Sharif Digital Repository

This paper presents a reactive power valuation method with regard to its effect on realization of MW transactions. The security constraint optimization model in which the objective function is maximization of transactions is solved by the genetic algorithm approach. The proposed scheme allocates a specific amount of MW transactions to each dynamic reactive power source. An index is introduced to derive VAr value from the calculated optimal parameters of power network. This index represents the system-wide effect of MVAr sources on MW transactions implementations. Application of proposed method has been illustrated using IEEE 30 and 14 bus test systems. Results are discussed and compared in... 

Switched reluctance motors (SRM) are one of the most reliable and cost effective motors and their applications are increasing in industry. However, it suffers from high level of torque ripple. In this paper, a new configuration for stator and rotor of SRM is presented. In the proposed method, a new saliency is developed to remove negative torque and therefore decrease torque ripple and acoustic noise, increase efficiency and as a result, expand speed range. The simulation results demonstrate that the new motor structure has a smooth torque profile with possibility to work at higher speed lower acoustic noise  

This paper introduces a stochastic dynamic power management policy for soft real-time systems. Such a system comprises a single processor with the capability of dynamic voltage scaling (DVS). The policy uses DVS to consume less power in the processor while satisfying some performance constraints. The idea is based on a Markovian model of the system, which presents an analytical technique for tuning the system parameters and evaluating the effectiveness of the policy. Real-time jobs arrive according to a Poisson process and have exponentially distributed service times and relative deadlines. The power management policy is designed to reduce the long-run power consumption of the system while... 

Link adaptation of a wireless cellular network is of much attention due to the desire of maximizing both the a erage lin throughput and co erage reliability, which have conflicting effect on each other. In this paper, the intra-cell lin adaptation problem is formulated as a non-differentiable constrained optimization problem to maximize average link throughput while guaranteeing the best possible coverage reliability. To achieve this, a cutting plane optimization algorithm is employed. The performance of our method: adaptive modulation/coding with power management (AMCWPM) using proposed algorithm is compared with that of an adaptive modulation/coding (AMC) with no power management.... 

Purpose - The purpose of this paper is to investigate the effect of power on pulsed plasma thruster (PPT) discharge current with respect to its peak, duration, and behavior while the power elevates in a low power range. Design/methodology/approach - A rectangular parallel-plate breech-fed PPT has been developed with a self-inductor coupling element connecting the PPT cathode to the ignitor plug cathode. The PPT has been operated in vacuum chamber at 10-6mbar and its discharge current has been recorded using a Rogowski coil while input power has been changed by means of varying the capacitor voltage at given capacitance and frequency. Findings - The analysis leads to elucidate the effects of... 

This paper proposes a high performance voltage tracking and current sharing among parallel connected inverters by applying optimal control and minimizing the cost function. The control system forces the voltage of load to track the voltage reference, and the current of all inverters becomes equal. Therefore, both current sharing and voltage tracking are obtained. In addition, the smallest input energy and simplicity in control circuit are the other advantages of the suggested method. To show the performance of the proposed control scheme, the simulations with two-modular practical systems are performed and the results are provided. The results indicate that the control objectives are... 

A space vector modulation (SVM) approach is proposed to control a four-switch rectifier with power factor correction and compensating the effect of capacitors voltage ripple. The theory and performance of this method are presented, and the method effectiveness is demonstrated by extensive simulations. The simulation results show that the capacitor voltage ripple effects in the output voltage and current shaping can be omitted and the rectifier can work agreeably under high power factor condition although capacitors voltage is not balance. The allowable amount of this unbalanced value of filter capacitors is determined  

A methodology for controlling three phase PFC Sepic converter is presented, and behavior of the system is evaluated. The converter is connected in delta at the input and parallel at the output side, and is controlled by variable hysteresis current control method. By this approach, the current drawn by each of the individual converters is controlled to be in phase with its own input voltage. Detailed design criteria for the power and control stages of the single-phase SEPIC converter are presented and effects of this method on THD are verified  

Installing smart meters to publish real-time electricity rates has been controversial while it might lead to privacy concerns. Dispatched rates include fine-grained data on aggregate electricity consumption in a zone and could potentially be used to infer a household's pattern of energy use or its occupancy. In this paper, we propose Blowfish privacy to protect the occupancy state of the houses connected to a smart grid. First, we introduce a Markov model of the relationship between electricity rate and electricity consumption. Next, we develop an algorithm that perturbs electricity rates before publishing them to ensure users' privacy. Last, the proposed algorithm is tested on data inspired... 

Estimating the energy consumption of applications is a key aspect in optimizing embedded systems energy consumption. This paper proposes a simple yet accurate instruction-level energy estimation model for embedded systems. As a case study, the model parameters were determined for a commonly used ARM7TDMI-based microcontroller. The total energy includes the energy consumption of the processor core, Flash memory, memory controller, and SRAM. The model parameters are instructions opcode, number of shift operations, register bank bit flips, instructions weight and their Hamming distance, and different types of memory accesses. Also, the effect of pipeline stalls have been considered. In order to... 

Embedded systems are usually energy constrained. Moreover, in these systems, increased productivity and reduced time to market are essential for product success. To design complex embedded systems while reducing the development time and cost, there is a great tendency to use commercial off-the-shelf ("COTS") devices. At system level, dynamic voltage and frequency scaling (DVFS) is one of the most effective techniques for energy reduction. Nonetheless, many widely used COTS processors either do not have DVFS or apply DVFS only to processor cores. In this paper, an easy-to-implement COTS-based evaluation platform for low-energy embedded systems is presented. To achieve energy saving, DVFS is... 

In this paper the direct torque control (DTC) of the induction motor fed by four switch three phase inverter (FSTPI) is investigated. A modified space vector modulation (SVM) approach with optimal voltage vector sequence is proposed to compensate the effect of dc-link voltage variations caused by circulating phase current through the capacitor bank. SVMDTC scheme of FSTPI fed induction motor is based on stator flux oriented control. According to simulation results, this approach significantly reduces the effect of dc-link voltage variation on the output torque, flux and current waveforms  

Linear controllers have been widely used for controlling Active Power Filters (APFs). However, due to their limitations, a tradeoff between the bandwidth of the current control loop (CCL) and the voltage control loop (VCL) need to be made to remain stable in all conditions. This tradeoff leads to imperfect usage of the APF's capacity. Nonlinear controllers can eliminate such limitations and simultaneously remain stable in all conditions. In this paper, a new nonlinear controller for controlling the output current and the DC voltage (Vdc) of an APF is proposed. Feedback linearization method is applied on the CCL and the VCL is controlled via indirect method. In this method, an auxiliary... 

Hybrid electric vehicles (HEVs) have been developed as a promising way to decrease the fuel consumption and emissions of conventional vehicles. Although the noise emission of HEVs is generally lower than that of conventional vehicles, it is still an issue, especially in urban transportation. In this paper, a power management strategy is developed to minimize the annoying noise of the engine for an HEV. This is a modified version of the strategy that was originally established based on the speed ratio of continuously variable transmission (CVT) as the control parameter (CVT-based strategy). The engine combustion noise is assessed using the experimental data of the in-cylinder pressure. Also,... 

There is growing interest in evaluating the impact of soft errors on multiprocessor system-on-chip (MPSoC) at application-level rather than architectural-level, particularly in multimedia applications to optimize system design. This has recently led to the concept of application-level correctness. In this paper, we consider the relationship between application-level correctness and system-level power management using voltage scaling technique with the aim to generate designs that are optimized in terms of power consumption, while providing acceptable application-level correctness and meeting real-time performance deadlines. We propose a novel voltage scaling technique based on linear... 

Electric power deregulation has drastically affected the engineering aspects of planning. In addition need flexible electric systems, changing regulatory and economic scenarios, energy savings and environmental impact are providing impetus to the development of Distributed Generation (DG), which is predicted to play an increasing role in the electric power system of the future. This opens the venue for distribution company's (Disco) aiming to minimize their investment risks by developing optimum new planning strategies to meet the load growth and satisfy the system performance at minimum cost different electricity structures. This paper proposes a framework for solving the distribution... 

Time redundancy (rollback-recovery) and hardware redundancy are commonly used in real-time systems to achieve fault tolerance. From an energy consumption point of view, time redundancy is generally more preferable than hardware redundancy. However, hard real-time systems often use hardware redundancy to meet high reliability requirements of safety-critical applications. In this paper we propose a hardware-redundancy technique with low energy-overhead for hard real-time systems. The proposed technique is based on standby-sparing, where the system is composed of a primary unit and a spare. Through analytical models, we have developed an online energy-management method which uses a slack... 

In a deregulated environment of power distribution industry, a comprehensive economic evaluation for the implementation of distribution automation (DA) systems is inevitable. Using the presented methodology in this paper and system dynamics approach, it is efficiently possible to deal with variation of the economic parameters such as the interest rate, inflation rate, energy supply cost, load growth, etc. In this paper, economic short-run and long-run impacts of DA systems are evaluated from utility point of view. Also economic benefits from customers' point of view are analyzed. A practical pricing strategy for maximizing the utility profit is suggested depending on the underlying market... 

A single-stage structure is proposed for realizing a unity power factor three-phase isolated AC-DC converter for telecommunication power supply modules. This structure is composed by integrating a boost converter to the isolated threephase three-switch buck rectifier. Modified space vector modulation method is applied to the three-phase three-switch isolated unity power factor input buck rectifier based on the space vector modulation for non-isolated buck. The output boost switch operates during heavily unbalanced mains conditions. Input currents are sinusoidal and in phase with the input voltages even for heavily unbalanced input voltages, e.g. loss of one phase. The converter is modeled by... 

Electric spring (ES) as a novel concept in power electronics has been developed for the purpose of dealing with demand-side management. In this paper, to conquer the challenges imposed by intermittent nature of renewable energy sources (RESs) and other uncertainties for constructing a secure modern microgrid (MG), the hybrid distributed operation of ESs and electric vehicles (EVs) parking lot is suggested. The proposed approach is implemented in the context of a hybrid stochastic/robust optimization (HSRO) problem, where the stochastic programming based on unscented transformation (UT) method models the uncertainties associated with load, energy price, RESs, and availability of MG equipment....