Sharif Digital Repository

It is shown that the asymmetry coupling between two coupled optomechanical cavities leads to special class of PT-symmetric model for optomechanical structure. Under these conditions, Hamiltonian is considered in blue and red sideband regime. In these cases, the asymmetric coupling between two cavities has been transferred such that the asymmetric beam-splitter or squeezing interaction is generated between optical and mechanical modes. Then, the amount of entanglement between the different optical and mechanical modes is calculated. The results define that PT-symmetry can improve the entanglement in special conditions. The proposed system provides good condition to investigate the... 

A mathematical model for a fixed bed radial flow catalytic reactor was developed for dehydrogenation of heavy paraffins over Pt-Sn/Al2O3 catalyst. The model included appropriate kinetic rate expressions for the main dehydrogenation reaction as well as side reactions and catalyst deactivation. The reactor model consisted of a set of partial and ordinary as well as algebraic equations that were solved numerically to determine the concentration of various species along the radius of the bed as a function of time. The Nelder-Mead optimization method was used to obtain the optimum kinetic parameters. The validity of the model was demonstrated by comparing the predicted paraffin conversion and... 

The steam reforming of ethylene glycol, a simple model compound for biomass-derived liquids, is considered to be an environmentally green process for producing renewable hydrogen. Both Pt and Ni species are known for their catalytic activity under steam reforming reaction conditions. In this investigation, alumina supported Ni-Pt bimetallic catalysts (X wt% Ni-Y wt% Pt/Al2O3 named XNi-YPt) were employed for steam reforming of ethylene glycol. The prepared catalysts were characterized by XRD, BET, H2-TPR, H₂-Chemisorption, and TEM. It was observed that Ni/Pt ratio strongly affected the redox behavior, BET surface area, and particle size of the samples that in turn affected their catalytic... 

Decorating photocatalysts with noble metal nanoparticles (e.g., Pt) often increases the catalysts’ photocatalytic activity and biomedical properties. Here, a simple and inexpensive method has been developed to prepare a Pt-Ag3PO4/CdS/chitosan composite, which was characterized and used for the visible light-induced photocatalytic and antibacterial studies. This synthesized composite showed superior photocatalytic activity for methylene blue degradation as a hazardous pollutant (the maximum dye degradation was observed in 90 min of treatment) and killing of Gram positive bacterial (Staphylococcus aureus and Bacillus cereus) as well as Gram negative bacteria (Klebsiella pneumoniae, Salmonella... 

Effect of alkaline metal salts on the solvent extraction of platinum from leached spent dehydrogenation catalysts (Pt/Al2O3) in aqua-regia by the Trioctylphosphine oxide (TOPO) has been investigated. Best salting out effect was achieved using KCl as the additive salt in which process upto 90% of Platinum extraction achieved. Response Surface methodology utilized in order to design the experiments, model the extraction process for platinum and aluminum as well as; optimize the whole process. It was shown that solvent extraction of platinum by TOPO was kinetically fast and the needed equilibrium time for it was less than 30 seconds. In the present study, proposed models for platinum and... 

The objective of this study is to calibrate Priestley-Taylor (PT) model for estimating open water evaporation from an arid region reservoir called Chahnimeh. Chahnimeh Reservoir which is situated in the Sistan area in the southeast of Iran is being affected by regional energy advection during May to October. Therefore, common models of open water evaporation estimation such as PT require calibration. PT method was calibrated for Chahnimeh Reservoir using a volume balance method. Results showed that PT coefficient, αPT, as a constant over the year varies between 2.47±0.09 and 1.20±0.03 for two different hydrologic conditions of dry and wet. It means that there is also an intra-annular... 

Liquid phase hydro-purification of crude terephthalic acid (CTA) was performed using supported Pd and Pd-Sn catalysts on functionalized multi-wall carbon nanotubes (FMWCNT). Pd/FMWCNT catalysts were prepared by wet impregnation with Pd loadings of 0.05 to 0.6 wt.%. Pd-Sn/FMWCNT catalysts were prepared by co-impregnation (CI) and successive impregnation (SI) using 0.3 wt.% Pd loading and Sn/Pd molar ratios of 0.1 and 0.35 for the CI method and 0.05 to 0.35 for the SI method. Pd loading of 0.3 wt.% for Pd/FMWCNT was sufficient to decrease the 4-carboxybenzaldehyde (4-CBA) content of CTA from 2100 ppm to 5.5 ppm without excessive hydrogenation of terephthalic acid (TA). The commercial catalyst... 

The energetics and kinetic energy barriers of vacancy/atom exchange in a 37-atom truncated octahedron Ag-Pt binary cluster in the Ag-rich range of compositions are investigated via a first-principles atomistic approach. The energy of the local minima obtained considering various distributions of a single vacancy and a few Pt atoms within the cluster and the energy barriers connecting them are evaluated using accurate density-functional calculations. The effects of the simultaneous presence of a vacancy and Pt atoms are found to be simply additive when their distances are larger than first-neighbors, whereas when they can be stabilizing at low Pt content due to the release of strain by the... 

An efficient electrocatalyst for Pt-free I−/I3 − reduction has been synthesized by high temperature treatment of graphene oxide-cobalt phthalocyanine mixtures. The graphitic material was characterized by various techniques and was found to consist of reduced graphene oxide carrying CoN3 entities, obtained by thermal decomposition of cobalt phthalocyanine. This material had an ionization potential equal to 4.9±0.1 eV and thus it was judged appropriate to act as reduction electrocatalyst for the I−/I3 − redox electrolyte. It was subsequently deposited as thin film on FTO electrodes, which were employed as counter electrodes for dye-sensitized solar cells. Its capacity to reduce I−/I3 − redox... 

A series of M-doped Pt[sbnd]MgO (M = Pd, Ir, Re, Ru, Rh and Cr) sheet-shaped nano-catalysts were synthesized by the controlled co-precipitation method. The effects of M-doping on both the physicochemical and the chemisorption characteristics of Pt[sbnd]MgO catalysts were examined. The performance of the catalysts for the aqueous phase reforming (APR) of glycerol was also investigated. The APR activity of Pt[sbnd]M[sbnd]MgO catalysts depended on the type of the M dopant used. The APR activity varied in the following order: Rh > Pd > Cr > Ir > undoped ≈ Ru > Re, with the Rh-promoted catalyst having an activity of about one order of magnitude higher than the Re-promoted catalyst at 250 °C. It... 

In the present work, several new thermodynamic linear isotherm regularities for the dense fluids have been derived for the first time. For this purpose, the thermodynamic perturbation theory (TPT) employing only the attractive effective pair potential (AEPP) as u(r) = - ϵeff (σeff / r)m was used, where σeff which is the effective hard core diameter, is temperature dependent and m > 0. Based on the derived regularities, the isotherm (Z - Z(0))v2 is a linear function of ρ2, ρ and 1/ρ, depends on the values of m = 12, 9 and 6, respectively where Z - Z(0) is the difference between the experimental compressibility factor of the real fluid (Z) and that of the reference fluid (Z(0)). Also, Z - Z(0)... 

Xwt% Pt/Al 2 O 3 (X = 1, 3, 5, 8, 10) and 5 wt% Pt-1wt% M/AlO 3 (M = Pd, Rh, Re, Ru, Ir, Cr) catalysts were prepared, characterized and tested for aqueous phase reforming of pure and crude glycerol. Results show drastic dependence of catalytic performance of catalysts on both the active metal loading and the type of applied promoters. 5 wt% was the best Pt loading and Pt[sbnd]Rh/Al₂O₃ shows the best catalytic activity which has the highest hydrogen production rate (mmol/g cat h −1 ) and selectivity (89%) in continuous aqueous phase reforming of 10 wt% pure glycerol solution  

Pt@Bi-TiO2 photocatalysts with different Bi (0–5 wt%) and Pt (0–2 wt%) contents were prepared by a two-step sol-gel and photo-deposition technique and were used in photo-reduction of CO2. The synthesized catalysts were characterized by X-ray powder diffraction (XRD), UV–Vis diffuse reflectance spectroscopy (DRS), scanning and transmission electron microscopy (SEM and TEM), nitrogen sorption measurement (BET), Raman spectroscopy, Electron paramagnetic resonance (EPR) spectroscopy and photoluminescence spectroscopy (PL). CO2 photo-reduction results revealed that the introduction of Bi into TiO2 structure and subsequent loading of Pt on its surface significantly increased the methane yield.... 

Due to the strong magnetic anisotropy energy, the L10 FePt nanocrystals are considered as one of promising candidates for magnetic recording media with ultrahigh densities. The surfaces of Si and SiO2 wafers have been covered by FePt nanoparticles (NPs) and heated at 600 °C for 1 h to form the L10 phase. Bonding of NPs with the SiO2 surface in the presence of magnetic field during annealing process controls the L10 FePt NPs size and their uniform surface distribution. In the presence of perpendicular magnetic field to the surface, the size of NPs obtains up to 30 nm with coercivity of 5.8 kOe and in parallel magnetic field, the NPs size reaches to 45 nm with coercivity of 2.9 kOe. These... 

A nanowire arrays system consisting of an ordered configuration of Pt, Ni and Co was constructed in single-bath solution through pulse electrodeposition. This structure was evaluated as a potential amperometric non-enzymatic sensor to detect glucose in alkaline solution. We observed a strong and fast amperometric response at low applied potential of 0.4 V vs. SCE over linear ranges of 0-0.2 mM and 0.2-8 mM glucose with sensitivities of 1125 and 333 μA mM-1 cm-2, respectively. We also observed a low detection limit for glucose of 1 μM. Correlation of the electronic and geometric modifications with the electrochemical performance characteristics enhanced catalytic activity of the electrode by... 

The aim of this study was to develop an appropriate kinetic model for propane dehydrogenation (PDH) over an industrial Pt-Sn/γ-Al 2O 3 catalyst in the presence of small amounts of oxygenated compounds. Experimental data were obtained from a previous study where catalytic PDH was carried out in a laboratory scale reactor at atmospheric pressure in the temperature range of 575-620 °C in the presence of small amounts of water or methanol. The kinetics of the main dehydrogenation reaction was described and the effects of water and methanol on coke deposition and catalyst sintering were considered in a catalyst deactivation model to explain the observed optimum level in the amount of added... 

Catalytic activity of carbon/Pt nanoparticles modified TiO 2 nanotubes electrode was studied by using dopamine contained solutions. The TiO 2 nanotubes electrode was prepared using anodizing method in aqueous solution. The electrochemical pulse method was then applied for electrodeposition of Pt nanoparticles onto the TiO 2 nanotubes. Further modification was achieved by decomposition of polyethylene glycol in a tube furnace to have a carbon/Pt nanoparticles modified TiO 2 nanotubes electrode. The final modified electrode could successfully detect the electro-oxidation of dopamine in a ImM contained solution using cyclic voltametry method. Also, a high sensitivity towards the oxidation of... 

An electro-catalysis non-enzymatic electrode is proposed based on alloyed Pt/Ni nanowire arrays (NWAs) for the detection of glucose. The Pt/Ni NWAs were prepared by pulse electrodeposition of Pt and Ni within a nano-pore polycarbonate (PC) membrane followed by a chemical etching of the membrane. The electrode structure is characterized by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The resulting Pt/Ni NWAs electrode shows high electrocatalytic activities towards the oxidation of glucose in alkaline solution. Consequently, a sensitive amperometric detection of glucose is achieved under 0.45 V vs. SCE with a low detection limit of 1.5 μM within a wide linear...