the industrial plants' environmental performance is the main pillar of improving efficiency that can reduce the waste of resources and make achieving lower-cost global emission reduction targets of the Kyoto protocol's clean development mechanism (CDM) possible. Considering the essentiality of knowledge-based research in increasing the awareness of policymakers by providing better access to accurate and reliable information, an analytical survey on efficiency in oil, gas, and petrochemical industries has been conducted by... 

Over the past few decades, industrial development has caused a dramatic increment in greenhouse gas (GHG) emissions, as a leading cause of climate change. Modifying the industrial plants' environmental performance is the main pillar of improving efficiency that can reduce the waste of resources and make achieving lower-cost global emission reduction targets of the Kyoto protocol's clean development mechanism (CDM) possible. Considering the essentiality of knowledge-based research in increasing the awareness of policymakers by providing better access to accurate and reliable information, an analytical survey on efficiency in oil, gas, and petrochemical industries has been conducted by... 

Herein, the fracture toughness of ternary epoxy systems containing nanosilica and hollow glass microspheres (HGMS) is investigated. The experimental measurements reveal synergistic fracture toughness in some hybrid compositions: The incorporation of 10 phr of HGMS and nanosilica alone modify the fracture toughness of epoxy by 39% and 91%, respectively. However, use of 10 phr hybrid modifier can enhance the fracture toughness of the resin up to 120%. Observations reveal different toughening mechanisms for the blends i.e., plastic deformation for silica nanoparticles and crack bifurcation for HGMS. Both of these toughening mechanisms additively contribute to the synergism in ternary epoxies  

Toughening of epoxy with different types of modifiers produces a bimodal blend that might show better fracture resistance in comparison with single-modified ones. In this research, bimodal epoxy formulations including mixtures of glass microsphere and silica nanoparticles are explored for possible synergistic toughening. The influence of composition on the glass transition temperature (Tg), tensile characteristics, and fracture toughness (KIC) is investigated. Interestingly, a synergism in fracture toughness is observed when mixtures of modifiers were incorporated. For the fixed overall modifier content, KIC is higher when the volume fraction of glass microsphere is lesser than the volume... 

For modeling the electromechanical behavior of nano-bridge structures with slender narrow-width beam elements, not only the simultaneous effects of surface layer and size dependency should be taken into account but also corrected force models should be considered. In this paper, the instability of a narrow-width nano-bridge is studied based on strain gradient theory and Gurtin–Murdoch surface elasticity. The mid-plane stretching is incorporated in the governing equation as well as corrected force distribution. Using Rayleigh–Ritz method, a parametric analysis is conducted to examine the impacts of surface layer, size dependence, dispersion forces and structural damping on static and dynamic... 

The present research is devoted to theoretical study of the pull-in performance of double-sided and paddle-type NEMS actuators fabricated from cylindrical nanowire operating in the Casimir regime and in the presence of the centrifugal force. D'Alembert's principle was used to transform the angular velocity into an equivalent static, centrifugal force. Using the couple stress theory, the constitutive equations of the actuators were derived. The equivalent boundary condition technique was applied to obtain the governing equation of the paddle-type actuator. Three distinct approaches, the Duan-Adomian Method (DAM), Finite Difference Method (FDM), and Lumped Parameter Model (LPM), were applied... 

In this research, rubber based nanocomposites with presence of nanoparticle has been studied. Styrene butadiene rubber (SBR)/nanocopper (NC) composites were prepared using two-roll mill method. Transmission electron microscope (TEM) and scanning electron microscope (SEM) images showed proper dispersion of NC in the SBR matrix without substantial agglomeration of nanoparticles. To evaluate the curing properties of nanocomposite samples, swelling and cure rheometric tests were conducted. Moreover, the rheological studies were carried out over a range of shear rates. The effect of NC particles was examined on the thermal behavior of the SBR using thermal gravimetric analysis (TGA). Furthermore,... 

The study of the anisotropy of the arrival directions is an essential tool to investigate the origin and propagation of cosmic ray primaries. A simple way of recording many cosmic rays is to record coincidences between a number of detectors. We have monitored multi-TeV cosmic rays by a small array of water Cherenkov detectors in Tehran (35°43′N, 51°20′E, 1200 m above sea level). More than 1.1×106 extensive air shower events were recorded. In addition to the Compton-Getting effect due to the motion of the Earth in the Galaxy, an anisotropy has been observed which is due to a unidirectional anisotropy of cosmic ray flow along the Galactic arms. © 2007 The American Physical Society  

In vivo dose-dependent effects of nanoscale graphene oxide (NGO) sheets on reproduction capability of Balb/C mice were investigated. Biodistribution study of the NGO sheets (intravenously injected into male mice at dose of ∼2000 μg/mL or 4 mg/kg of body weight) showed a high graphene uptake in testis. Hence, in vivo effects of the NGO sheets on important characteristics of spermatozoa (including their viability, morphology, kinetics, DNA damage and chromosomal aberration) were evaluated. Significant in vivo effects was found at the injected concentrations ≥200 μg/mL after (e.g., ∼45% reduction in sperm viability and motility at 2000 μg/mL). Observation of remarkable DNA fragmentations and... 

Asian red ginseng was used for green reduction of chemically exfoliated graphene oxide (GO) into reduced graphene oxide (rGO). The reduction level and electrical conductivity of the ginseng-rGO sheets were comparable to those of hydrazine-rGO ones. Reduction by ginseng resulted in repairing the sp 2 graphitic structure of the rGO, while hydrazine-rGO showed more defects and/or smaller aromatic domains. The ginseng-rGO sheets presented a better stability against aggregation than the hydrazine-rGO ones in an aqueous suspension. Whilst the hydrophobic hydrazine-rGO films exhibited no toxicity against human neural stem cells (hNSCs), the hydrophilic GO and ginseng-rGO films (as more... 

Vigorous debates have taken place within and between many countries about regulatory policy regimes covering the assessment and approval of genetically modified (GM) crops. In Iran, a very vigorous and hotly contested policy debate concerning legislation covering GM crops occurred between 2004 and 2009, but it was confined within government circles with almost no public discussion. This paper analyses the Iranian policy-making process in the period 2006-9. It explains how and why a stalemate arose in disputes between ministries and departments. The chosen analytical framework draws mainly on the regulation of technological risks and the analysis of public policy-making. It deploys the... 

A μ-way latin trade of volume s is a set of μ partial latin rectangles (of inconsequential size) containing exactly the same s filled cells, such that if cell (i, j) is filled, it contains a different entry in each of the μ partial latin rectangles, and such that row i in each of the μ partial latin rectangles contains, set-wise, the same symbols and column j, likewise. In this paper we show that all μ-way latin trades with sufficiently large volumes exist, and state some theorems on the non-existence of μ-way latin trades of certain volumes. We also find the set of possible volumes (that is, the volume spectrum) of μ-way latin trades for μ = 4 and 5. (The case μ = 2 was dealt with by Fu,... 

The set of integers k for which there exist three latin squares of order n having precisely k cells identical, with their remaining n2 -k cells different in all three latin squares, denoted by I3[n], is determined here for all orders n. In particular, it is shown that I3[n] = {0,.,n2 -15}U [n2 - 12,n2-9,n2], for n ≫8. ©2002 Eisevier Science B.V. All rights reserved  

Coronary angiography is a vital instrument to detect the prevailing of vascular diseases, and accurate vascular segmentation acts a crucial role for proper quantitative analysis of the vascular tree morphological features. Level set methods are popular for segmenting the coronary arteries, but their performance is related to suitable start-up and optimum setting of regulating parameters, essentially done manually. This research presents a novel fuzzy level set procedure with the objective of segmentation of the coronary artery tree in 2-D X-ray angiography as automatically. It is clever to clearly develop from the early segmentation with spatial fuzzy grouping. The adjusting parameters of... 

Visual attributes are great means of describing images or scenes, in a way both humans and computers understand. In order to establish a correspondence between images and to be able to compare the strength of each property between images, relative attributes were introduced. However, since their introduction, hand-crafted and engineered features were used to learn increasingly complex models for the problem of relative attributes. This limits the applicability of those methods for more realistic cases. We introduce a deep neural network architecture for the task of relative attribute prediction. A convolutional neural network (ConvNet) is adopted to learn the features by including an... 

We present the first public code for the calculation of the astrometric centroid shift occurring during microlensing events. The computation is based on the contour integration scheme and covers single and binary lensing of finite sources with arbitrary limb darkening profiles. This allows for general detailed investigations of the impact of finite source size in astrometric binary microlensing. The new code is embedded in version 3.0 of vbbinarylensing, which offers a powerful computational tool for extensive studies of microlensing data from current surveys and future space missions. © 2021 The Author(s) Published by Oxford University Press on behalf of Royal Astronomical Society  

The possibility of real-time tuning of optical devices has attracted a lot of interest over the last decade. At the same time, coming up with simple lithography-free structures has always been a challenge in the design of large-area compatible devices. In this work, we present the concept and the sample design of an electrically tunable, lithography-free, ultra-thin transmission-mode color filter, the spectrum of which continuously covers the whole visible region. A simple Metal-Insulator-Metal (MIM) cavity configuration is used. It is shown that using the electro-optic dielectric material of 4-dimethyl-amino-N-methyl-4-stilbazoliumtosylate (DAST) as the dielectric layer in this... 

Magnetic flux leakage is the most widely used method for oil and gas pipeline non destructive testing. The saturation level of the sample under test has a significant effect on its efficiency; therefore, the magnetizing yoke requires an elaborate design. The finite element method is the conventional approach used for this purpose, but it is very time consuming. In this article, a neuro-fuzzy method is presented to model the behavior of the magnetizing yoke. Modeling a few different designs with the finite element method and using the results for training the neuro-fuzzy model eradicates the necessity of modeling a huge number of designs with the finite element method. The acquired... 

The problem of finding necessary and sufficient conditions to decompose a complete tripartite graph K(r, s, t) into 5-cycles was first considered by Mahmoodian and Mirzakhani (1995). They stated some necessary conditions and conjectured that these conditions are also sufficient. Since then, many cases of the problem have been solved by various authors; however the case when the partite sets r ≤ s ≤ t have odd and distinct sizes remains open. A necessary condition is t ≤ 3r. Billington and Cavenagh (2011) have shown that when r, s, and t are all odd and r ≤ s ≤ t ≤ κr, where κ ≈ 1.0806, then the conjectured necessary conditions for decomposing are also sufficient. We extend this result...