Sharif Digital Repository

The authors have synthesized a superhydrophobic silica aerogel by using a sol-gel technique. The material is shown to be an efficient sorbent for needle trap microextraction of chlorobenzenes. Hydrophobicity affects the performance of the sorbent as shown by altering the ratio between tetraethylorthosilicate (TEOS) and methyltrimethoxysilane when synthesizing the sorbent. The observed contact angle (which is >150°) underpins the superhydrophobic properties of the aerogel. The microstructure of the sorbent was investigated by BET adsorption, revealing a surface area above 1000 m2 g−1. The sorbent was applied to needle trap extraction of chlorobenzenes from aqueous samples, and their... 

A series of experiments were carried out to study the unsteady wake phenomenon behind an oscillating airfoil. The airfoil is a section of a wind turbine blade oscillating in pitch about the quarter chord axis at various reduced frequencies, oscillation amplitude and mean angles of attack. Streamwise velocity profiles were obtained by real time and instantaneous measurements at 35 vertically aligned points behind the airfoil via two similar rakes. One of rakes has only static pressure probes and the other is equipped with total pressure ones. An estimation of the variation of linear momentum defect during the oscillation is obtained and has been compared with the corresponding static one. The... 

An extensive experimental study is conducted to investigate the effects of reduced frequency on a harmonically pitching wing where its cross section is used in a 660 kW wind turbine under construction in Iran. The corresponding lift coefficient and real time pressure signatures at three sections of the model at various reduced frequencies are examined. The test covers a wide range of angles of attack at prestall, stall, and deep stall regions. Pressure distributions at tip, middle, and root sections of the wing were recorded and from these distributions the lift coefficients are computed. The results show great role of the reduced frequency in altering the maximum lift coefficients, lift... 

In this paper, a novel six degrees-of-freedom (6-DOF) parallel manipulator actuated by three base-mounted partial spherical actuators is proposed. The parallel manipulator consists of a base, a moving platform and three connecting legs. Each leg has spherical (S), prismatic (P) and universal (U) joints (SPU) in serial manner. The spherical joints are partially actuated due to the fact that the actuators of each leg are used only to specify its leg's direction. The inverse and forward pose kinematics as well as the singularity points of the aforementioned mechanism is described in the article. In the inverse pose kinematics, active joint variables could be calculated with no need for the... 

Recently, super gas wet and gas wet surfaces have been extensively attended in petroleum industry, as supported by the increasing number of publications in the last decade related to wettability alteration in gas condensate reservoirs. In many cases, contact angle measurement has been employed to assess the wettability alteration. Even though contact angle measurement seems to be a straightforward approach, there exist many misuses of this technique and consequently misinterpretation of the corresponding results. In this regard, a critical inspection of the most recent updated concepts and the intervening parameters in the contact angle based wettability evaluation of liquid-solid-gas... 

The biodegradation behavior of Mg, coated by polymethyl methacrylate as well as polymethyl methacrylate (PMMA)−bioactive glass (BG) composite was investigated. Electrophoretic deposition and dip coating techniques were adopted to prepare composite coating using a suspension of different percentages of the above two chemical materials. The deposited coatings were characterized using SEM, EDS, FTIR, and water contact angle measurements. Biodegradation behavior study of the coated Mg was performed using linear polarization, impedance spectroscopy, and immersion tests in simulated body fluid. The compact and homogeneous composite coating was developed as evidenced by electron microscopy results.... 

Vertically aligned ZnO@CdS nanorod heterostructure films with various loadings of CdS nanoparticle shell were synthesized and applied in photoinactivation of Escherichia coli bacteria under visible light irradiation. While neither the bare ZnO nanorods (with band-gap energy (Eg) of ∼3.28 eV) under visible light irradiation nor the nanorod heterostructures in dark exhibited any significant antibacterial activity, the ZnO@CdS nanorod heterostructures (with Eg ∼2.5-2.6 eV) could successfully inactivate the bacteria under visible light irradiation. Furthermore, it was found that an optimum loading of the CdS shell (corresponding to the effective thickness less than ∼15 nm) is required to achieve... 

In this study, four types of mixed matrix membranes were fabricated using polysulfone (as the base polymer) and different contents of graphene oxide (GO) nanosheets (as modifier) through wet phase inversion method. Based on the amounts of GO (0, 0.5, 1, and 2 wt%), the synthesized membranes named as M1, M2, M3, and M4, respectively. The membranes characteristics were evaluated using FE-SEM, FT-IR, and water contact angle measurements. In addition, the performance of the prepared membranes was investigated in terms of basic parameters: filtrate water flux, nitrate removal efficiency, and antifouling properties. Results showed significant improvements of the characteristics of modified... 

In this study, four types of mixed matrix membranes were fabricated using polysulfone (as the base polymer) and different contents of graphene oxide (GO) nanosheets (as modifier) through wet phase inversion method. Based on the amounts of GO (0, 0.5, 1, and 2 wt%), the synthesized membranes named as M1, M2, M3, and M4, respectively. The membranes characteristics were evaluated using FE-SEM, FT-IR, and water contact angle measurements. In addition, the performance of the prepared membranes was investigated in terms of basic parameters: filtrate water flux, nitrate removal efficiency, and antifouling properties. Results showed significant improvements of the characteristics of modified... 

Peripheral nerve injuries remain among the most challenging medical issues despite numerous efforts to devise methods in fabrication of nerve conduits to functionally regenerate axonal defects. In this regard, the current study offers a holistic perspective in design by considering the mechanical, topographical and structural aspects which are crucial for a successful nerve guide conduit. Poly(e-caprolactone) and gelatin were employed to serve this purpose in the form of dual-electrospun films which were rolled and later shaped the assembly of a multichannel conduit. Polyaniline/graphene (PAG) nanocomposite was incorporated to endow the conduit with conductive properties. FTIR analysis,... 

This paper describes a feasibility study of using numerical analysis technique, coupled with a non-linear simulation model of a conceptual fluidic-thrust-vectored unmanned aerial tailsitter to obtain required thrust deflection angles for a transition manoeuvre in take-off. It also studies the aircraft behaviour in transition subjected to the changes in specified parameters like the thrust value and the engine distance from the centre of gravity. The focus of the research presented was to get the vehicle from zero speed on the ground, in vertical position, to a specified velocity at a specified attitude, in cruise position. It was also specified that, when the vehicle was considered to be... 

TixSi1-xO2 compound thin-film systems were deposited by reactive RF magnetron co-sputtering technique. The effect of Ti concentration on the hydrophilicity of TixSi1-xO2 compound thin films was studied and it was shown that the films with Ti0.6Si0.4O2 composition possess the best hydrophilic property among all the grown samples. Surface ratio and average roughness of the thin films were measured by atomic force microscopy (AFM). Surface chemical states and stoichiometry of the films were determined by X-ray photoelectron spectroscopy (XPS). In addition, XPS revealed that the amount of Ti-O-Si bonds in nanometer depth from the surface of the Ti0.6Si0.4O2 films was the maximum, which resulted... 

Nd:YAG laser treatment was used in order to increase surface cell adhesion aspects of polycarbonate (PC) films prepared via melt process. The treatment was carried out under different wavelengths and beam diameters. ATR-FTIR and UV spectra obtained from different samples before and after laser treatment in air showed that laser irradiation has induced some chemical and physical changes in surface properties. The irradiated films were also characterized using scanning electron microscopy (SEM) and contact angle measurements. Effect of pulse numbers on the surface properties was also investigated. Cell culture test was used to evaluate cell adhesion property on the PC films before and after... 

Anatase and amorphous TiO2 nanoparticles were used to improve recovery of heavy oil from sandstone cores. Before performing core floods, the stability of nanoparticles at different salinities was tested using ζ potential and ultraviolet-visible (UV-vis) methods. While water recovered only 49% of the oil in the core flood experiments, 0.01% anatase structure solution recovered 80% of the oil after injecting two pore volumes at optimum conditions. To understand the mechanism responsible for improved recovery, contact angle measurements were performed on the rock surface before and after treatment with the nanoparticle solution. Contact angle measurements showed that the rock wettability... 

The effects of the polarized incident laser pulse on the electrons of the plasma surface and on the reflected pulse in the relativistic laser-plasma interaction is investigated. Based on the relativistic oscillating mirror and totally reflecting oscillating mirror (TROM) regimes, the interaction of the intense polarized laser pulses with over-dense plasma is considered. Based on the effect of ponderomotive force on the characteristic of generated electron nano-bunches, considerable increasing in the localization and charges of nano-bunches are realized. It is found that the circularly polarized laser pulse have N e/N cr of 1500 which is almost two and seven times more than the amounts for... 

In this research, an attempt was made to improve TiO2 photo-catalyst properties, thus pure, N-Ce co-doped TiO2 thin films were prepared on glass-ceramic substrate using a sol-gel dip-coating technique. The samples were calcinated in air at 475 °C, 550°C, and 650°C for 2 h. The result of simultaneous thermal analysis (STA) and X-ray diffraction (XRD) showed that the presence of Ce in TiO2 could inhibit the phase transformation from anatase to rutile and enhance the thermal stability, and anatase was the dominant phase in N-Ce co-doped TiO2 samples. Also based on the results, the doping results in decreasing the size of TiO 2 crystallite. The results of ultra violet-visible light diffuse... 

In this research, we have used glancing angle deposition (GLAD) RF sputtering technique with various angular speeds ranging from 5 to 30 RPM to fabricate polytetrafluoroethylene (PTFE, Teflon) coated Tungsten on glass substrate for producing hydrophobic surface. According to scanning electron microscopy (SEM) observations, Tungsten nanorods were formed on the substrate with average diameter and length of about ∼50 nm and 300 nm, respectively. Hydrophobic property of W/Glass and PTFE/W/Glass systems was investigated by water contact angle measurements and we have found that the contact angle varied with the substrate angular speed. Maximum contact angle of 121 was measured for the... 

In this study, TiO 2-SiO 2 nanocomposite films with different amounts of SiO 2 were prepared by sol-gel process and were coated onto stainless steel 316L. The effect of addition of various amount of SiO 2 in the precursor solution on the photocatalysis, photo-generated hydrophilicity and self-cleaning property of TiO 2 thin films was investigated by X-ray diffraction, Fourier transform infrared spectroscopy, water contact angle measurements and UV spectroscopy. In the tested ranges of SiO 2 content and sintering temperature, the highest photocatalytic activity and self-cleaning property were observed in the 15 mol% SiO 2 sample sintered at 750 °C. Addition of less than 30 mol% SiO 2 had a... 

Low-frequency O 2 plasma was used to modify the surface of polysulfone gas-separation membranes. The effects of the treatment time and plasma power input on the membranes were also investigated. Pure CO 2 and CH 4 gas-permeation measurements were performed before and after plasma treatment. The results show the increase of permeability of the treated membranes due to surface ablation and surface polarization up to 5.63 and 68.80 gas-permeation units for CH 4 and CO 2, respectively, whereas, the CO 2/CH 4 selectivity of the treated membranes varied from 7.7 to 45.3, depending on the treatment conditions. Attenuated total reflection-Fourier transform infrared spectroscopy determined the...