Sharif Digital Repository

In this paper, fungal rennin production has been carried out by solid state fermentation of Mucor miehei NRRL 3420. The optimum dilution ratio, temperature and fermentation time of the enzymatic solution were determined to be 1:30, 40°C and 4 days after the beginning of the fermentation process, respectively. Also, the enzyme recovery by precipitation was studied using (NH4)2SO4, acetone and ethanol, respectively. The effects of pH, salt and solvent concentration on rennin recovery were studied and the optimum pH value as well as the optimum salt concentration were determined. The maximum specific activity of the enzyme was obtained by precipitation at pH of 6.5 and 50% saturated solution of... 

In this study the effect of different nitrogen source substrates on the amount of chitosan production by Aspergillus niger was investigated. A. niger PTCC 5012 from the Persian Type Culture Collection (PTCC) was grown on soy bean, corn seed and canola residues at 30 °C for specified cultivation days under sterilized conditions. Chitosan was extracted from the fungal mycelia using hot alkaline and acid treatment. The results were shown that soy bean residue at moisture of 37% and 8.4 ± 0.26 % of nitrogen content produced the highest amount of chitosan (17.053 ± 0.95 g/kg of dry substrate), after 12 days of incubation. Corn seed residue produced very low amount of chitosan (1.9 ± 0.4 % of... 

Dissolved oxygen tension and shear stress as two very important factors in fungal fermentation were studied in the batch cultures of Aspergillus niger. The intention was to maximize the total activity of glucose oxidase produced in a 5-1 bench-top bioreactor. 300 rpm found to be optimum for enzyme production, however in higher mixing rates higher growth was achieved. The maximum activity of glucose oxidase was obtained in 1.5 vvm while the best aeration rate for growth was 2 vvm. Glucose oxidase with the activity of 548 U mL-1 was produced in 1.5 vvm and 300 rpm as the optimum conditions. © 2007 Asian Network for Scientific Information  

The objective of this research work was to obtain a microorganism capable of decolorizing treated distillery wastewater (TDW). 21 isolated and procured microorganisms were screened for their percentage decolorization. The screening strategy was performed using three different culture media in two main steps. The primary screening was carried out in two stages. In the first stage 10 microorganisms had a lower than 25% decolorization of TDW (with 25% TDW concentration). In the second stage 8 microorganisms had more than a 48% decolorization of TDW. In the secondary screening all 3 different culture media, the effect of TDW concentration, pH and nitrogen source were studied. A fungus identified... 

Mobile phones are known as the most widely used electronic instruments, and an enormous number of discarded mobile phones are generated. The present work used a pure culture of Penicillium simplicissimum in a bubble column bioreactor to extract Cu and Ni from mobile phone printed circuit boards (MPPCBs) waste. Molasses was used as an efficient carbon source to enhance bioleaching efficiency and increase the cost benefits. The adaptation phase was done at Erlenmeyer flasks to reach 40 g/L of MPPCBs powder. The most significant parameters, including the mass of MPPCBs powder, aeration, molasses concentration, and their interaction, were optimized in order to leach the maximum possible Cu and... 

Production yield of solid-state (SSF) and submerged fermentation (SMF) on chitosan from Aspergillus niger was investigated. A. niger BBRC 20004 was grown on soybean residue and Sabouraud Dextrose Broth medium (2% glucose). Chitosan was extracted from the fungal mycelia using hot alkaline and acid treatment. Soybean residue at a moisture content of 37%, and 8-4 ± 0.26% of nitrogen content produced the highest amount of chitosan, 17.053 ± 0.95 g/kg dry substrate after 12 days. Also, chitosan was extracted from A. niger on Sabouraud Dextrose Broth medium in submerged fermentation (0.8455 g/l after 12 days of cultivation). The yield of chitosan isolated in SSF was about 15-20 times more than in... 

The effect of glucose concentration in submerged fermentation (SMF) on chitosan production by Aspergillus niger was investigated. A. niger, BBRC, 20004, from the Biochemical and Bioenvironmental Research Centre at Sharif University of Technology, Tehran, Iran, was grown in a Sabouro Dextrose media. Chitosan was extracted from the fungal mycelia using hot alkaline and acid treatment and after 12 days of cultivation, 0.8455 g chitosan /l of the fermentation medium was obtained. The content of glucose in the Sobouro Dextrose Broth media was also changed and the highest yield of chitosan 0.9121 g/l was obtained in Sobouro Dextrose Broth media containing 8% glucose. © Sharif University of... 

Adaptation of Penicillium simplicissimum with different heavy metals present in a spent hydrocracking catalyst, as well as one-step, two-step, and spent medium bioleaching of the spent catalyst by the adapted fungus, was examined in batch cultures. Adaptation experiments with the single metal ions Ni, Mo, Fe, and W showed that the fungus could tolerate up to 1500. mg/L Ni, 8000. mg/L Mo, 3000. mg/L Fe, and 8000. mg/L W. In the presence of multi-metals, the fungus was able to tolerate up to 300. mg/L Ni, 200. mg/L Mo, 150. mg/L Fe and 2500. mg/L W. A total of 3% (w/v) spent catalyst generally gave the maximum extraction yields in the two-step bioleaching process (100% of W, 100% of Fe, 92.7%... 

A short lifespan and increased consumption patterns make e-waste the world's fastest-growing waste stream. Computers are one of the most significant parts of e-waste. Recycling of e-waste has been introduced as the main solution to deal with environmental problems and to save natural mines. This research aims to investigate the bioleaching of Cu, Ni, and Al from computer printed circuit boards (CPCBs) using Penicillium simplicissimum. The adaptation phase began at 1 g/l CPCBs powder with 107 spores and final pulp density was reached at 30 g/l. The most effective parameters including pulp density, initial pH, and the sucrose concentration were optimized to achieve maximum simultaneous... 

Removal of zirconium from its dilute aqueous solution using Aspergillus niger as a dried and living biomass was investigated. Through that, the effect of some operational parameters on biosorption, including pH, temperature, contact time, initial concentration of zirconium and dose of biomass, were studied. Based on the results, it was concluded that the uptake of zirconium by both dried and living biomasses is pH dependent, and maximum uptake was observed in pH = 3.1 for both biomasses. The maximum uptake capacity of the living biomass was obtained at 30°C. However, the biosorption of zirconium by dried biomass was not affected by temperature. The maximum uptake capacity for living and... 

This study was focused on the heavy metal (Ni, Co, Mo, V, Mn, Fe, W and Zn) tolerance of fungi strains Aspergillus niger, Aspergillus foetidus and Penicillium simplicissimum. Aspergillus niger was exposed to a mixture of Mo, V and Mn at a mass ratio of 1:2:6 as approximately present in the spent refinery processing catalyst. This study highlights the adaptation of fungi strains to Tungsten and Vanadium to high concentration. The effect of different metals and metal concentration on different strains of fungi was evaluated. Results showed that Ni was one of the most toxic metals for strains of Aspergillus and Penicillium. Aspergillus foetidus was the least tolerant, in particular for Ni, Co... 

There is a substantial volume of mobile phone waste every year. Due to the disadvantages of traditional methods, it is necessary to look for biological processes that are more eco-friendly and economical to recover metals from e-waste. Fungi provide large amounts of organic acids and dissolve metals but using sucrose in the medium is not economical. In this paper, the main objective is to find a suitable alternative carbon substrate instead of sucrose for fungi bioleaching of Ni and Cu in printed circuit boards (PCBs) of mobile phones using Penicillium simplicissimum. Four kinds of carbon sources (including sucrose, cheese whey, sugar, and sugar cane molasses) were selected. Also, pH and... 

Bisphenol A (BPA), which is a major component in the production of various consumer products, is one of the most significant endocrine-disrupting chemicals. In this research, the biocatalytic elimination of Bisphenol A using laccase produced by Phanerochaete chrysosporium was examined and optimized. The response surface methodology was used to study the effect of independent variables such as pH, temperature, initial laccase activity, initial Bisphenol A concentration, and the interactive effects of each variable on the removal of Bisphenol A and residual enzyme activity. Based on response surface plots, the maximum Bisphenol A removal (93%) was detected at a pH value of 8, temperature... 

Arbuscular mycorrhizal (AM) fungi are non-specific symbionts developing mutual and beneficial symbiosis with most terrestrial plants. Because of the obligatory nature of the symbiosis, the presence of the host plant during the onset and proceeding of symbiosis is necessary. However, AM fungal spores are able to germinate in the absence of the host plant. The fungi detect the presence of the host plant through some signal communications. Among the signal molecules, which can affect mycorrhizal symbiosis are plant hormones, which may positively or adversely affect the symbiosis. In this review article, some of the most recent findings regarding the signaling effects of plant hormones, on... 

The kinetics of bioleaching of Mo, Ni, and Al from spent hydrocracking catalyst, using Aspergillus niger was studied. The four most effective bioleaching variables were selected in accordance with the Plackett-Burman design and were further optimized via central composite design (CCD). The optimal values of the variables for maximum multi-metal bioleaching were as follows: particle size 150-212. μm, sucrose 93.8. g/L, pulp density 3%. w/v, and pH 7. The maximum metal recoveries corresponding to these conditions were 99.5 ± 0.4% Mo, 45.8 ± 1.2% Ni, and 13.9 ± 0.1% Al. The relatively low Ni extraction was attributed to the precipitation of Ni in the presence of oxalic acid. Under the optimal... 

The ability of Paraconiothyrium variabile, a laccase producing ascomycete recently isolated from soil, was studied to eliminate chlorophenol derivatives in submerged culture medium. Among the tested compounds, ρ-chlorophenol (ρ-CP) and pentachlorophenol (PCP) were found to have minimum and maximum toxic effects, respectively, on the growth of the microorganism and at the same time high and low bioelimination percentages. The fungal strain was able to remove 86% of ρ-CP (with initial concentration of 40mgl -1) and 56% of 2,4-dichlorophenol (2,4-DCP; with same concentration as ρ-CP) after 9 days of incubation while no elimination was observed in the presence of 2,4,6-trichlorophenol... 

Enzymatic decolorization of the monoazo dye, acid orange 7 (AO7) by the fungal peroxidase from Coprinus cinereus NBRC 30628 is a complex system, which is greatly affected by temperature, pH, enzyme activity and the concentrations of H2O2 and dye concentration. The study of these factors and investigating the combined interactions between them by applying one-factor-at-a-time (OFAT) method and two other statistical methods including 2-factorial method and response surface methodology (RSM) were aimed in this work. Through OFAT analysis the optimized conditions were a temperature of 25 °C, pH 9.0 with H2O2 concentration of about 3.9 mM and AO7 concentration of 40 mg/l. A complete... 

Background: Warts are the most common clinical manifestation of the human papilloma-virus infection in the skin and mucous membranes. In spite of the various therapeutic modalities for nongenital skin warts, there is still no single method to be used as an approved treatment. In this study, we compared the efficacy of immunotherapy and cryotherapy on wart lesions. Methods: Sixty patients with verruca vulgaris and plantar warts were randomly divided into two groups. One group received intralesional injection of candida antigen repeated every 3 weeks until complete improvement of all warts or for a maximum of three sessions. The second group was treated by cryotherapy with liquid nitrogen for... 

Introduction: In recent years, the use of cost-effective, multifunctional, environmentally friendly and simple prepared nanomaterials/nanoparticles have been emerged considerably. In this manner, different synthesizing methods were reported and optimized, but there is still lack of a comprehensive method with multifunctional properties. Materials and Methods: In this study, we aim to synthesis the copper oxide nanoparticles using Achillea millefolium leaf extracts for the first time. Catalytic activity was investigated by in situ azide alkyne cycloaddition click and also A3 coupling reaction, and optimized in terms of temperature, solvent, and time of the reaction. Furthermore, the...