Sharif Digital Repository

Adirect numerical simulation approach is used to investigate the effective non-linear viscoelastic stress response of non-gap-spanning magnetic chains suspended in a Newtonian fluid. The suspension is confined in a channel and the suspended clusters are formed under the influence of a constant external magnetic field. Large amplitude oscillatory shear (LAOS) tests are conducted to study the non-linear rheology of the system. The effect of inertia on the intensity of non-linearities is discussed for both magnetic and non-magnetic cases. By conducting magnetic sweep tests, the intensity and quality of the non-linear stress response are studied as a function of the strength of the external... 

Employing a proper pulse shaper in the conventional split Hopkinson pressure bar (SHPB) test helps to achieve dynamic equilibrium condition and to fulfill a constant strain rate condition in the test specimen. To this end, the parameters affecting the incident pulse shape, i.e., pulse shaper thickness, pulse shaper diameter, striker bar length and striker bar velocity are experimentally studied. Moreover, simulation results, validated by experimental data together with wave propagation analysis, are exploited to provide general guidelines to properly design a pulse shaper. It is recommended to use a relatively large diameter pulse shaper for testing work-hardening materials. Also, for... 

Dynamic behavior of concrete specimens is investigated experimentally and numerically by split Hopkinson pressure bar (SHPB) tests. In order to accurately determine dynamic properties of brittle materials such as concrete, specimens should be subjected to particular pulse loading that can be generated by using pulse shapers. Choosing proper pulse shaper dimensions helps to obtain dynamic stress equilibrium, achieve constant strain rate and minimize pulse oscillation in the concrete specimens. To this end, SHPB tests are performed for concrete specimens and effective parameters on shaping pulses such as striker bar velocity, diameter and thickness of the pulse shaper are studied... 

The dynamic and static softening phenomena in Al-6Mg alloy were studied through interrupted two-stage hot compression test performed isothermally at 480°C and strain rate range of 0.001-0.1 s-1. The interruptions of 29 and 90 s were considered when the true strain reached 0.5. It was concluded that the effect of static softening on the flow stress was not highlighted by extending the interruption at a constant strain rate. Also, it was exhibited that softening rate highly enhanced with the strain rate decrement at a constant time. Moreover, the static and dynamic recrystallization was revealed as the dominant softening mechanisms at low and high strain rates, respectively  

The influence of Cu addition on the hot deformation behavior of NiTi shape memory alloys was investigated using hot compression test. A series of alloys with different Cu contents of Ti50.4Ni49.6-xCux (x = 0, 3, 5, 7 at.%) were deformed under compression to a true strain of 0.7 at the temperature range of 700-1000 °C with 100 °C intervals and constant strain rate of 0.1 s-1. The stress-strain curves showed that the addition of Cu to NiTi alloy made the flow curves shift upward. This was confirmed by the calculated critical stress, σc, obtained from inflections in θ-σ plots, which is attributed to the formation of high strength Cu containing precipitates and solid solution hardening caused by...