Sharif Digital Repository

Carbide morphologies of white cast iron containing 22% Cr and 10-12% tungsten with different carbon contents (2.34-3.20. wt.%) were investigated. Results indicated that for the as-cast alloys with no heat treatments, the addition of carbon changes the morphology of carbides during air-cooling in the presence of tungsten. Light microscopy analysis revealed that for an alloy with 2.3. wt% carbon, chromium carbides possess coarse gray appearance (GA). Increasing the carbon content reduced the coarse GA zones volume fraction while a finer GA zones emerged. The coexistence of coarse and fine GA phases came to an end at 2.8. wt% carbon, at which only fine GA zones spread throughout the chromium... 

In the endurance time (ET) method, structures are subjected to a specially designed intensifying ground acceleration function and their performance is judged based on their response at various excitation levels. A range of equivalent intensities can be covered in a single numerical or experimental simulation, thus significantly reducing the computational demand as compared to full nonlinear response-history analyses. The applied excitation intensity at various times has been correlated with those of the scaled ground motions. Response spectra of seven ground motions on stiff soil were used to produce intensifying acceleration functions that at each time window produce a response spectrum... 

Chromatographic method development for preparative targets is a time-consuming and subjective process. This can be particularly problematic because of the use of valuable samples for isolation and the large consumption of solvents in preparative scale. These processes could be improved by using statistical computations to save time, solvent and experimental efforts. Thus, contributed by ESI-MS, after applying DryLab software to gain an overview of the most effective parameters in separation of synthesized celecoxib and its co-eluted compounds, design of experiment software that relies on multivariate modeling as a chemometric approach was used to predict the optimized touching-band... 

Anisotropy and heterogeneity in reservoir properties introduce challenges during the development of hydrocarbon reservoirs in naturally fractured reservoirs. In reservoir simulations, grid-block properties are frequently assigned to obtain reasonable history matches. Even then, accuracy with regard to some aspects of the performance such as water or gas cuts, breakthrough times, and sweep efficiencies may be inadequate. In some cases, this could be caused by the presence of substantial flow through natural fractures. In this work the fracture characterization and modeling was performed in a highly fractured carbonate reservoir in SW Iran. It was observed that reservoir simulation based on... 

In this research particle trajectory in a bidirectional vortex flow has been numerically predicted and the results experimentally validated. Scale analyses of forces show their order of magnitudes and give a criterion to recognize the order of magnitude of exerting forces on the particle. The particle has been assumed to be a rigid sphere. Initial velocity, diameter, density, and position of entering particle are assumed to be known. If the particle length scale is considered not to be comparable with the chamber length and if particle number density is low, then influence of particle on the flow field is negligible and a one-way solution is applicable. The governing equation is converted to... 

In this paper, the so-called small time-step instability in finite element simulation of the fluid part is considered in fluid-structure interaction (FSI) problems in which a high-frequency vibrating structure interacts with an incompressible fluid. Such a situation is common in many microfluid manipulating devices. A treatment has been proposed that uses the dimensionless set of FSI governing equations in order to scale up the problem time step to a proper level that precludes the potential small time-step instability. Two-dimensional and three-dimensional finite element simulations of a mechanical micropumping device are performed to verify the efficiency of the presented approach. Solid... 

Background: Oral rehydration solution (ORS) is a form of oral rehydration therapy (ORT) for diarrhoea that has the potential to drastically reduce child mortality; yet, according to UNICEF estimates, less than half of children younger than 5 years with diarrhoea in low-income and middle-income countries (LMICs) received ORS in 2016. A variety of recommended home fluids (RHF) exist as alternative forms of ORT; however, it is unclear whether RHF prevent child mortality. Previous studies have shown considerable variation between countries in ORS and RHF use, but subnational variation is unknown. This study aims to produce high-resolution geospatial estimates of relative and absolute coverage of... 

Bioremediation of soil and groundwater sites contaminated by petroleum hydrocarbons is known as a technically viable, cost-effective, and environmentally sustainable technology. The purpose of this study is to investigate laboratory-scale bioremediation of petroleum-hydrocarbon contaminated soil through development of eight bioreactors, two bioreactors for each bioremediation mode. The modes were: (1) natural attenuation (NA); (2) biostimulation (BS) with oxygen and nutrients; (3) bioaugmentation (BA) with hydrocarbon degrading isolates; (4) a combination of biostimulation and bioaugmentation (BS-BA). Total petroleum hydrocarbons (TPH) mass balance over the bioreactors showed about 2% of...