Sharif Digital Repository

In this study, we numerically investigate the size effect of a bluff body, embedded inside a combustor, on the formation of carbonaceous nano-particulate matter (PM). The combustor is fed with a jet propulsion fuel. We first evaluate our extended numerical tool by simulating a turbulent kerosene/air nonpremixed flame in a combustor. The achieved results are then compared with those of experiment. The comparisons show that there are good agreements between them. Next, we embed an O-ring type flame holder inside the combustor to change its configuration, i.e., to extend it to a bluff-body burner. Assuming a constant air mass flow rate, we investigate the blockage ratio effects of the burner... 

There are many approaches to fabricate nanoparticles reinforced aluminum matrix composites. However, uniform distribution of nanoparticle within aluminum matrix remains a difficult challenge. In this study, a novel method is used by taking the advantages from squeeze casting of semi-solid aluminum slurry combined with electromagnetic field to refine the microstructure of the primary Al and eutectic Si phase, plus to obtain uniform distribution nano alumina particles in the aluminum matrix. It is noted that electromagnetic field plays an important role in the formation of non-dendritic primary α-Al particles and a great microstructure refinement occurs as a consequence of the pressure... 

A mathematical model was developed to describe the performance of nanoparticulate mixed oxide pseudocapacitors based on RuO 2-MO 2 (M being another suitable transition metal) under galvanostatic charge/discharge regime. Both double layer and faradaic processes were taken into account. The effects of the active material's particle size and composition were examined. Furthermore, the influence of discharge current on the extents of double layer and faradaic contributions was analyzed. The model analysis showed that the energy density declined upon increasing the volume fraction of larger particles. © 2008 Springer-Verlag  

Herein, we report a new strategy for improving the efficiency and reducing the fabrication cost of dye-sensitized solar cells (DSCs) by elimination of the three- or four-fold layer deposition of TiO2. This is performed by replacing a single layer deposition of mesoporous TiO2 beads, with sub-micrometer size, high surface area and tunable pore size, synthesized by a combination of sol-gel and solvothermal methods. Furthermore, superior electronic properties gained by a reduction in electronic trap states are achieved through doping of pristine TiO2 beads with lithium. The beads have a spherical shape with monodispersed texture consisting of anatase-TiO2 nanocrystals and ultra-fine pores. The...