Sharif Digital Repository

The present study investigates the turbulence characteristic of turbidity current experimentally. The three-dimensional Acoustic-Doppler Velocimeter (ADV) was used to measure the instantaneous velocity and characteristics of the turbulent flow. The experiments were conducted in a three-dimensional channel for different discharge flows, concentrations, and bed slopes. Results are expressed at various distances from the inlet, for all flow rates, slopes and concentrations as the distribution of turbulence energy, Reynolds stress and the turbulent intensity. It was concluded that the maximum turbulence intensity happens in both the interface and near the wall. Also, it was observed that the... 

The resonant interaction of surface and internal waves produces a nonlinear mechanism for energy transfer among wave components in oceans, lakes, and estuaries. In many field situations, the stratification may be well approximated by a two-layer fluid with a diffuse interface. The growth and damping rates of sub-harmonic interfacial waves generated by a surface wave through a three-wave resonant interaction are measured in the laboratory. These measurements are compared with theoretical predictions. A diffuse interface reduces the damping rate and increases the growth rate. The predicted growth rate provides excellent comparison with the laboratory measurements. The inclusion of the effects... 

Accurate knowledge of pure hydrocarbon and natural gas viscosity is essential for reliable reservoir characterization and simulation as well as economic design of natural gas processing and transport units. The most trustable sources of pure hydrocarbon and natural gas viscosity values are laboratory experiments. When there is no available experimental data for the required composition, pressure, and temperature conditions, the use of predictive methods becomes important. In this communication, a novel approach was proposed to develop for prediction of viscosity of pure hydrocarbons as well as gas mixtures containing heavy hydrocarbon components and impurities such as carbon dioxide,... 

To avoid saturation of a protective current transformer (CT) operating under an autoreclosing scheme, the CT size should be chosen much higher than a similar CT operating under a single-step fault clearing scheme. The main reason for this significant difference is that the residual flux (caused by the first stage of the fault) cannot be noticeably reduced during the deadtime interval of the reclosing process and, therefore, the occurrence of a subsequent fault can extremely saturate the CT. In this paper, a low-cost, low-power electronic device is developed and introduced to demagnetize the CT under the reclosing deadtime interval. It will be shown that by using this device, the required... 

The dynamo effect is a class of macroscopic phenomena responsible for generating and maintaining magnetic fields in astrophysical bodies. It hinges on the hydrodynamic three-dimensional motion of conducting gases and plasmas that achieve high hydrodynamic and/or magnetic Reynolds numbers due to the large length scales involved. The existing laboratory experiments modeling dynamos are challenging and involve large apparatuses containing conducting fluids subject to fast helical flows. Here we propose that electronic solid-state materials - in particular, hydrodynamic metals - may serve as an alternative platform to observe some aspects of the dynamo effect. Motivated by recent experimental... 

In this paper, a new approach toward material detection and classification, based on the spectral analysis of millimeter-wave images, using machine learning technique is proposed. The focus of this paper is to detect concealed dangerous materials. It is shown that by using adequate number of training data captured from different materials of interest, the trained machine could detect concealed dangerous materials with an acceptable accuracy. The training phase is performed with materials of varying thickness, shape, background, covering layers and distance. The training data is collected with laboratory experiments in the frequency range of 27-31 GHz with 51 frequency samples. The results... 

To improve the thermal stability of starch in water-based drilling fluid, monoethanolamine (MEA) was added, and the effect was investigated by laboratory experiment. The experimental results show that the addition of monoethanolamine (MEA) increases the apparent viscosity, plastic viscosity, dynamic shear force, and static shear force of the drilling fluid, and reduces the filtration rate of drilling fluid and thickness of mud cake apparently. By creating hydrogen bonds with starch polymer, the monoethanolamine can prevent hydrolysis of starch at high temperature. Starch, as a natural polymer, is able to improve the rheological properties and reduce filtration of drilling fluid, but it works... 

The compressive strength of mass concrete in dams is obtained from laboratory experiments of various cylindrical specimens with diameters of 150, 250, and 300 mm, and heights of 300, 500, and 450 mm, respectively. These specimens with 37.5, 75, and 150 mm maximum size of aggregate were investigated. The 7- and 90-day compressive strength of concrete was found to be between 20 and 58 MPa depending on the size of the specimens. The results reveal the existence of a significant size effect. Based on test results, relationships between the strength of mass concrete specimens and their size and shape are developed. Finally, results and a discussion are presented regarding compressive strength... 

This research evaluates the effect of filler type and content on rutting resistance of asphaltic materials by using laboratory experiments. To examine the effect of filler type, two traditional fillers (Silica sandstone powder and Portland cement) and a new recycled lime powder (Eggshell) were considered. To investigate the effect of filler content, three different filler contents were used. Marshall Stability test was performed on full mixes in order to determine the optimum binder content of the mixtures. Then, the static creep test was performed on Fine Aggregate Matrix (FAM) samples. The permanent strain after 10 minutes of recovery (PS-660) was considered as the indicator of potential... 

Dilute Surfactant flooding has been recognized as one of the significant processes in chemical flooding. Many oil reservoirs became appropriate candidates for surfactant/water flooding when screening criteria was developed. Injected surfactant tried to mobilize the residual oil that was trapped in interstice. The main contributing mechanism to enhance oil recovery by surfactant flooding was defined as rock wettability alteration. Wettability is one of the substantial parameters to choose the best approach for a successful surfactant flooding in which tiny change in wettability will lead to improve oil recovery fundamentally. In this experimental study the effect of different aging time and... 

Time of concentration (TC) of surface flow in watersheds depends on the coupled response of hillslopes and stream networks. The important point in this background is to study the effects of the geometry and the shape of complex hillslopes on the time of concentration considering the degree of flow convergence (convergent, parallel or divergent) as well as the profile curvature (concave, straight or convex). In this research, the shape factor of complex hillslopes as introduced by Agnese et al. (2007) is generalized and linked to the TC. A new model for calculating TC of complex hillslopes is presented, which depends on the plan shape, the type and degree of profile curvature, the Manning... 

Compressibility factor (z-factor) values of natural gasses are essential in most petroleum and chemical engineering calculations. The most common sources of z-factor values are laboratory experiments, empirical correlations and equations of state methods. Necessity arises when there is no available experimental data for the required composition, pressure and temperature conditions. Introduced here is a technique to predict z-factor values of natural gasses, sour reservoir gasses and pure substances. In this communication, a novel mathematical-based approach was proposed to develop reliable model for prediction of compressibility factor of sour and natural gas. A robust soft computing... 

The hydraulic efficiency of sedimentation basins is reduced by short-circuiting, circulation zones and bottom particleladen jets. Baffles are used to improve the sediment tank performance. In this study, laboratory experiments were used to examine the hydrodynamics of several baffle configurations. An accompanying numerical analysis was performed based on the 2-D Reynolds-averaged Navier-Stokes equations along with the k-ε turbulence closure model. The numerical model was supplemented with the volume-of-fluid technique, and the advection-diffusion equation to simulate the dynamics of particle-laden flow. Model predictions compared well with the experimental data. An empirical function was... 

The structure of turbidity currents released on a sloping bed below fresh water is investigated. Kaolin is used as a suspended material. Laboratory observations indicate that if a dense layer moves through the channel, the current thickness increases due to a hydraulic jump. This phenomenon occurs under special inlet conditions and has a significant effect on the current structure including velocity profile, current height and bed shear stress. Flows with different inlet Froude numbers based on various inlet concentrations behave more distinctly than those based on different inlet opening heights. Laboratory experiments indicate that an increase in the inlet Froude number causes an increase... 

A lot of laboratory experiments have been carried out to investigate each aspect of ultrasonic wave s role on fluid flow behavior through porous media. Despite all experimental works, little attention has been paid for modeling the ultrasonic wave influence on capillary imbibition, which is the main mechanism of production in fractured reservoirs. At this work the process of imbibition with and without applying ultrasonic waves is mathematically modeled by modification of piston-like model. In contrast to this model s assumption, in which mobility ratio is assumed to be constant, here permeability variation due to increase in water saturation is considered in numerical solution. To evaluate... 

Current-transformer (CT) saturation causes severe distortion in the measured current waveform which may lead to maloperation of the protective devices. This paper proposes a low-cost, power-electronic device to prevent the CT from saturation. The proposed compensator is inserted in series with the relay in the CT secondary circuit and acts as a controlled voltage source (CVS). The proposed CVS generates a time-varying voltage to cancel the voltage developed across the CT burden; therefore, the CT magnetic flux remains almost constant and undistorted during the power system transients. It will be shown that this device can precisely compensate fault current, inrush current, and other probable... 

Cyclic loading on asphalt concrete materials with a longer relaxation time and lower remaining stress lead to higher viscoelastic strain recovery. Consequently, more aggregate reorientation occurs and the rate of viscoplastic strain increases in subsequent cycles. The present study proposes a hardening relaxation constitutive relationship (fHR) as a function of accumulated recovered viscoelastic strain εrve based on experimental observation. This model captures the initiation and evolution of hardening-relaxation during the relaxation time and/or stress reduction under cyclic loading. The model was then coupled with viscoelastic, viscoplastic and viscodamage constitutive relationships. The... 

Turbidity currents are often the main processes of sediment transport in deep waters and reservoirs. To prevent sedimentation in critical locations, various methods, such as placing solid obstacles in the path of these flows, have been proposed. In the present study, the effect of inlet concentration on the behavior of turbidity currents in the presence of two consecutive triangular obstacles was investigated experimentally. For this purpose, a series of laboratory experiments were conducted with various inlet concentrations. In each experiment, velocity and concentration profiles were measured using an acoustic Doppler velocimeter. The velocity of the current head and local Froude number... 

One of the key open questions in the area of low or controlled salinity water flooding (LSWF or CSWF) is how the observed oil recovery at macro-scale (e.g. Darcy or core-scale) can the explained and what underlying microscopic mechanisms drive it. Thus far, the micromodel investigation of LSWF has been limited to sandstones, remaining challenging to apply to carbonates. In this paper we aim to i) extend the capability to fabricate a novel calcite micromodel using Iceland spar calcite crystal, ii) investigate the pore-scale mechanisms leading to oil recovery from carbonates. A target crude oil-brine-rock (COBR) system was first selected. To screen potential brines which can produce... 

Hydraulic fracturing is a widely used and efficient technique for enhancing oil extraction from heavy oil sands deposits. Application of this technique has been extended from cemented rocks to uncemented materials, such as oil sands. Models, which have originally been developed for analyzing hydraulic fracturing in rocks, are in general not satisfactory for oil sands. This is due to a high leak-off in oil sands, which causes the mechanism of hydraulic fracturing to be different from that for rocks. A thermal hydro-mechanical fracture finite element model is developed, which is able to simulate hydraulic fracturing under isothermal and non-isothermal conditions. Plane strain or axisymmetric...