Sharif Digital Repository

In order to predict the flow stress curves up to peak under the hot working conditions two crucially modified models are presented. The modification is done by considering the effects of both temperature and strain rate. Besides, the ability of prediction at very low strains is added to them. Furthermore a new mathematical model has been developed to estimate the stress-strain curves beyond the peak via a secant hyperbolic function. The predicted results are found to be in accord with empirical values  

Multi-floor facility layout problem concerns the arrangement of departments on the different floors. In this paper, a new mathematical model is proposed for multi-floor layout with unequal department area. Maximising the number of useful adjacencies among departments is considered as the objective function. The adjacencies are divided into two major categories: horizontal and vertical adjacencies. The horizontal adjacency may be occurred between the departments assigned to same floors while the vertical can be happened between departments assigned to any consecutive floors. A minimum common boundary length (surface area) between any two horizontal (vertical) adjacent departments is... 

Bubble point pressure is a crucial PVT parameter of reservoir fluids, which has a significant effect on oil field development strategies, reservoir evaluation and production calculations. This communication presents a new mathematical model to calculate the saturation pressures of crude oils as a function of temperature, hydrocarbon and non-hydrocarbon reservoir fluid compositions, and characteristics of the heptane-plus fraction. The model was developed and tested using a total set of 130 experimentally measured compositions and saturation pressures of crude oil samples from different geographical locations covering wide ranges of crude oil properties and reservoir temperatures. In-depth... 

In this paper we developed a new mathematical model for the flow inside cascade impactors and via this simplified model, we determined the particle size distribution by a fast and low cost computational method. Using cascade impactors for determining the particle size distribution, one can use comprehensive CFD methods to fully simulate the particle traces. Although the results from those CFD analyses can be very accurate, usually that is not a time and cost efficient routine. In contrast, we showed that by using our proposed calculation we can estimate the particle size distribution very fast and yet with the slight error -comparing to the results from CFD method. Cascade impactors are... 

A new mathematical model for the capacitated multi-facility location-allocation problem with probabilistic customers' locations and demands is developed in this article. The model is formulated into the frameworks of the expected value model (EVM) and the chance-constrained programming (CCP) based on two different distance measures. In order to solve the model, two hybrid intelligent algorithms are proposed, where the simplex algorithm and stochastic simulation are the bases for both algorithms. However, in the first algorithm, named SSGA, a special type of genetic algorithm is combined and in the second, SSVDO, a vibration-damping optimisation (VDO) algorithm is united. The Taguchi method... 

This work is concerned with the role of geometrical properties of fractures on oil displacement efficiency during solvent injection to heavy oil. Here, a series of solvent injection processes were conducted on one-quarter five-spot fractured micromodels that were initially saturated with the heavy oil, at a fixed flow rate condition. The oil recovery was measured using image analysis of the continuously provided pictures. The results show that for the range of experiments performed here, the maximum oil recovery happens at a fracture orientation angle of 45 degrees. Also, increasing the number of fractures leads to a higher oil recovery factor by solvent in 45 degrees, while it does not... 

The paper aims at proposing a controller through two-layer neural networks (NN) in order to control CD4 amount in HIV + Patients. In the same direction, initially a new mathematical model by using of two-layer neural networks (NN) was designed. Medical information of 300 HIV + Patients who were being treated in the Iranian Research Center for HIV/AIDS (IRCHA), Imam Khomeini Hospital, Tehran, was used to design this model. Highly active antiretroviral therapy (HAART) medical method is a significant method that was used in this study. It is worthy to say that CD4 amount declining leads to immune system deficiency and it is considered as one of AIDS main symptoms. Output of this mathematic... 

Geologic sequestration of CO2 in deep saline aquifers is becoming increasingly important as a method with the greatest potential to economically sequester large volumes of anthropogenic CO2. The interfacial tension (IFT) between the formation brine in the aquifer and the injected CO2 phase has a significant influence on the displacement, and its precise determination is essential for accurate modeling and evaluation of such a process. This paper presents two new mathematical models to calculate the brine/CO2 IFT. The two models differ in input parameters; pressure, temperature, and salinity for the first model, and pressure, temperature, and brine composition for the second one. The proposed... 

This paper developed a new mathematical model to investigate the heat transfer as well as wick's thickness of a heat pipe. The model was established by conservative equations of continuity, momentum, and energy in the thermal boundary layer. Using a similarity variable, the governing equations were changed to a set of ordinary differential equations and were solved numerically by the forth-order Runge-Kutta method. The flow variables, such as velocity components, wick's thickness, and Nusselt number, were obtained. The results show that the Nusselt number is proportional to the square root of the Darcy-modified Rayleigh number and to the distance from the edge of the condenser surface.... 

Bioactive glass has been used clinically in bone repair applications for bone grafting because of its prominent physiochemical and osteogenic properties. Various attempts have been made to enhance bioactive glass efficiency in combination with other biomaterials such as antibiotics and growth factors. In present study, we developed a modification of bioactive glass nanoparticles that insured long term antibacterial effect. Bioactive glass nanoparticles (BGNs) were functionalized with (3-Aminopropyl) triethoxysilane (APTS), then vancomycin (VAN) was immobilized onto BGNs-APTS via EDC/NHS cross-linking process. Another study group namely BGNs-VAN was synthesized as a control group without any... 

This work studies the natural frequencies and modes of liquid sloshing in a rectangular 3D tank with the slotted baffles in middle. A new vibrational model incorporating the pressure difference between the two sides of the baffle, using a transmission function in Laplace space is presented. To this end, a part of the baffle that includes the wall and the slot is modeled in Fluent software, to express this pressure difference as a function of the fluid velocity passing through the baffle. Then, using the boundary element method, and boundary conditions, the equations of the fluid domain are developed. In this research, the rigid baffle is surrounded by a three-dimensional irrotational...