Loading...
Search for:
heat-treatment-time
0.005 seconds
Influence of martensite volume fraction on impact properties of triple phase (TP) steels
, Article Journal of Materials Engineering and Performance ; Volume 22, Issue 3 , 2013 , Pages 823-829 ; 10599495 (ISSN) ; Ekrami, A ; Sharif University of Technology
2013
Abstract
Ferrite-bainite-martensite triple phase (TP) microstructures with different volume fractions of martensite were obtained by changing heat treatment time during austempering at 300 C. Room temperature impact properties of TP steels with different martensite volume fractions (VM) were determined by means of Charpy impact testing. The effects of test temperature on impact properties were also investigated for two selected microstructures containing 0 (the DP steel) and 8.5 vol.% martensite. Test results showed reduction in toughness with increasing VM in TP steels. Fracture toughness values for the DP and TP steels with 8.5 vol.% martensite were obtained from correlation between fracture...
Evolution of microstructure and mechanical properties of Al-5 wt% Ti composite fabricated by P/M and hot extrusion: effect of heat treatment
, Article Materials Science and Engineering A ; Volume 689 , 2017 , Pages 166-175 ; 09215093 (ISSN) ; Madaah Hosseini, H. R ; Sharif University of Technology
Abstract
An Al-5 wt% Ti composite was fabricated via powder metallurgy and hot extrusion from initial pure Al and Ti powders. The effect of subsequent heat treatment at 600 °C for different time intervals on microstructure and mechanical properties was investigated. XRD and EDS analyses showed the in-situ formation of Al3Ti intermetallic. SEM micrographs demonstrated the formation of core-shell structured particles in Al matrix for composites heat treated up to moderate heating times (4 h). Generation of voids and pores in the heat treated composites was considered as a result of the Kirkendall effect. Mechanical properties of composites were studied by hardness and tensile testing methods at room...