Loading...
Search for: hydrogen-gas-sensing
0.005 seconds

    Decorated CNT based on porous silicon for hydrogen gas sensing at room temperature

    , Article RSC Advances ; Volume 6, Issue 50 , 2016 , Pages 44410-44414 ; 20462069 (ISSN) Ghorbani Shiraz, H ; Razi Astaraei, F ; Fardindoost, S ; Hosseini, Z. S ; Sharif University of Technology
    Royal Society of Chemistry  2016
    Abstract
    A new triple-component sensor for detection of H2 was developed based on porous silicon and CNTs. An increase in deposition of CVD catalysis was shown to promote a high and fast response. Also, it was shown that the composite system exhibited good selectivity  

    Fabrication of Pd doped WO3 nanofiber as hydrogen sensor

    , Article Polymers ; Volume 5, Issue 1 , 2013 , Pages 45-55 ; 20734360 (ISSN) Nikfarjam, A ; Fardindoost, S ; Zad, A. I ; Sharif University of Technology
    2013
    Abstract
    Pd doped WO3 fibers were synthesized by electro-spinning. The sol gel method was employed to prepare peroxopolytungstic acid (P-PTA). Palladium chloride and Polyvinyl pyrrolidone (PVP) was dissolved in the sol Pd:WO3 = 10% molar ratio. The prepared sol was loaded into a syringe connected to a high voltage of 18.3 kV and electrospun fibers were collected on the alumina substrates. Scanning electron microscope (SEM), X-ray powder diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) techniques were used to analyze the crystal structure and chemical composition of the fibers after heat treatment at 500 °C. Resistance-sensing measurements exhibited a sensitivity of about 30 at 500 ppm... 

    Hybrid multiwalled carbon nanotubes and trioxide tungsten nanoparticles for hydrogen gas sensing

    , Article Journal of Physics D: Applied Physics ; Volume 42, Issue 16 , 2009 ; 00223727 (ISSN) Ghasempour, R ; Iraji zad, A ; Sharif University of Technology
    2009
    Abstract
    The WO3/multiwalled carbon nanotubes (MWNTs) hybrid films were fabricated by spin-coating on an alumina substrate. The structure, morphology, chemical composition and quality of the as-prepared WO3 nanoparticles, functionalized MWNTs and WO3/MWNTs hybrid films were studied by SEM, TEM, XRD, XPS, DLS and Raman spectroscopy methods. Results show that WO3 nanoparticles were nucleated on oxygenated functionalized MWNTs in hybrid suspension. After coating and annealing the films at 350 °C, the hybrid WO3/MWNTs films present rather linear gas sensitivity as a function of hydrogen concentrations at 300 °C. Results are discussed based on surface increase as well as development of two types of... 

    The decoration of TiO2/reduced graphene oxide by Pd and Pt nanoparticles for hydrogen gas sensing

    , Article International Journal of Hydrogen Energy ; Volume 37, Issue 20 , 2012 , Pages 15423-15432 ; 03603199 (ISSN) Esfandiar, A ; Ghasemi, S ; Irajizad, A ; Akhavan, O ; Gholami, M. R ; Sharif University of Technology
    Elsevier  2012
    Abstract
    Reduced graphene oxide (RGO) was used to improve the hydrogen sensing properties of Pd and Pt-decorated TiO2 nanoparticles by facile production routes. The TiO2 nanoparticles were synthesized by sol-gel method and coupled on GO sheets via a photoreduction process. The Pd or Pt nanoparticles were decorated on the TiO2/RGO hybrid structures by chemical reduction. X-ray photoelectron spectroscopy demonstrated that GO reduction is done by the TiO2 nanoparticles and Ti-C bonds are formed between the TiO2 and the RGO sheets as well. Gas sensing was studied with different concentrations of hydrogen ranging from 100 to 10,000 ppm at various temperatures. High sensitivity (92%) and fast response time...