Search for: electrochemical-studies
A study of glycine-based dithiocarbamates as effective corrosion inhibitors for cold rolled carbon steel in HCl solutions, Article Surfaces and Interfaces ; Volume 21 , 2020 ; Shockravi, A ; Mokarami Ghartavol, H ; Ziyaei Halimehjani, A ; Ostadrahimi, M ; Mirhosseini, S. M ; Behzadi, H ; Ghorbani, M ; Sharif University of Technology
Elsevier B.V 2020
The corrosion inhibition of glycine-based dithiocarbamates with benzyl (BDTC) and propyl (PDTC) groups were investigated for cold rolled carbon steel (CRS) in 0.5 M HCl, indicating that the compounds as mixed type inhibitors significantly reduced the corrosion rate of the CRS due to the formation of a stable protective film on the metal surface. As confirmed by ATR-FTIR, SEM, AFM, XPS and theoretical studies, chemically adsorbed BDTC molecule is a better corrosion inhibitor with higher corrosion efficiency of about 98% at room temperature and a better thermal stability attributed to the Fe-S and Fe-N bindings, and in addition, to the presence of the benzene ring in the molecular structure. ©...
Article Journal of Solid State Electrochemistry ; Volume 14, Issue 4 , 2010 , Pages 643-650 ; 14328488 (ISSN) ; Gobal, F ; Raissi, H ; Moghiminia, S ; Sharif University of Technology
Nanostructured molybdenum oxide was potentiodynamically deposited onto a stainless steel surface from an aqueous bath by cycling the potential between 0 and -0.75 V vs. Ag/AgCl. The deposit consisted of particulates in the range of 30 to 80 nm. Electrochemical studies under galvanostatic charge/discharge and also impedance spectroscopy revealed capacitive behavior in the potential range of -0.3 to -0.55 V vs. Ag/AgCl with the value of 477 F g-1 at 0.1 mA/cm2. An equivalent circuit comprising of three parallel branches consisting of double-layer capacitance, Warburg impedance, and a constant phase element signifying pseudo-capacitance each coupled with their corresponding resistances was...
RGO-α-Fe2O3/β-FeOOH ternary heterostructure with urchin-like morphology for efficient oxygen evolution reaction, Article Journal of Electroanalytical Chemistry ; Volume 843 , 2019 , Pages 1-11 ; 15726657 (ISSN) ; Kowsari, E ; Seifvand, N ; Naseri, N ; Sharif University of Technology
Elsevier B.V 2019
RGO-α-Fe2O3/β-FeOOH ternary heterostructure composite has been developed as an active photocatalyst for photoelectrochemical water splitting. RGO-α-Fe2O3/β-FeOOH has been successfully synthesized through one-pot hydrothermal-ionic liquid assisted route using tetrabutyl ammonium L-methioninate [TBA][L-Met]and graphene oxide (GO). The electrochemical studies were carried out to demonstrate the oxygen evolution reaction (OER)and photocatalytic activities. The overpotential reduction by rGO-α-Fe2O3/β-FeOOH sample was higher than the nanobean α-Fe2O3/β-FeOOH and pristine α-Fe2O3 samples. The photocurrent density enhanced for rGO-α-Fe2O3/β–FeOOH urchin-like structure and obtained as 0.62 mA·cm−2....
Structural, microstructural and electrochemical studies of TiO2-Ag double layer coated NCM cathode for lithium-ion batteries, Article Materials Research Express ; Volume 6, Issue 8 , 2019 ; 20531591 (ISSN) ; Ghorbanzadeh, M ; Sharif University of Technology
Institute of Physics Publishing 2019
Lithium ion batteries as one of the most important energy storage equipments, have several challenges including capacity drop as number of cycles increases. Cathode particle coating is an effective approach in improvement of electrochemical performance of the batteries. In this study, TiO2-Ag coating was used to improve NCM cathode performance. The microstructure and crystal structure properties of coated NCMs were evaluated by the FE-SEM and XRD. Electrochemical behavior of the batteries was investigated by cycling performance analysis and EIS. TiO2 coating was deposited as a uniform layer and Ag coating was precipitated as dispersed nanoparticles. The results shows that using of TiO2-Ag...
Electrocrystallization of Ni nanocones from chloride-based bath using crystal modifier by electrochemical methods, Article Journal of Alloys and Compounds ; Volume 818 , 2020 ; Aliofkhazraei, M ; Dolati, A ; Rouhaghdam, A. S ; Sharif University of Technology
Elsevier Ltd 2020
The early stages of nucleation and growth of nanostructures can control the shape and final size of the fabricated nanostructure. Therefore, the study of the nucleation and growth mechanism of nanostructures is of great importance. The purpose of this study is to investigate the nucleation and growth mechanism of nickel nanocones from a chloride-based bath containing ethylene ammonium dichloride as a crystal modifier. Cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and chronoamperometry tests were employed to investigate the nucleation and growth mechanism and also the mechanism of crystal modifier performance on the growth of nanocones. Electrochemical studies revealed...
Article Materials Chemistry and Physics ; Volume 263 , 2021 ; 02540584 (ISSN) ; Shahrokhian, S ; Navabi, M ; Sharif University of Technology
Elsevier Ltd 2021
A novel modified electrode is reported for the electrochemical investigation of the oxidation mechanism and also voltammetric determination of raloxifene (RLX). The surface of the electrode was modified with a thin layer of reduced graphene oxide-carbon nanotube nano-composite (rGO-CNT) was prepared, and successfully employed for the electrochemical studies of RLX. The morphology of the sensor surface was characterized by using a scanning electron microscopy. RLX Oxidation response significantly increased at the GCE covered with rGO-CNT, regarding the bare and CNT or rGO functionalized GCE. Experimental parameters affecting the RLX response were optimized and mechanism of the RLX oxidation...
Article Cuihua Xuebao/Chinese Journal of Catalysis ; Volume 31, Issue 11 , 2010 , Pages 1351-1357 ; 02539837 (ISSN) ; Rashvand Avei, M ; Danaee, I ; Gobal, F ; Mahjani, M. G ; Sharif University of Technology
A stable copper (hydr)oxide-modified electrode was prepared in 0.5 mol/L NaOH solution by cyclic voltammetry in the range of -250 to 1000 mV. It can be used for electrochemical studies in the range of -250 to 1000 mV without interfering peaks because there is no oxidation of copper. During an anodic potential sweep, the electro-oxidation of saccharose on Cu occurred by the formation of CuIII and this reaction also occurred in the early stages of the reversed cycle until it is stopped by the negative potentials. A mechanism based on the electro-chemical generation of CuIII active sites and their subsequent consumption by saccharose was proposed, and the rate law and kinetic parameters were...
Selecting Support Layer for Electrodeposited Efficient Cobalt Oxide/Hydroxide Nanoflakes to Split Water, Article ACS Sustainable Chemistry and Engineering ; Volume 4, Issue 6 , 2016 , Pages 3151-3159 ; 21680485 (ISSN) ; Esfandiar, A ; Qorbani, M ; Moshfegh, A. Z ; Sharif University of Technology
American Chemical Society 2016
Energy and environment crises motivated scientists to develop sustainable, renewable, and clean energy resources mainly based on solar hydrogen. For this purpose, one main challenge is the low cost flexible substrates for designing earth abundant efficient cocatalysts to reduce required water oxidation overpotential. Here, a systematic morphological and electrochemical study has been reported for cobalt oxide/hydroxide nanoflakes simply electrodeposited on four different commercially available substrates, titanium, copper sheet, steel mesh, and nickel foam. Remarkable dependence between the used substrate, morphology, and electrocatalytic properties of nanoflakes introduced flexible porous...
Cyclometalated platinum(II) complexes of 2,2′-bipyridine N-oxide containing a 1,1′-bis(diphenylphosphino)ferrocene ligand: structural, computational and electrochemical studies, Article Dalton Transactions ; Volume 46, Issue 6 , 2017 , Pages 2013-2022 ; 14779226 (ISSN) ; Fereidoonnezhad, M ; Niazi, M ; Mosavi, S. T ; Habib Kazemi, S ; Kia, R ; Shirkhan, S ; Abdollahi Aghdam, S ; Sharif University of Technology
Royal Society of Chemistry 2017
The preparation and characterization of new heteronuclear-platinum(ii) complexes containing a 1,1'-bis(diphenylphosphino)ferrocene (dppf) ligand are described. The reaction of the known starting complex [PtMe(κ2N,C-bipyO-H)(SMe2)], A, in which bipyO-H is a cyclometalated rollover 2,2'-bipyridine N-oxide, with the dppf ligand in a 2:1 ratio or an equimolar ratio led to the formation of the corresponding binuclear complex [Pt2Me2(κ2N,C-bipyO-H)2(μ-dppf)], 1, or the mononuclear complex [PtMe(κ1C-bipyO-H)(dppf)], 2, respectively. According to the reaction conditions, the dppf ligand in 1 and 2 behaves as either a bridging or chelating ligand. All complexes were characterized by NMR spectroscopy....
Article Electrochemistry Communications ; Volume 11, Issue 7 , 2009 , Pages 1425-1428 ; 13882481 (ISSN) ; Ghalkhani, M ; Sharif University of Technology
Thin carbon nanoparticle/Nafion film (CNP/N), as a novel electrode material, is formed on the surface of the glassy carbon electrode in a simple solvent evaporation process. The electrochemical behavior of Azathioprine (Aza) at the CNP/N-modified electrode is investigated in detail by the means of cyclic voltammetry. During the electrochemical reduction of Aza, an irreversible cathodic peak is appeared. Cyclic voltammetric studies indicated that the reduction process has an irreversible and adsorption-like behavior. The observed reduction peak is attributed to a four-electron process referring to the reduction of nitro group to the corresponding hydroxylamine. The prepared electrode showed...