Sharif Digital Repository

Performance-based optimal seismic design of structures requires repetitive and massive dynamic analyses. In the Endurance Time (ET) method, structures are subjected to specially designed intensifying acceleration functions and their response at various excitation levels is estimated by each single response-history analysis, thus, significantly reducing the required computational demand. In this paper, the ET method is utilized to acquire optimal placement of viscous dampers in short steel frames with the target of obtaining the desirable performance in two hazard levels simultaneously. In the optimization procedure, the damping coefficients of the added dampers are treated as design... 

The Endurance Time (ET) method is a new dynamic pushover procedure in which structures are subjected to gradually intensifying acceleration functions and their performance is assessed based on the length of the time interval that they can satisfy required performance objectives. In this paper, the accuracy of the Endurance Time method in estimating average deformation demands of low and medium rise steel frames using ETASOf series of ET acceleration functions has been investigated. The precision of the ET method in predicting the response of steel frames in nonlinear analysis is investigated by considering a simple set of moment-resisting frames. An elastic-perfectly-plastic material model... 

The preliminary design of building structures is normally based on the equivalent lateral forces provided in seismic design guidelines. The height-wise distribution of these loads is predominantly based on elastic vibration modes. However, as structures exceed their elastic limits in severe earthquakes, these design load patterns may not necessarily lead to efficient distribution of strength within the structures. To address this issue, several alternative load patterns have been proposed for the seismic design of non-linear structures. However, due to the simplifications involved in the development of these design load patterns, their adequacy needs to be assessed for different structural... 

A new comparative performance measure based on a structure's seismic fragility curve is introduced. This factor, called the performance improvement factor (PIF), was used to compare the seismic performance and reliability of two structures. Using the PIF, the efficiency of viscous dampers on the behaviour of a weak mid-rise steel structure was investigated. A prototype five-span 12-storey steel frame was equipped with three patterns of viscous dampers and their seismic performance was studied. The distribution of dampers along the height of the structure was optimised in three hazard levels using a genetic algorithm and the structure was subjected to 12 ground motion records scaled to levels...