Sharif Digital Repository

In this paper, a diverse range of routing algorithms is classified into a new family of routings called zone-ordered label-based routing algorithms. The proposed classification is based on three common steps (factors) for generating such routings, namely, graph labeling, deadlock-free zones, and zone ordering. The main goal of this classification is to define several new routing concepts and streamline the knowledge on routing algorithms. Following the classification, a novel methodology is proposed to generate routing algorithms for irregular networks. The methodology uses the three mentioned steps to generate deadlock-free routings. Consequently, the methodology-based routings fall into... 

In this paper, a diverse range of routing algorithms is classified into a new family of routings called zone-ordered label-based routing algorithms. The proposed classification is based on three common steps (factors) for generating such routings, namely, graph labeling, deadlock-free zones, and zone ordering. The main goal of this classification is to define several new routing concepts and streamline the knowledge on routing algorithms. Following the classification, a novel methodology is proposed to generate routing algorithms for irregular networks. The methodology uses the three mentioned steps to generate deadlock-free routings. Consequently, the methodology-based routings fall into... 

This paper introduces a novel methodology for design and assessment of offshore structures exposed to irregular sea waves. For this, Constrained NewWave (CNW) is integrated with the Endurance Time Analysis (ETA) methodology, which is basically developed for the performance based analysis of onshore structures to earthquake loads. In this approach, the offshore structure is simulated in time-domain under a set of calibrated intensifying wave functions. They are devised to represent a gradually increasing roughness of the sea state by time. A performance index such as base shear, drift or stress in a critical structural members are monitored until they reach to a predefined maximum value. A... 

Medical applications of rapid prototyping have an increasing trend, making the future of RP more and more promising. These applications may include design, development, and manufacture of medical devices and instrumentation, as well as implant design, anatomical modeling, surgical planning, surgical implants, and prosthesis fabrication. This paper provides a new methodology for customized hip prosthesis that could provide high accuracy of femoral canal reconstruction via 3D modeling of prosthesis stem, 3D modeling of prosthesis neck, and facilitating the communication between the designer and surgeon. Combining RP technologies and rapid tooling with this novel custom-made hip prosthesis,... 

Ejector refrigeration system has many advantages over traditional compressor-based systems, including: simplicity, low installation and operating costs and the ability to operate with low-grade thermal energy sources. However, its main drawbacks are low Coefficient of Performance (COP) and failure at high ambient temperatures. To overcome these problems, a novel methodology for designing a multi-ejector refrigeration system is proposed. This system utilizes a parallel array of ejectors instead of one ejector. Therefore, the system can continuously operate at its optimum efficiency. Each ejector works within a specific range of condensing pressures. The condenser pressure governs the... 

Frequency control during power system restoration has not been strongly addressed. Operators are often concerned with the offline sizing of load and generation steps, but, nowadays, the introduction of Wide Area Measurement System (WAMS) makes it possible to monitor the stability of power system online. The constraints of WAMS operation result in some changes in power system frequency control. This paper proposes a novel methodology for frequency control and monitoring during the early steps of power system restoration based on WAMS. Detailed load modeling is achieved based on the static load modeling approach. Power generators' modeling is also accomplished utilizing the single machine...