Loading...
Search for:
neural-recordings
0.003 seconds
A 3-D inductive powering approach dedicated to implantable/wearable biomedical microsystems
, Article IEEE 2014 Biomedical Circuits and Systems Conference, BioCAS 2014 - Proceedings ; oct , 2014 , p. 424-427 ; Nasiri, S ; Mousavi, N ; Sharifkhani, M ; Sodagar, A. M ; Sharif University of Technology
Abstract
This paper proposes a new coil structure for inductive powering to wearable/implantable biomedical devices. This structure is virtually independent from the direction (and alignment) of the receiving coil relative to the transmitting coil. In addition to conducting experimental tests and characterizations, the proposed coil structure (energized by a transmitting coil) has been used to power up a real test system designed for wireless neural recording, operating at 1.2V and drawing 48 mW
Wireless interfacing to cortical neural recording implants using 4-FSK modulation scheme
, Article IEEE International Conference on Electronics, Circuits, and Systems, 6 December 2015 through 9 December 2015 ; Volume 2016 March , 2016 , Pages 221-224 ; 9781509002467 (ISBN) ; Judy, M ; Molaei, H ; Sodagar, A. M ; Sharifkhani, M ; Sharif University of Technology
Institute of Electrical and Electronics Engineers Inc
Abstract
This paper used a 4-level frequency shift keying (4-FSK) modulation scheme to enhance the density of wireless data transfer from implantable biomedical microsystems to the outside world. Modeling and simulation of the wireless channel for 4-FSK modulation in the case of a neural recording implant has been done. To realize the 4-FSK scheme, the modulator and demodulator circuits are proposed, designed and simulated in a 0.18-μm CMOS process, and in the 174-216 MHz frequency band at a data rate of 13.5 Mbps. Operated using a 1.8 V supply voltage, the modulator circuit consumes a power of 7.8 μW
Finite-element analysis of platinum-based cone microelectrodes for implantable neural recording
, Article 2009 4th International IEEE/EMBS Conference on Neural Engineering, NER '09, Antalya, 29 April 2009 through 2 May 2009 ; 2009 , Pages 395-398 ; 9781424420735 (ISBN) ; Frounchi, J ; Jahed, N ; Tinati, M. A ; National Institutes of Health, NIH; National Institute of Neurological Disorders and Stroke, NINDS; National Science Foundation, NSF ; Sharif University of Technology
2009
Abstract
There have been significant advances in fabrication of high-density microelectrode arrays using silicon micromachining technology in neural signal recording systems. The interface between microelectrodes and chemical environment brings great interest to researchers working on extracellular stimulation. This interface is quite complex and must be modeled carefully to match experimental results. Computer simulation is a method to increase the knowledge about these arrays and to this end the finite element method provides a strong environment for investigation of relative changes of the electrical field extension surrounding an electrode positioned in chemical environment. In this paper FEM...