Sharif Digital Repository

Dynamic modeling of a double-pipe heat exchanger is the subject of the current study. The basis of this study is the same velocity of vapor and liquid phases or, in other words, homogeneous phase, in the annulus part of the exchanger. The model can predict the temperature and vapor quality along the axial pipe from the pipe inlet up to a distance where steady state conditions are achieved. The simulation is conducted for two modes of co- and counter-flow in a one dimensional transient system. The physical properties of water are estimated from empirical correlation and a saturated vapor table with cubic spline interpolation. The exchanger model, which is a set of Ordinary Differential... 

In this research, a numerical investigation is done on the effect of employing the new combined vortex generators, the twisted tape turbulator and Al2O3-H2O nanofluid as the involved base fluid. Such study is carried out on the behavior of the heat transfer rate and the pressure drop of a double pipe heat exchanger. Accordingly, the response surface methodology (RSM) grounded on the central composite design (CCD) is used for acquiring the optimized geometry of the combined vortex generator and twisted tape turbulator. In order to have the maximum Nusselt number and minimum friction factor, twenty cases with different pitches ratio Pil=0.09-0.18, angles (θ=0-30°) and Reynolds numbers (Re =... 

The overall heat transfer coefficient (OHTC) of air in a double-pipe helical heat exchanger is studied and experimentally investigated. In order to increase the rate of heat transfer in the annulus section, a copper-wire fin is soldered on the outside area of the internal tube. The literature correlations’ results are presented against the experimental data by changing mass flow rate and temperature, and consequently changing the Reynolds number. Further, a new method is suggested to obtain the heat transfer coefficients of double-pipe helical heat exchangers for the internal tube and the annulus section by combining two of the previously proposed approaches and making subsequent...