Sharif Digital Repository

In this study the effect of HPGR operational parameters on the dimensional properties of pellet feed was examined and optimized using factorial methodology. The operational parameters considered include feed moisture, specific pressure and roll speed. For this study, size and shape of particles with Blaine number in the range 1800–2200 cm2 g−1 was thoroughly investigated. It was deduced that increasing the specific pressure and decreasing the roll speed would result in reduction of D80 but would increase the Blaine number. The circularity, aspect ratio and roughness descriptors of the particles were measured by SEM micrographs and image analysis software. It was observed that particles... 

In this study the effect of HPGR operational parameters on the dimensional properties of pellet feed was examined and optimized using factorial methodology. The operational parameters considered include feed moisture, specific pressure and roll speed. For this study, size and shape of particles with Blaine number in the range 1800–2200 cm2g−1 was thoroughly investigated. It was deduced that increasing the specific pressure and decreasing the roll speed would result in reduction of D80 but would increase the Blaine number. The circularity, aspect ratio and roughness descriptors of the particles were measured by SEM micrographs and image analysis software. It was observed that particles tended... 

Gas porosities and Fe-rich phases and entrapped double oxide films (hereafter: oxides) are known to be the most detrimental defects in cast Al-Si-Mg alloys. The effects of H (gas porosities) and Fe (Β-Al5FeSi phase) on reproducibility of tensile properties in Al-7Si-0.35Mg alloy have been investigated in this study. Four different casting conditions (Low H-Low Fe, Low H-High Fe, High H-Low Fe and High H-High Fe) were studied. In each case, 30 tensile test samples were prepared by casting in a metallic mold and machining (total of 120 tensile test samples). Results of tensile test were analyzed by Weibull three-parameter analyses. The microstructures of samples were studied by optical... 

Double oxide films (hereafter: oxides), inclusions and Fe-rich phases are known to be the most detrimental defects in cast Al-Si-Mg alloys. The effects of these defects on reproducibility of tensile properties in Al-7Si-0.35Mg alloy have been investigated in this study. Four different casting conditions (low oxide-low Fe, high oxide-low Fe, low oxide-high Fe and high oxide-high Fe) were studied. In each case, 30 tensile test samples were prepared by casting in a metallic mold and machining (total of 120 tensile test samples). Results of tensile test were analyzed by Weibull three-parameter and mixture analyses. The microstructure and fracture surface of samples were studied by optical and... 

The effects of real and Gleeble simulated double pass thermal cycles on the properties of the intercritically reheated coarse grained heat affected zones in X80 microalloyed pipeline steel has been investigated. The Gleeble simulated process involved heating the X80 steel specimens to the first peak temperature of 1400°C and then reheating to the second peak temperature of 800°C, with different cooling rates. The size and area fraction of martensite/austenite (M/A) constituents were obtained by a combination of field emission scanning electron microscopes and image analysis software. In addition, misorientation was characterized by electron back-scatter diffraction analysis. It is clear that...