Sharif Digital Repository

Liquid-liquid-liquid microextraction (LLLME) in combination with HPLC and UV detection has been used as a sensitive method for the determination of ephedrine in urine samples. Extraction process was performed in a homemade total glass vial without using a Teflon ring, usually employed. Ephedrine was first extracted from 3.5 mL of urine sample (pH 12) into a microfilm of toluene/benzene (50:50). The analyte was subsequently back extracted into an acidic microdrop solution (pH 2) suspended in the organic phase. The extract was then injected into the HPLC system directly. An enrichment factor of 137 along with a good sample clean-up was obtained under the optimized conditions. The calibration... 

A crude phenolic glycolipid extract from Mycobacterium bovis BCG was fractionated by column chromatography. A reversed-phase high performance liquid chromatography (HPLC) method with UV detection at 275nm was developed for simultaneous detection and separation of phenolic glycolipids (PGLs) in Mycobacterium bovis BCG. This analysis provides a good resolution. Different solvent systems and columns for HPLC were compared. A system composed of acetonitrile-water in the ratio of 0→80% at a flow rate of 0.8 mL/min and C8 analytical column were found to be optimum for HPLC of the phenolic glycolipids. This simple method is therefore appropriate to purify these compounds present in M. bovis extract... 

In salting-out liquid-liquid extraction (SALLE) technique, water-miscible organic solvents are used for extraction of polar analytes from saline solutions. In this study, for the first time, a coupled 1-mL syringes system was utilized to perform a miniaturized SALLE method. Sulfanilamide antibiotic was extracted and determined via the developed method followed by high performance liquid chromatography-ultraviolet detection (HPLC-UV). The extraction process was carried out by rapid shooting of acetonitrile as extraction solvent (syringe B) into saline aqueous sample solution (syringe A), and then the shooting was repeated several times at a rate of 1 cycle s-1. Thereby, an extremely large... 

Bio-inspired Human Serum Albumin (HSA) imprinted polydopamine nano-layer was produced through oxidative polymerization of dopamine on the pore surface of HSA modified porous silica particles. The coating thickness was controlled by the reaction time and thereby varied within 0-12. nm. The samples were characterized by elemental analysis, FT-IR, DSC, SEM, TEM, TGA, physisorption and thermoporometry. The characterization confirmed the success of evolution and deposition of polydopamine layer on the silica pore surface. Batch rebinding experiment showed that the molecularly imprinted polymer (MIP) with 8.7. nm coating thickness, in comparison with the thinner and thicker coatings, displays the... 

A new dibenzothiophene (DBT) desulfurizing bacterium was isolated from oil-contaminated soils in Iran. HPLC analysis and PCR-based detection of the presence of the DBT desulfurization genes (dszA, dszB and dszC) indicate that this strain converts DBT to 2-hydroxybiphenyl (2-HBP) via the 4S pathway. The strain, identified as Rhodococcus erythropolis SHT87, can utilize DBT, dibenzothiophene sulfone, thiophene, 2-methylthiophene and dimethylsulfoxide as a sole sulfur source for growth at 30 °C. The maximum specific desulfurization activity of strain SHT87 resting cells in aqueous and biphasic organic-aqueous systems at 30 °C was determined to be 0.36 and 0.47 μmol 2-HBP min-1 (g dry cell)-1,... 

An imprinted interpenetrating polymer network (IPN) was synthesized and used as a medium for isolation of carbamazepine from urine samples. The polymer network consisted of a homogeneous polystyrene–sol gel hybrid constructed by in–situ radical polymerization method. In this process, within the sol–gel reaction duration, styrene monomer could penetrate into the reaction mixture and after the polymerization initiation, a monolithic IPN structure was prepared. The scanning electron microscopy (SEM) image and energy dispersive spectroscopy (EDX) are indications of the polystyrene dispersion at nano- to micro-meter level in the sol gel matrix. Eventually, the synthesized IPN was used as a... 

A modified solvent microextraction with back extraction method (SME/BE) combined with high performance liquid chromatography and fluorescence detection (HPLC-FD) was developed for the determination of citalopram in human plasma. Extraction process was performed in a home-made total glass vial without using a teflon ring, usually employed in SME/BE. Citalopram was first extracted from 0.5 mL of plasma, modified with sodium hydroxide, into hexane. Back extraction step was then performed into 5.2 μL of 45 mM ammonium formate solution (pH 4) using a GC microsyringe. The extract was subsequently transferred into a liner-like vial and then injected into the HPLC system. An enrichment factor of 150... 

In the present work, with the focus on an environmentally–friendly approach, some gels were prepared by synthesizing amine–modified lignin, extracted from sugarcane bagasse, and further esterification and subsequent freeze–drying. These lignin–based gels were implemented as extractive phases in an online micro–solid phase extraction (μSPE) setup in conjunction with high performance liquid chromatography (HPLC) with UV detector. The developed method was used for analytical determination of valsartan and losartan in urine samples. To study the effect of the functionalization process, the efficiency of the unmodified lignin and the functionalized lignin were compared both in the absence and the... 

In this work a novel unbreakable sol-gel-based in-tube device for on-line solid phase microextraction (SPME) was developed. The inner surface of a copper tube, intended to be used as a high performance liquid chromatography (HPLC) loop, was electrodeposited by metallic Cu followed by the self assembled monolayers (SAM) of 3-(mercaptopropyl) trimethoxysilane (3MPTMOS). Then, poly (ethyleneglycol) (PEG) was chemically bonded to the -OH sites of the SAM already covering the inner surface of the copper loop using sol-gel technology. The homogeneity and the porous surface structure of the SAM and sol-gel coatings were examined using the scanning electron microscopy (SEM) and adsorption/desorption... 

A method based on direct immersion solid-phase microextraction (DI-SPME) coupled with high performance liquid chromatography combined with post-column photochemically induced fluorimetry derivatization and fluorescence detection (HPLC-PIF-FD) was developed to extract three pyrethroid insecticides, i.e. cyfluthrin, cypermethrin, and flumethrin from water samples. A sol-gel based coating fiber using 3-(trimethoxysilyl propyl) amine as precursor was prepared and used for the extraction of the pyrethroids from groundwater samples. A post-column photochemical reactor was designed and constructed for the derivatization of these environmentally important pollutants to increase their fluorescence... 

An electro membrane extraction (EME) methodology was utilized to study the isolation of some environmentally important pollutants, such as chlorophenols, from aquatic media based upon the electrokinetic migration process. The analytes were transported by application of an electrical potential difference over a supported liquid membrane (SLM). A driving force of 10 V was applied to extract the analytes through 1-octanol, used as the SLM, into a strongly alkaline solution. The alkaline acceptor solution was subsequently analyzed by high performance liquid chromatography-ultraviolet (HPLC-UV) detection. The parameters influencing electromigration, including volumes and pH of the donor and... 

Biomass, originates from plant- or animal-based materials with a huge potential to be reused. Here we report a simple, rapid and inexpensive method for preparation of modified biochars derived from the banana peel followed by their applications in pipette-tip micro solid-phase extraction (PT-µSPE). Due to the contribution of various effective parameters on modification of banana peel biochars (BPBs), Taguchi design was used to optimize activation temperature, activation repetition, treatment material and impregnation ratio. Efficiency of the prepared BPBs were studied by extraction of twelve various pesticides, as model analytes with an extended range of log P values (1.4–5.7), followed by...