Sharif Digital Repository

This paper proposes a novel formula to calculate sensitivities of electromechanical modes to generators active power changes. Quadratic eigenvalue problem is applied to construct the framework of the proposed formula. Sensitivity factors are calculated using power system model parameters and power flow variables, which can be either obtained via state estimation or measured directly by phasor measurement units. The 39-bus New England power system is used to verify performance of the proposed method  

This paper proposes a comprehensive analytic method for applying various optimal remedial actions to improve critical electromechanical modes damping without jeopardizing damping of non-critical modes and violating security constraints of power system. Generators and reactive power sources redisptach, demand side management and the generators voltage reference tuning are remedial actions that are considered here. Dynamic equations of the flux-decay dynamic model of generators, standard dynamic models of excitation system and power system stabilizer and algebraic equations of active and reactive powers balance are formulated in the quadratic eigenvalue problem framework. With simultaneous use... 

Various researchers have contributed to the identification of the mass and stiffness matrices of two dimensional (2-D) shear building structural models for a given set of vibratory frequencies. The suggested methods are based on the specific characteristics of the Jacobi matrices, i.e., symmetric, tri-diagonal and semi-positive definite matrices. However, in case of three dimensional (3-D) structural models, those methods are no longer applicable, since their stiffness matrices are not tri-diagonal. In this paper the inverse problem for a special class of vibratory structural systems, i.e., 3-D shear building models, is investigated. A practical algorithm is proposed for solving the inverse... 

Stability analysis of a horizontal cantilevered pipe conveying fluid with an inclined terminal nozzle is considered in this paper. The pipe is modelled as a cantilevered Euler-Bernoulli beam, and the flow-induced inertia, Coriolis and centrifugal forces along the pipe as well as the follower force induced by the jet-flow are taken into account. The governing equations of the coupled bending-torsional vibrations of the pipe are obtained using extended Hamilton's principle and are then discretized via the Galerkin method. The resulting eigenvalue problem is then solved, and several cases are examined to determine the effect of nozzle inclination angle, nozzle aspect ratio, mass ratio and... 

This letter presents new sufficient conditions for robust Hurwitz stability of interval matrices. The proposed conditions are based on two approaches: (i) finding a common Lyapunov matrix for the interval family and (ii) converting the robust stability problem into a robust non-singularity problem using Kronecker operations. The main contribution of the letter is to derive accurate and computationally simple optimal estimates of the robustness margin and spectral bound of general interval matrices. The evaluation of the condition relies on the solutions of linear matrix inequalities (LMIs) and eigenvalue problems, both of which are solved very efficiently. The improvements gained by using... 

Thermally developing mixed electroosmotically and pressure-driven flow in a parallel plate microchannel with a step change in wall temperature is considered in the framework of an extended Graetz problem. Both Joule heating and viscous dissipation effects are taken into consideration. Expressions for the dimensionless temperature and Nusselt number in the form of infinite series are presented. In general, the associated eigenvalue problem is solved numerically. Nevertheless, an analytical solution is also presented for axial locations close to the entrance. Comparisons are made between the present results and those obtained by approximating the electroosmotic velocity with the... 

This paper investigates the free vibrations of a shell made of n cone segments joined together. The governing equations of the conical shell were obtained by applying the Sanders shell theory and the Hamilton principle. Then, these governing equations are solved by using the power series method and considering a displacement field which is harmonic function about the time and the circumferential coordinate. Using the boundary conditions of the two ends of the shell and the continuity conditions at the interface section of shell segments, and solving the eigenvalue problem, the natural frequencies and the mode shapes are obtained. Very good agreements exist between the analytical results of... 

The potentials of carbon nanotubes (CNTs) as mechanical resonators for atomic-scale mass sensing are presented. To this aim, a nonlocal continuum-based model is proposed to study the dynamic behavior of bridged single-walled carbon nanotube-based mass nanosensors. The carbon nanotube (CNT) is considered as an elastic Euler–Bernoulli beam with von Kármán type geometric nonlinearity. Eringen’s nonlocal elastic field theory is utilized to model the interatomic long-range interactions within the structure of the CNT. This developed model accounts for the arbitrary position of the deposited atomic-mass. The natural frequencies and associated mode shapes are determined based on an eigenvalue... 

In this paper, we extract the fundamental resonant mode of a graphene patch using a variational method. We use 2-D eigenvalue problem obtained from the integral equation governing the surface current on graphene patterns under quasi-static approximation. To compute the eigenvalues, we propose three trial eigenfunctions, which meet the boundary conditions. We investigate the accuracy of these eigenfunctions with comparing to the results obtained by full wave simulations. Finally, we analyze square-lattice arrangements of graphene patches using the most accurate proposed eigenfunction and derive a very accurate surface impedance for it. The proposed surface impedance is much more precise than... 

Waveform design for Target identification and classification in MIMO radar systems has been studied in several recent works. While the previous works considered signal independent noise, here we extend the results to the case where signal-dependent noise, clutter, is also present and then we find the optimum waveform for several estimators differing in the assumptions on the given statistics. Computing the optimal waveforms for MMSE estimator leads to the Semi-definite programming (SDP) problem. Finding the optimal transmit signals for CSLS estimator results in a minimax eigenvalue problem. Finally it is shown that equal power waveforms are the best transmit signals for the SLS estimator.... 

Interactive vibrations and buckling of double current-carrying strips (DCCS) are investigated in this study. Considering the rotational and transverse deformation of the strip, four coupled equations of motion are obtained using Hamilton’s principle. Using the Galerkin method, mass and stiffness matrices are extracted and the stability of the system is determined by solving the eigenvalue problem. Effects of pretension and elevated temperature on the stability of DCCS are studied for three types of materials and various arrangements. Finally, the effect of horizontal or vertical distance between strips on the critical current value is investigated. According to the results, the effects of... 

Interactive vibrations and buckling of double current-carrying strips (DCCS) are investigated in this study. Considering the rotational and transverse deformation of the strip, four coupled equations of motion are obtained using Hamilton’s principle. Using the Galerkin method, mass and stiffness matrices are extracted and the stability of the system is determined by solving the eigenvalue problem. Effects of pretension and elevated temperature on the stability of DCCS are studied for three types of materials and various arrangements. Finally, the effect of horizontal or vertical distance between strips on the critical current value is investigated. According to the results, the effects of... 

This paper presents a model-based method for applying online proactive generators redispatch to improve damping of the critical electromechanical oscillations of power system. The proposed method comprises two stages: 1) monitoring modal characteristics of oscillatory modes in ambient condition, and 2) applying generators redispatch based on sensitivities of the critical mode to the generators active power changes using a new analytic method. An online identification method such as error feedback lattice recursive least square adaptive filter is applied for online estimation of the oscillatory modes. Then, whenever the damping ratio of an identified mode is less than a preset threshold, its... 

Objective: Joint analysis of multi-subject brain imaging datasets has wide applications in biomedical engineering. In these datasets, some sources belong to all subjects (joint), a subset of subjects (partially-joint), or a single subject (individual). In this paper, this source model is referred to as joint/partially-joint/individual multiple datasets unidimensional (JpJI-MDU), and accordingly, a source extraction method is developed. Method: We present a deflation-based algorithm utilizing higher order cumulants to analyze the JpJI-MDU source model. The algorithm maximizes a cost function which leads to an eigenvalue problem solved with thin-SVD (singular value decomposition)... 

Waveform design for Target identification and classification in MIMO radar systems has been studied in several recent works. While the previous works considered signal independent noise and found optimal signals for an e stimation algorithm, here we extend the results to the case where clutter is also present and then we will find the optimum waveform for several estimators differing in the assumptions on the given statistics. Several different approaches to the optimal waveform design are proposed, including minimizing the error of MMSE estimator, minimizing the maximum error of the covariance shaping least square (CSLS) estimator and minimizing the MSE error of scaled least square (SLS)... 

The present study attempts to analyze the extended Graetz problem in combined electroosmotic and pressure driven flows in rectangular microchannels, by employing a variational formulation. Both the Joule heating and axial conduction effects are taken into consideration. Since assuming a uniform inlet temperature profile is not consistent with the existence of these effects, a step change in wall temperature is considered to represent physically conceivable thermal entrance conditions. The method of analysis considered here is primarily analytical, in which series solutions are presented for the electrical potential, velocity, and temperature. For general treatment of the eigenvalue problem... 

Thermally developing electroosmotically generated flow of two viscoelastic fluids, namely the PTT and FENE-P models, through a slit microchannel is considered. Both the viscous dissipation and Joule heating effects are taken into account and a step change in wall temperature is considered to represent physically conceivable thermal entrance conditions. Expressions for the dimensionless temperature and Nusselt number in the form of infinite series are presented. In general, the resultant eigenvalue problem is solved numerically; nevertheless, an analytical solution is presented for the regions close to the entrance. A parametric study reveals that increasing amounts of the Peclet number... 

The present investigation considers the thermally developing electroosmotic flow of power-law fluids through a parallel plate microchannel. Both the viscous dissipation and Joule heating effects are taken into account and a step change in wall temperature is considered to represent physically conceivable thermal entrance conditions. Expressions for the dimensionless temperature and Nusselt number in the form of infinite series are presented. In general, the resultant eigenvalue problem is solved numerically; nevertheless, an analytical solution is presented for the regions close to the entrance. A parametric study reveals that increasing amounts of the Peclet number result in higher wall...