Sharif Digital Repository

In this study, the effect of mixotrophic, heterotrophic, photoautotrophic (CO2 of air source), and photoautotrophic (bicarbonate source) cultivation of Chlorella vulgaris was investigated on microalgae growth rate and nutrient removal under different kinds of nitrogen sources. The highest N–NH3 +, N–NO3 −, P–PO4 3− (in ammonium source), and P–PO4 3− (in nitrate source) removal efficiency (87.28 ± 0.89, 70.00 ± 1.20, 87.00 ± 3.10, and 78.10 ± 1.95%, respectively) was reached in the mixotrophic culture. In all cultivations, when nitrate was used as the nitrogen source, specific growth rate, biomass productivity, and specific oxygen production rate (SOPR) were higher than the one with ammonium... 

In the present study, two novel annular photobioreactors (PBR) were developed to enhance microalgae growth. One of these photobioreactors used mirrors outside the PBR, while the other one utilized phosphorescence materials inside the PBR. The results of the study suggested that the use of mirrors and phosphorescence materials led to 70% and 30% increase, respectively, in the light intensity without any additional energy consumption. Further, the results revealed that when compared with the base case, the biomass concentration increased by 91% and 24% in PBR with mirrors and phosphorescence materials, respectively. In conclusion, an improvement in PBRs resulted in efficient light to biomass... 

Chlorella vulgaris was cultivated in a hybrid (two-stage) system. The effect of the transferring time from nutrient-replete phase with a low light intensity (photobioreactor) to the nutrient deprivation phase (open pond) with a higher light intensity, as well as the effect of initial cell concentration in the deprivation phase, on the growth rate and lipid content of the microalgae was investigated. The microalgae were transferred to the nutrient deprived medium at different intervals with various initial cell concentrations. Transferring the cultivated medium of the 4th day with the initial cell concentration of 66 mg L−1 into the deprivation phase resulted in a highest lipid productivity... 

Analysis of microparticle size and fluorescence intensity can be used to classify microparticles. We designed and fabricated an optofluidic system that characterizes microparticles, including fluorescent microparticles and microalgae. A new type of multi-pixel photon counter (MPPC) was employed to miniaturize the device, lower its power consumption, and make it insensitive to magnetic fields. The system uses a 635 nm laser for excitation of the microparticles' fluorescence. The scattered light from the fluorescent microparticles, as well as Chlorella vulgaris and Chlorella protothecoides, were measured. Additionally, we analyzed the width and height of the measured signals generated as a... 

Microalgae's biomass productivity and oil content depend heavily on the method of its cultivation. In this study, nutrient removal from municipal wastewater by Chlorella vulgaris in batch culture was investigated. Carbon dioxide was supplied from sodium hydrogen carbonate. Effect of parameters including light intensity, sodium hydrogen carbonate concentration, and daily illumination time on the productivity of biomass and lipid was investigated. Lipid and biomass production of C.vulgaris increased at higher concentration of sodium hydrogen carbonate concentration and higher light intensity until a certain value and then decreased, but longer daily illumination time, increased both biomass... 

In this research, organic solvent composed of hexane and methanol was used for lipid extraction from dry and wet biomass of Chlorella vulgaris. The results indicated that lipid and fatty acid extraction yield was decreased by increasing the moisture content of biomass. However, the maximum extraction efficiency was attained by applying equivolume mixture of hexane and methanol for both dry and wet biomass. Thermodynamic modeling was employed to estimate the effect of hexane/methanol ratio and moisture content on fatty acid extraction yield. Hansen solubility parameter was used in adjusting the interaction parameters of the model, which led to decrease the number of tuning parameters from 6... 

Recently, microalgae has received a high attention for application in bioelectrochemical systems due to its potential to be used for oxygen generation and biodiesel production. In this study performance of algal biocathode in a microbial desalination cell (MDC) was evaluated against air cathode and biocathode microbial fuel cell (MFC). Effluent of a dairy wastewater treatment plant with COD of 1000 mg l-1 was utilized as substrate in the anode and the microalgae Chlorella vulgaris was inoculated in the cathode using a synthetic culture media. Experiments were conducted using two different saline water concentrations including 15 g l-1 (MDC-1) and 35 g l-1 (MDC-2) in a desalination cell and... 

In this study, four types of tetrabutylphosphonium carboxylate ionic liquids (ILs) were synthesized and used for a one-pot transesterification of wet Chlorella vulgaris (C. vulgaris) microalgae into fatty acid methyl esters (FAME) in the presence of methanol, as well as refined oils (sunflower, canola, and corn oil). The resulting process removed the need for complete drying and lipid extraction steps typically needed for biodiesel production from microalgae. The leading candidate ionic liquid catalyst, tetrabutylphosphonium formate ([P4444][For]), was further optimized using response surface methodology to minimize material consumption, increase water compatibility, reduce processing time... 

Here in this study, successful conversion of visible light into electricity has been achieved through utilizing microalgal pigments as a sensitizer of nanostructured photo-electrode of dye-sensitized solar cells (DSSCs). For the first time, photosynthetic pigments extracted from microalgae grown in wastewater is employed to imitate photosynthesis process in bio-molecule-sensitized solar cells. Two designs of photoanode were employed: 10μm nanoparticular TiO2 electrode and 20μm long self-ordered, vertically oriented nanotube arrays of titanium dioxide films. Microalgal photosynthetic pigments are loaded on nanostructured electrodes and their photovoltaic performances have been investigated.... 

In this research, a two-stage process consisting of cultivation in nutrient rich and nitrogen starvation conditions was employed to enhance lipid production in Chlorella vulgaris algal biomass. The effect of supplying different organic and inorganic carbon sources on cultivation behavior was investigated. During nutrient sufficient condition (stage I), the highest biomass productivity of 0.158. ±. 0.011. g/L/d was achieved by using sodium bicarbonate followed by 0.130. ±. 0.013, 0.111. ±. 0.005 and 0.098. ±. 0.003. g/L/d for sodium acetate, carbon dioxide and molasses, respectively. Cultivation under nitrogen starvation process (stage II) indicated that the lipid and fatty acid content... 

In this article, indium doped ZnO nanoparticles (alloy nanoparticles) were investigated as inhibitors against algae growth on adobe mud and earthen artworks for surface preservation from destruction caused by micro-organisms under humid conditions, through surface modification and activation run off. Nanoparticles (NPs) were fabricated by physical vapor deposition (PVD) growth mechanism. The fabricated NPs were approximately 20 nm in size. The Chlorella vulgaris and Scenedesmus quadricauda were tested by application of indium doped ZnO nanoparticles (In/ZnO NPs) as inhibitors. As concentrations of NPs increased, the negative impacts of NPs on the algal growth were enhanced and physical... 

This study develops a photosynthetic microalgae microbial fuel cell (PMMFC) engaged Chlorella vulgaris microalgae to investigate effect of light intensities and illumination regimes on simultaneous production of bioelectricity, biomass and wastewater treatment. The performance of the system under different light intensity (3500, 5000, 7000 and 10,000 lx) and light/dark regimes (24/00, 12/12, 16/8 h) was investigated. The optimum light intensity and light/dark regimes for achieving maximum yield of PMMFC were obtained. The maximum power density of 126 mW m−3, the coulombic efficiency of 78% and COD removal of 5.47% were achieved. The maximum biomass concentration of 4 g l−1 (or biomass yield...