Loading...
Search for:
sequential-chemical-bath-deposition--s-cbd
0.009 seconds
Synthesis, Characterization and Studying of Photoelectrochemical (PEC) Properties for TNA/Ag2S Nanostructures
, M.Sc. Thesis Sharif University of Technology ; Moshfegh, Ali Reza (Supervisor) ; Moradlo, Omran (Co-Advisor)
Abstract
Free-standing TiO2 nanotube array (TNA) films were fabricated via two-step anodization of titanium sheet. The electrolyte consisted of DI water and ethylene glycol (99.9%, Merck) solution with volume ratio of 10:90, containing 0.5 M NH4F. Then, a few drops of 1M H3PO4 aquaes solution have been added to adjust pH at 5.7. The anodization process was performed at optimized applied voltage of 60 V for 200 min. Indeed it does in two-step for 50 and 150 min, and samples were sonicated of 40s between two steps. Then, to crystallize the grown structures, they were annealed in air at 500˚C for 80 minutes. Surface of TNA was modified by sequential-chemical bath deposition (S-CBD) method to fabricate...
Synthesis and Characterization of CdS Modified TiO2 Nanotubes for Studying of Photoelectrochemical (PEC) Properties
, M.Sc. Thesis Sharif University of Technology ; Moshfegh, Alireza (Supervisor) ; Azimirad, Rouhollah (Supervisor)
Abstract
In this research, first thin films with nanostructures of titanium nanotube arrays (TNAs) synthesized by anodization under different applied voltage (20- 60 V) and different reaction times (120 and 200 min). The electrolyte solution for synthesizing the samples contained 90% ethylene glycol (EG), 10% DI water, 0.1 M NHR4RF and a little HR3RPOR4R to reach the pH to 5.6. The synthesized samples crystallized under annealing treatment at 500 °C (with heating rate of 9.5 °CminP -1 P). The scanning electron microscopy (SEM) analysis was indicate that the length and the inner diameter of the nanotubes have increased from 1.6 μm and 67 nm (for 30 V anodization and for 2h) to 4.2 μm and 125 nm (for...