Sharif Digital Repository

Natural ventilation has been used to increase indoor air quality, remove pollutants, and remove heat absorbed in the building structure. Some architectural features such as wind-catcher systems are used to induce airflow into buildings, and openings equipped with louvers are employed to reduce solar daylight while allowing natural ventilation. Earlier studies on ventilated louvers and wind-catchers have shown the impact of the louvers’ opening positions and slat angles. However, their combination with each other has been less studied. This paper presents CFD simulations of cross-ventilation in a generic isolated building integrated with a one-sided roof-top wind-catcher and the outlet... 

Noise analysis techniques including Feynman-α (variance-to-mean) and Rossi-α (correlation) have been simulated by MCNP computer code to calculate the prompt neutron decay constant (α0), effective delayed neutron fraction (βeff) and neutron generation time (Λ) in a subcritical condition for the first operating core configuration of Tehran Research Reactor (TRR). The reactor core is considered to be in zero power (reactor power is less than 1 W) in the entire simulation process. The effect of some key parameters such as detector efficiency, detector position and its dead time on the results of simulation has been discussed as well. The results of proposed method in the current study are... 

Nowadays, applying sustainable development strategies in designation and production of various products has attracted specific attention. In order to consider ecological sustainable development for a product, reducing its environmental impacts should be observed. Concrete technology and its products are not exceptions, and therefore, the same has been a concern for concrete industry. Alongside, concrete recycling is one of the measures used to reduce the environmental impacts of concrete products during their life cycle. On the other side, positive performance of silica nano-particles has been proven in numerous researches as one super pozzolanic material. Hence, in this study, we aimed on... 

Al2O3-SiC composite ceramics were prepared by pressureless sintering with and without the addition of MgO, TiO2 and Y2O3 as sintering aids. The effects of these compositional variables on final density and hardness were investigated. In the present article at first α-Al2O3 and β-SiC nano powders have been synthesized by sol-gel method separately by using AlCl 3, TEOS and saccharose as precursors. Pressureless sintering was carried out in nitrogen atmosphere at 1600 °C and 1630 °C. The addition of 5 vol.% SiC to Al2O3 hindered densification. In contrast, the addition of nano MgO and nano TiO2 to Al 2O3-5 vol.% SiC composites improved densification but Y2O3 did not have positive effect on... 

In this article, two optical-fibre probes used in displacement measurements are reported. In one arrangement, two optical fibres with protective buffer jackets are placed together, while in the second arrangement, the protective buffer jackets are removed and the two fibres are placed with the claddings in contact, with a concomitant smaller centrecentre distance. As the core and cladding diameters are the same in both probes, the effect of the centrecentre distance on double-fibre designs can be investigated. The reflected output powers are recorded for the probes as a function of the axial distance from a reflective surface. A theoretical model is also implemented, which considers the... 

Quartz is usually detected as an impurity of kaolinite clays. The present work attempts to evaluate the role and behaviour of quartz particles in geopolymerisation and its probable effects on mechanical behaviour of geopolymeric products. Two kaolinite clays with different free quartz contents were used as raw materials to produce geopolymers. Results showed that using high content quartz kaolin causes higher compressive strength. Scanning electron microscopy studies confirmed that quartz does not participate in geopolymerisation and completely remains in the structure as fine particles. High hardness quartz particles by retarding crack growth in the geopolymer matrix enhance mechanical... 

A number of forced gravity drainage experiments have been conducted using a wide range of the physical and operational parameters, wherein the type, length, and permeability of the porous medium as well as oil viscosity and injection rate were varied. Results indicate that an increase in the Bond number has a positive effect on oil recovery whereas the capillary number has an opposite effect. These trends were observed over a two-order of magnitude change in the value of the dimensionless groups. Furthermore, it was found that use of each number alone is insufficient to obtain a satisfactory correlation with recovery. A combined dimensionless group is proposed, which combines the effect of... 

A series of wind tunnel tests were performed to study the effects of a canard and its position on the downstream flowfield over the wing surface. The wing surface pressure was measured for both canard-off and canard-on configurations. In addition, the canard position effects on the wing were investigated at different angles of attack. The canard was installed at three vertical positions and at two different horizontal distances from the wing apex. The results show a remarkable increase in the wing suction peak for the canard-on configurations. At low to moderate angles of attack, among the various configurations examined in the present experiments, the mid-canard configuration developed a... 

Enzymatic decolorization of reactive blue 221 (RB221) using laccase was investigated in a dual-chamber microbial fuel cell (MFC). Suspended laccase was used in the cathode chamber in the absence of any mediators in order to decolorize RB221 and also improve oxygen reduction reaction in the cathode. Molasses was utilized as low cost and high strength energy source in the anode chamber. The capability of MFC for simultaneous molasses and dye removal was investigated. A decolorization efficiency of 87% was achieved in the cathode chamber and 84% COD removal for molasses was observed in the anode chamber. Laccase could catalyze the removal of RB221 and had positive effect on MFC performance as... 

The effects of leachate recycling and bed mixing on the removal rate of H 2S from waste gas stream were investigated. The experimental setup consisted of an epoxy-coated three-section biofilter with an ID of 8cm and effective bed height of 120cm. Bed material consisted of municipal solid waste compost and PVC bits with an overall porosity of 54% and dry bulk density of 0.456gcm -3. Leachate recycling had a positive effect of increasing elimination capacity (EC) up to 21gSm -3 bedh -1 at recycling rates of 75mld -1, but in the bed mixing period EC declined to 8g Sm -3bedh -1. Pressure drop had a range of zero to 18mm H 2Om -1 in the course of leachate recycling. Accumulation of sulfur reduced...