Sharif Digital Repository

Knowledge of Air-water two phase flows is significant to different engineering systems such as chemical reactors and power plant and petrochemical and petroleum industry. One of the most industrial cases of two phase flow is two phase flow in vertical large pipes. In this paper in order to find two phase flow behavior along vertical large diameter pipes we simulate air inlets with different number of holes and different hole diameters in the same flow rate of air. In addition, flow characteristics such as cross-sectional void fraction and velocity and pressure were considered. To achieve this aim, main equations of flow have been developed for investigation of flow behavior in air-water two... 

Identification of different flow regimes in industrial systems operating under two-phase flow conditions is necessary in order to safely design and optimize their performance. In the present work, experiments on two-phase flow have been performed in a large scale test facility with the length of 6 m and diameter of 5 cm. Four main flow regimes have been observed in vertical air-water two-phase flow at moderate superficial velocities of gas and water namely: Bubbly, Slug, Churn, and Annular. An image processing technique was used to extract information from each picture. This information includes the number of bubbles or objects, area, perimeter, as well as the height and width of objects... 

Simplicity of manufacturing and high reliability of airlift pumps have promoted these pumps to be used in different industries, such as petrochemical and oil industries, especially in oil recovery from dead wells. One of the main parameters affecting the performance of these pumps is two-phase flow regime in the main pipe of the pump. In this research, experimental data are utilized to investigate the influence of the flow regimes on the performance of an airlift pump. The data are obtained for air-water two-phase flow in a vertical pipe with a diameter of d = 50. mm and an aspect ratio of L/d = 120. In this study, the gas liquid upward two-phase flow regime in the upriser pipe is... 

Air-water two-phase flow usually occurs during a sudden rise in water level at a tunnel or during the falling of the water level at an upstream reservoir while entering the conduit. When this happens, different flow patterns are generated, due to the hydraulics of flow and fluid properties. An analytical/numerical model, based on the assumption of a rigid incompressible water column and a compressible air bubble, is derived, to simulate pressure fluctuation, void fraction, air/water flow rate and water velocity in a closed conduit, including water depth at the upper reservoir, due to air bubbles becoming trapped in the water, for the highest possible number of flow patterns. It is a...