Sharif Digital Repository

In this paper, a new 1/4 rate clock linear phase detector (PD) structure for PLL-based clock and data recovery (CDR) circuits will be suggested. The proposed topology offers a more suitable PD for high speed applications compared to the conventional topologies. The effect of duty cycle variation on the operation of CDR has been also studied. Designed in a 0.18μm CMOS technology, the proposed PD consumes 16mA from a 1.8V voltage supply. © 2006 IEEE  

A high-Q, tunable, bandpass filtered amplifier structure is proposed which is based on a novel Q enhancement technique in N-path filters. Using Fourier series analysis, frequency response of an N-path filter as well as the aliasing effects which are present in it are derived. Frequency translation of unwanted contents at higher frequencies to the center frequency of the bandpass filter is called harmonic fold back (HFB). It is shown that using an additional N-path filter with the same clock frequency but different clock phases can reduce the HFB. The required conditions for fold back elimination are derived fromFourier series expansion analysis. In order to achieve HFB reduction as well as... 

Thermal noise is one of the most important challenges in analogue integrated circuits design. This problem is more crucial in switched-capacitor (SC) filters due to the aliasing effect of wide-band thermal noise. In this article, a new simple method is proposed for estimating the power spectrum density of output thermal noise in SC filters, which have acceptable accuracy and short running time. In the proposed method, first using HSPICE simulator, accurate value of accumulated sampled noise on sampler capacitors in each clock state is achieved. Next, using difference equations of the SC filter, frequency response of the SC filter is shaped by time domain analysis. Based on the proposed... 

An innovative vector-sum phase shifter with a full 360° variable phase-shift range in 0.18-μm CMOS technology is proposed and experimentally demonstrated in this paper. It employs an I/Q network with high I/Q accuracy over a wide bandwidth to generate two quadrature basis vector differential signals. The fabricated chip operates in the 2.3-4.8 GHz range. The root-mean-square gain error and phase error are less than 1.1 dB and 1.4° over the measured frequency span, respectively. The total current consumption is 10.6 mA (phase shifter core: ∼2.6 mA) from a 1.8 V supply voltage and overall chip size is 0.87 × 0.75 mm 2. To the best of the authors' knowledge, this circuit is the first... 

This article explores the main tradeoffs in design of power and area efficient bandgap voltage reference (BGR) circuits. A structural design methodology for optimizing the silicon area and power dissipation of CMOS BGRs will be introduced. For this purpose, basic equations of the bandgap circuit have been adapted such that can simply be applied in the optimization process. To improve the reliability of the designed circuit, the effect of amplifier offset has been also included in the optimization process. It is also shown that the minimum achievable power consumption and area are highly depending on the fabrication process parameters especially sheet resistivity of the available resistors in... 

A Bandgap circuit capable of generating a reference voltage of less than 1 V with high PSRR and low temperature sensitivity is proposed. High PSRR achieved by means of an improved current mode regulator which isolates the bandgap voltage from the variations and the noise of the power supply. A vigorous analytical approach is presented to provide a universal design guideline. The analysis unveils the sensitivity of the circuit characteristic to device parameters. The proposed circuit is fabricated in a 0.18μm CMOS technology and operates down to a supply voltage of 1.2 V. The circuit yields 20 ppm/°C of temperature coefficient in typical case and 50 ppm/°C of temperature coefficient in worst...