Sharif Digital Repository

Increasing the permeability of hydrocarbon reservoirs by creating artificial cracks that are induced by injection of fluids under high pressure is called hydraulic fracturing (HF). This method is widely used in petroleum reservoir engineering. For design of Hydraulic Fracture operations, several analytical models have been developed. KGD and PKN are the first and most used analytical models in this area. Although number of advanced softwares are developed in recent years, KGD and PKN models are still popular and have even been used in a number of softwares. In both models the characteristics of the fracture namely: fracture length (L), fracture width (w), and fluid pressure at the crack... 

For a low-permeability carbonate formation, the acid fracture process is simulated through coupling a commercial acid fracture simulator (GOHFER) to a finite volume reservoir simulator (IMEX). Unlike LGR (Local grid refinement) approach that suffers from severe convergence problems, a dynamic up-scaling procedure is employed to convert the discrete fracture network (DFN) model into a dual continuum model for our simulation. In this paper, multiple simulations are used to optimize the acid fracture schedule parameters, such as fluid volume, flow rate, perforation location, number of injection steps, and acid type, in order to maximize the effective fracture length. For four points perforation... 

The effect of an efficient biosurfactant produced from Pseudomonas aeroginosa MR01, a bacterial strain isolated from oil excavation areas in southern Iran, on the recovery of residual oil trapped within carbonate rocks, was investigated. In a core holder set-up, bearing a number of limestone-and dolomite-containing core samples, biosurfactant flooding resulted in oil recoveries as large as 20% to 28% Residual Oil (R.O). Biosurfactant injection in less permeable rocks in a range of 0.5 to 32 md was more successful, in terms of oil production. In the case of the least oil recovery via biosurfactant flooding, incubation of the core with a biosurfactant solution at reservoir conditions,... 

In this paper, different injectivity scenarios were experimentally investigated in a coreflooding system to observe the efficiency of each method in laboratory conditions. Surfactant flooding, CO2 injection, carbonated water injection (CWI), active carbonated water injection (ACWI), after water flooding were investigated through the coreflooding system. First, it is necessary to optimize the surfactant concentration and then use it in ACWI injection. To do this, linear alkylbenzene sulfonic acid (LABSA) was used as a cationic surfactant at different concentrations. It was observed that 0.6 PV concentration of LABSA had an optimum result as increasing the surfactant concentration would not be... 

There are uncertainties in both inherent geological properties and IOR/EOR performance parameters of low permeability greenfield reservoirs. Therefore, efforts to reduce uncertainties in the appraisal phase are necessary for the development and production phases. An adequate selection of the appraisal area in the hydrocarbon field is an imperative factor since the results of the appraisal well drilling and IOR/EOR pilot tests will be utilized for the development of the entire field. The major challenge in selecting an appraisal area is the lack of an integrated and systematic approach. In this study, we present a novel systematic and quantitative approach consisting of a better... 

Accurate determination of relative permeability (kr) curves and their hysteresis is needed for reliable prediction of the performance of oil and gas reservoirs. A few options (e.g., Carlson, Killough and Jargon models) are available in commercial reservoir simulators to account for hysteresis in kr curves under two-phase flow. Two-phase kr curves are also needed for estimating kr hysteresis under three-phase flow during water-alternating-gas (WAG) injection. Although, most oil reservoirs are mixed-wet, the existing hysteresis predictive approaches have been developed based on water-wet conditions. Experimentally measured data are needed to assess the performance of these methodologies under...