Loading...
Search for: oil-contents
0.005 seconds

    The effect of temperature and impeller speed on mechanically Induced Gas Flotation (IGF) performance in separation of Oil from oilfield-produced water

    , Article Petroleum Science and Technology ; Volume 28, Issue 14 , 2010 , Pages 1415-1426 ; 10916466 (ISSN) Mastouri, R ; Borghei, S. M ; Nadim, F ; Roayaei, E ; Sharif University of Technology
    2010
    Abstract
    The effect of temperature and impeller speed on the performance of induced gas flotation (IGF) systems for the removal of oil from produced water in different ranges (5-300 g/L) of total dissolved solids (TDS) was investigated in a pilot plant study. Furthermore, it was evaluated whether the IGF pilot plant effluent could reach the 15 mg/L outlet oil content as required by Article VI of the Kuwait Convention for Persian Gulf region, before being discharged to the sea. The results showed that oil removal efficiencies up to 90% could be reached at high temperature (80°C) in just one single flotation cell without adding any chemicals. Flotation unit, however, should be followed by at least one... 

    Effective factors in the treatment of kerosene-water emulsion by using UF membranes

    , Article Journal of Hazardous Materials ; Volume 161, Issue 2-3 , 2009 , Pages 1216-1224 ; 03043894 (ISSN) Rezvanpour, A ; Roostaazad, R ; Hesampour, M ; Nyström, M ; Ghotbi, C ; Sharif University of Technology
    2009
    Abstract
    The effects of different parameters including membrane type (regenerated cellulose and polysulphone), transmembrane pressure (TMP), the content of oil in the feed, the flow velocity of the feed and pH on the ultrafiltration of an emulsion of kerosene in water were studied. It was found that the important factors affecting ultrafiltration were, in order, membrane type, pressure and oil concentration. The greatest flux at the optimum conditions here of 3 bar, an oil content of 3% (v/v) and with membrane type C30F was predicted as 108 L/(m2 h) that was within the range of the confidence limit of the measured value of 106 L/(m2 h). The normalised FTIR results of the virgin cellulosic membranes...