Loading...
Search for:
output-power-and-efficiencies
0.007 seconds
Wide-band high-efficiency Ku-band power amplifier
, Article IET Circuits, Devices and Systems ; Vol. 8, issue. 6 , December , 2014 , p. 583-592 ; 1751858X ; Medi, A ; Sharif University of Technology
Abstract
A 37 dBm power amplifier (PA) is designed on a 0.25 μm optical T-gate pseudomorphic high electron mobility transistor (pHEMT) technology. The design of this two-stage PA along with a step-by-step design procedure is presented in this paper. This methodology can be used for design of PA in different technologies and frequencies. The PA delivers 5 W output power over the frequency band of 13-19 GHz. It shows average power-added efficiency of 37% and large signal gain of 15 dB in measurements which is consistent with simulation results. The output power and efficiency of the realised amplifier reach maximums of 37.6 dBm and 45%, respectively. Considering output power, bandwidth, chip area and...
Energy and exergy analysis of a gas turbine power plant with inlet evaporating cooling systems
, Article 23rd International Conference on Efficiency, Cost, Optimization, Simulation, and Environmental Impact of Energy Systems, 14 June 2010 through 17 June 2010 ; Volume 4 , 2010 , Pages 203-210 ; 9781456303181 (ISBN) ; Karimi, M ; Ahmadi, P ; Ecole Polytechnique Federale de Lausanne; Schweizerische Eidgenossenschaft ; Sharif University of Technology
Aabo Akademi University
Abstract
The gas turbine (GT) is known to feature low capital cost to power ratio, high flexibility, high reliability without complexity, short delivery time, early commissioning and commercial operation and fast starting-accelerating. Hence, researchers all over the world are working to increase the output power and efficiency of gas turbine cycle. One of the important techniques to increase the output power of such cycles is the compressor inlet air cooling method. The objective of this paper is to analysis the gas turbine cycle from both energy and exergy point of view. Thus, two important methods for increasing the output power, i.e. fog and media inlet air cooling systems are discussed....
Computational study on design parameters of a solar chimney
, Article International Conference on Sustainable Mobility Applications, Renewables and Technology, 23 November 2015 through 25 November 2015 ; 2015 ; 9781467395298 (ISBN) ; Raveshi, S ; Shahsavari, M ; Sedaghat, A ; Sharif University of Technology
Institute of Electrical and Electronics Engineers Inc
Abstract
Today, the production of energy and electricity is one of the major concerns of mankind. Electricity generation by solar energy is considered as one of the alternatives to fossil fuels. Solar chimneys mechanism is based on a natural phenomenon. In this process the solar energy heat up the earth's surface and the surrounding air. Due to the density difference between cold air and warm air, heated air ascends and causes air circulation. In this study, mathematical modelling of solar chimney and governing equations of this system will be discussed. In order to validate the numerical results, upwind velocity in chimney has been compared with a reliable reference results. As well as, the...