Sharif Digital Repository

The effect of Solid State Fermentation (SSF) on Chitosan production by A. niger was investigated. A. niger BBRC 20004 from Biochemical and Bioenvironmental Research Centre of Sharif University of Technology (Tehran, Iran), was grown on corn residue. Chitosan was extracted from the fungal mycelia using hot alkaline and acid treatment. A. niger was incubated for 12 days on corn residue with moisture content of 35 % and 1.12 % of nitrogen. The Chitosan was obtained and 10.9 g/kg of Urea dry residue was added in various amounts to the medium in order to evaluate the effect of the nitrogen concentration in the production of Chitosan. The highest amount of Chitosan obtained by 6.5 g of urea after... 

The effect of glucose concentration in submerged fermentation (SMF) on chitosan production by Aspergillus niger was investigated. A. niger, BBRC, 20004, from the Biochemical and Bioenvironmental Research Centre at Sharif University of Technology, Tehran, Iran, was grown in a Sabouro Dextrose media. Chitosan was extracted from the fungal mycelia using hot alkaline and acid treatment and after 12 days of cultivation, 0.8455 g chitosan /l of the fermentation medium was obtained. The content of glucose in the Sobouro Dextrose Broth media was also changed and the highest yield of chitosan 0.9121 g/l was obtained in Sobouro Dextrose Broth media containing 8% glucose. © Sharif University of... 

In this research, low density polyethylene (LDPE) and poly ethylene-co-vinyl acetate (EVA) were used as polymeric materials. The methods used to produce LDPE and EVA was Film Blowing and ThermalDry Phase Inversion. The amount of permeability, diffusivity and solubility of O2 and CO2 through above polymers were obtained and also the effect of temperature, pressure and film thickness for LDPE was measured. The Barometric method was considered and measurements were based on ASTM standard. To study film cross-section morphology in EVA, Scanning Electron Microscopy (SEM) was applied. From results we considered that the amount of permeability and solubility were decreased by increasing film... 

In this paper we report experimental results for the performance and rate of heat transfer in copper tubes in solar water heaters with thermosyphonic flow in continuation of experimental data reported in previous publications (Solar Energy, 2003, vol. 74, pp. 441-445, and Energy Sources, 1997, vol. 19, pp. 147-152). We also show a comparison between performances of three kinds of tubes: copper, polypropylene and steel under similar conditions. An analytical relation for calculation of rate of heat transfer in copper tubes is also presented in terms of Nusselt versus Reynolds and Prantdl numbers. A comparison of experimental data showed that performance of copper tubes is slightly better than... 

In this research, low density polyethylene (LDPE) and poly(ethylene-co-vinyl acetate) (EVA) were used as polymeric materials. The methods used to produce LDPE and EVA was film blowing and thermal-dry phase inversion. The amount of permeability, diffusivity and solubility of O2 and CO2 through above polymers were obtained and also the effect of temperature, pressure and film thickness for LDPE was measured. To study film cross-section morphology in EVA, scanning electron microscopy (SEM) was applied. The results showed that the amount of permeability and solubility were decreased by increasing film thickness but diffusivity was increased. However, by increasing temperature, permeability,...