Sharif Digital Repository

Mixed matrix membranes of synthesized polyurethane (PU) based on toluene diisocyanate (TDI), polydimethylsiloxane (PDMS) and polytetramethylene glycol (PTMG) with polyvinyl alcohol based polar silica particles were prepared by solution casting technique. The homogeneity and thermal properties of the prepared PDMS-PU/silica membranes were characterized using scanning electron microscope (SEM), differential scanning calorimetry (DSC) and thermal gravimetric analysis (TGA). The SEM micrographs confirmed the distribution of silica particles in the polymer matrix without agglomerations. Gas permeation properties of membranes with different silica contents were studied for pure CO2, CH4, O2, He... 

Natural gas contains several impurities, e.g., CO 2 and H 2S, which have undesirable effects on the performance of the glassy polymeric membranes. The plasticization effect of H 2S at high concentrations on the gas separation performance of polyphenylene oxide hollow fiber membrane has been studied at different compositions of H 2S and feed pressures. The existence of high concentrations of H 2S in CH 4 feed mixture, which is present in many natural gas sources in Iran, enhances plasticization. For a H 2S/CH 4 mixture containing 5008 ppm H 2S at ≈ 75 psig, the H 2S permeance reduces by > 45% from its initial value. H 2S acts as a plasticizer in H 2S/CH 4 membrane separation at elevated... 

Impurities such as hydrogen sulfide, water vapor and heavy hydrocarbons in natural gas have considerable effects on the membrane performance. Small amounts of condensable and polymer soluble components in the feed gas cause swelling or plasticization of glassy membranes, leading to a reduction in membrane selectivity. In the present research the influence of ethane was investigated on the permeance and selectivity of two commercially available hollow fiber membranes, namely Cardo-type polyimide and PPO hollow fibers for CO 2/CH 4 separations. It was concluded that the gas mixture permeation rate was increased in the presence of C 2H 6. However, the CO 2/CH 4 separation factors remained... 

Graphene oxide membranes were prepared by vacuum and pressurized ultrafiltration methods on the 12% modified Polyacrylonitrile (12mPAN) substrate to specify challenges, salient features, future directions, and potential of GO membrane for separation fields using characterization techniques and gas separation test (studied gases are CO2, He and N2), which is an efficient tool for better understanding of GO membrane behavior. GO membrane structure was examined over a wide range of parameters, such as pore size range of substrate and its surface properties, pH of GO dispersion, GO content, synthesis pressure, operating pressure and temperature. The results show that the GO content does not hold... 

Novel PVA/PEG cross-linked membranes were prepared with (0–20 wt. %) of silica nanoparticles. The presence of both the polymers and additive was confirmed by FTIR analysis. The thermal properties of the membranes were analyzed by TGA and DSC analysis. The morphological and mechanical properties of the membranes were studied by SEM analysis and tensile testing, respectively. The gas permeation performances of the membranes were examined using state-of-the-art gas permeability cell. It was found that permeability of all the gases increased with the increase of silica loading, whereas ideal selectivity of carbon dioxide with respect to nitrogen and methane increased up to 10 wt. % loading and... 

A mathematical model has been developed that is based the dual sorption in the dense layer and pore flow in the porous layer. In the porous layer a resistance model is applied where four mechanisms, i.e., Knudsen, Viscous, Slip, and Surface flows, are superimposed. Steady-state, constant pressure along the membrane and constant physical properties are assumed. Its application to the separation of H 2S/CH 4 gas mixtures as a sour gas in natural gas sweetening by using a PPO hollow fiber module is put forward. The Quasi Newton method is used to determine the parameters of membrane transport model for the case of H 2S/CH 4 separation. The H 2S and CH 4 permeances increased by increasing the... 

If an ideal membrane for gas separation is to be obtained, the following three characteristics should be considered: the membrane should be as thin as possible, be mechanically robust, and have welldefined pore sizes. These features will maximize its solvent flux, preserve it from fracture, and guarantee its selectivity. Graphene is made up of a hexagonal honeycomb lattice of carbon atoms with sp2 hybridization state forming a one-atom-thick sheet of graphite. Following conversion of the honeycomb lattices into nanopores with a specific geometry and size, a nanoporous graphene membrane that offers high efficiency as a separation membrane because of the ultrafast molecular permeation rate as... 

The solubility of carbon dioxide and hydrogen sulfide gases in the ionic liquid 1-ethyl-3-methylimidazolium trifluoromethanesulfonate ([C2mim][OTf]) was measured at temperatures from (303.15-353.15) K and pressures up to about 3.0 MPa. The Henry's law constants were determined from the new experimental data, which in turn were used to derive the change of some thermodynamic functions of dissolution of the gases in that particular ionic liquid. The new experimental data were correlated by a combination of the extended Henry's law and Pitzer's model for the excess Gibbs energy. The average relative percent deviation (ARD%) of correlated molality values from experimental data are within... 

We demonstrated a novel mixed-matrix composite membrane (MMCM) based on acrylated polyurethane (APU) and UiO-66 nanoparticles to separate CO 2 /N 2 mixture. UiO-66 and functionalized UiO-66 including NH 2 -UiO-66 and glycidyl methacrylate (GMA)-UiO-66 were loaded into APU/2-hydroxyethyl methacrylate (APUH) matrix at variable concentrations between 3 and 30 wt %. APUH/GMA-UiO-66 MMCMs exhibited strong adhesion with a support layer of polyester/polysulfone, which was not deteriorated after immersion in water for a long time (20 days). Incorporation of UiO-66 and its functionalized forms increased simultaneously permeability and CO 2 /N 2 selectivity, which were indeed superior in comparison... 

In this work, poly(vinyl) alcohol (PVA)/poly(ethylene) glycol (PEG) 600 g/mol cross-linked membranes with different alumina (Al2O3) content were synthesized. The membranes were then characterized by FTIR, TGA, DSC, SEM, mechanical strength and permeation properties for carbon dioxide and nitrogen gases at different operating temperatures. The FTIR results confirmed the acetal linkages of cross-linking at 1083 cm−1 and the presence of stretching and bending peaks of Al-O bond at 598 and 444 cm−1, respectively. TGA results showed that the thermal stabilities of the membranes improved with the addition of alumina particles. DSC analysis proved that the glass transition temperature of the... 

Mixed-matrix membranes (MMMs) are promising candidates for carbon dioxide separation. However, their application is limited due to improper dispersion of fillers within the polymer matrix, poor interaction of fillers with polymer chains, and formation of defects and micro-voids at the interface of both phases, which all result in the decline of the gas separation performance of MMMs. In this work, we present a new method to overcome these challenges. To this end, a series of MMMs based on polyethersulfone (PES) as the continuous polymer matrix and MIL-53-derived MOFs as the dispersed filler were prepared. FTIR-ATR, XRD, TGA, FESEM, and N2 adsorption/desorption analyses were employed to... 

Supersonic separators (3Ss) are applied in gas separation processes. Two-dimensional simulation is employed to investigate the effect of operational and thermophysical parameters on the shockwave position. In addition, the impact of the cyclonic part and wet outlet geometry is evaluated by proposing four cases. Increasing the length of the cyclonic part exerts positive and negative influences on the performance of the 3S and the pressure recovery coefficient, respectively. The optimum length is determined between 10 and 15 cm. To demonstrate negative effects of wasted air from the wet outlet, its flow has been increased from 3.6 to 8.1 % of the inlet flow. Improved performance of the 3S is... 

A brass vortextube is used to carry out a series of experiments. The main objective of the present research is to investigate the separation performances of a vortex tube (VT) for a hydrocarbon mixture. Examination is also applied to study the effects of nozzle intakes number and cold fraction on the gas species separation at specific inlet pressure 236.37 kPa in a VT with two gas mixtures (LPG as a hydrocarbon mixture and LPG-N2). A two-dimensional computational fluid dynamic (CFD) model simulation of a VT is presented. CFD code after validation is also applied to investigate the role of cold fraction and nozzle intakes number on the gas species separation. The highly rotating flow field... 

Zeolite SAPO-34 was used for fabrication of mixed matrix membranes (MMMs) to improve the CO2/CH4/N2 gas separation performance of the neat Pebax1074 membrane. Permeability and selectivity of the MMMs were studied at different temperatures of 25-65°C and pressures of 4-24 bars. Also sorption of different gases in MMMs was measured at 35°C and different pressures, which showed enhanced solubility coefficients. Moreover, thermal, morphological and mechanical properties of MMMs were characterized by differential scanning calorimetry (DSC), scanning electron microscope (SEM) and tensile analysis. The results showed excellent improvement in... 

In this study, the effects of the type and content of reactive diluents on the permeation/separation of carbon dioxide/nitrogen (CO2/N2) through acrylate-terminated polyurethane (APU)-acrylate/acrylic diluent (APUA) composite membranes was investigated. A series of APUs based on poly(ethylene glycol) (PEG)-1000 g mol−1, toluene diisocyanate, and 2-hydroxyethyl methacrylate was synthesized and then diluted with several reactive diluents. The results obtained from differential scanning calorimetry (DSC) and Fourier transform infrared analyses showed that the microphase interference of hard and soft segments increased with increasing reactive diluent content. Furthermore, with increasing alkene... 

A high silica CHA-type membrane was synthesized by the in-situ crystallization method on a disk like α-alumina porous support to separate both acid (H2S, CO2) gases from methane. The membrane showed a permeance of 3.39×10-8mol/m2sPa for pure CO2with CO2/CH4 ideal selectivity of 21.6 at 303K and 100kPa pressure difference across the membrane. The membrane was also tested with N2 and O2 pure gases indicating a small O2/N2 selectivity of 1.2-1.4, which shows that this type of membrane is not suitable for O2/N2 separation. The membrane performance was also analyzed by binary (CO2-CH4) and ternary (H2S-CO2-CH4) gas mixtures, with compositions near the real sour natural gas (CO2: 2.13mol%, H2S:... 

Gas separation properties of commercially available polyphenylene oxide (PPO) and Cardo-type polyimide (PI) hollow fiber membranes were investigated by CO2/CH4 and O2/N2 separation experiments. The pure gas permeation and the mixed gas separation experiments indicated that the two hollow fiber membranes were suitable candidates for O2/N2 and CO2/CH4 separations. Average O2/N2 permselectivities of 3.9 and 5.7 for PPO and PI hollow fibers, respectively, average CO2/CH4 permselectivities of 16.4 and 36.0 for PPO and PI hollow fibers, respectively, CO2 permeances of 210 and 110 GPU at 100 psig for PPO and PI hollow fibers, and O2 permeances of 40 GPU and 15 GPU for PPO and PI hollow fibers were... 

New experimental results are presented for the solubility of carbon dioxide, hydrogen sulfide in the ionic liquid 1-octyl-3-methylimidazolium hexafluorophosphate ([C8mim][PF6]) at temperatures range from (303.15 to 353.15) K and pressures up to about 2 MPa. The solubility of the mixture of CO2/H2S in [C8mim][PF6] under various feed compositions were also measured at temperatures of (303.15, 323.15 and 343.15) K and the pressure up to 1 MPa. The solubility of carbon dioxide and hydrogen sulfide increased with increasing pressure and decreased with increasing temperature and the solubility of H2S is about three times that of CO2 in the particular ionic liquid studied. The measured data were... 

In this article an attempt was made to fabricate defect-free asymmetric polysulfone (PSf) membranes for the separation of oxygen and nitrogen. The approach is based on the enhanced delayed demixing by blending surface modifying macromolecules (SMMs) in the casting solution and by immersing the cast film in isopropanol for a certain period before it is immersed in water. Different SMMs, including hydrophobic and charged SMMs, were synthesized, characterized, and blended to the host PSf. It was found that the charged SMM could indeed contribute to the removal of defective pores from the skin layer and enhancement of oxygen/nitrogen selectivity. The experimental results were further interpreted...