Sharif Digital Repository

A semi-analytical method is developed for the analysis of deformation and three-dimensional stress field in rotating annular disks made of cylindrically orthotropic nested rings. The method is based on a layerwise theory and the Hamilton principle. The proposed method is applied to calculate in-plane and out-of-plane stresses in a rotating disk made up of two nested rings that is rigidly fixed (or free) at the inner boundary and is free at the outer boundary. The computed results are compared with those obtained from the finite element method. It is found that because of discontinuity of material properties, the stress field is three-dimensional at the interface of two rings. © 2004 Elsevier... 

Interlaminar stresses resulting from bending of rectangular cross-ply composite laminates are determined using a layer wise laminate theory. Two types of laminates are considered. First a fully simply supported laminate subjected to bi-directional bending is analyzed. The results obtained from this theory are compared with those of the published three-dimensional elasticity solutions to verify the validity and accuracy of the present theory. Then laminates with two edges simply supported and the other two edges free are examined. The results indicate the presence of significant interlaminar stresses near the free edges. © 2003 Elsevier Ltd. All rights reserved  

An elasticity formulation for finite general cross-ply (symmetric and unsymmetric) laminates subjected to extension and/or a layerwise temperature distribution is developed. It is shown that the edge-effect problem of such laminates is actually a quasi-threedimensional problem and its stress analysis can be restricted to a generic two-dimensional cross-section of the laminates. A layerwise theory is used to investigate analytically the interlaminar stresses near the free edges of general cross-ply composite laminates. The results obtained from this theory are compared with those available in the literature. It is found that the theory can predict very accurately the stresses in the interior... 

A layerwise theory is used to investigate analytically the interlaminar stresses near the free edges of general cross-ply composite laminates under uniform axial extension. Laminates with finite dimensions are considered and full three-dimensional stresses in the interior and the boundary-layer regions are calculated. The results obtained from this theory are compared with those available in the literature. It is found that the edge-effect problem of general cross-ply laminates is actually a quasi three-dimensional problem and its stress analysis can be restricted to a generic two-dimensional cross-section of the laminates. © 2003 Elsevier Science Ltd. All rights reserved  

Reddy's layerwise theory is used to investigate analytically the interlaminar stresses near the free edges of general (unsymmetric and symmetric) cross-ply composite laminates with various boundary conditions subjected to mechanical and hygrothermal loadings. Laminates with finite dimensions are considered and full three-dimensional stresses in the interior and the boundary-layer regions are calculated. The results obtained from this theory are compared with those available in the literature. It is found that the theory can predict very accurately the stresses in the interior region and near the free edges of both finite and long laminates  

Material discontinuity could cause in-plane stress gradients that it arises interlaminar stresses in regions of sudden transition of material properties. A layerwise laminated beam theory that is a modification of a layerwise laminated plate theory is developed and it is used to analyze analytically the interlaminar stresses at material discontinuities in rotating composite beams. Equations of motion are obtained by using Hamilton's principle. It is assumed that the beam is divided into two regions with different layups which are joined together. The predicted interlaminar stress distributions at the ply interfaces are shown to be in good agreement with comparative three-dimensional finite... 

Online media play an important role in information societies by providing a convenient infrastructure for different processes. Information diffusion that is a fundamental process taking place on social and information networks has been investigated in many studies. Research on information diffusion in these networks faces two main challenges: (1) In most cases, diffusion takes place on an underlying network, which is latent and its structure is unknown. (2) This latent network is not fixed and changes over time. In this article, we investigate the diffusion network extraction (DNE) problem when the underlying network is dynamic and latent. We model the diffusion behavior (existence... 

This paper deals with analytical thermomechanical stress analysis of adhesively bonded composite joints in presence of a structural imperfection in the form of an interfacial void within the adhesive layer based on the full layerwise theory (FLWT). The joints are subjected to mechanical tension, uniform temperature change, or steady-state heat conduction. The proposed adhesive joint is divided into three distinct regions along its length and a large number of mathematical plies through its thickness. Three sets of fully coupled governing equilibrium equations are derived employing the principle of minimum total potential energy. The three-dimensional nonlinear interlaminar stress... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared