Loading...
Search for: shear-thinning-fluids
0.005 seconds

    Experimental investigation and comparison of Newtonian and non-Newtonian shear-thinning drop formation

    , Article Experimental Thermal and Fluid Science ; Volume 94 , 2018 , Pages 148-158 ; 08941777 (ISSN) Salehi, M. S ; Esfidani, M. T ; Afshin, H ; Firoozabadi, B ; Sharif University of Technology
    Elsevier Inc  2018
    Abstract
    The presence of small amount of polymer in Newtonian liquids affects the fluid behavior significantly and creates superficial differences between Newtonian and non-Newtonian drop formation. In the present study, Newtonian and non-Newtonian shear-thinning drop formation in air is examined experimentally and the geometrical parameters, such as drop elongation length, minimum neck diameter and current contact angle are studied for water, glycerin solutions (79, 89 and 94% w/w) and Carboxymethyl cellulose (CMC) solutions (0.5 to 1.5% w/w) drops. The results indicate that at initial stages of the drop growth, Newtonian and non-Newtonian liquids behave similarly. However, at the start of the... 

    Experimental investigation of the bubble motion and its ascension in a quiescent viscous liquid

    , Article Experimental Thermal and Fluid Science ; Volume 103 , 2019 , Pages 274-285 ; 08941777 (ISSN) Oshaghi, M. R ; Shahsavari, M ; Afshin, H ; Firoozabadi, B ; Sharif University of Technology
    Elsevier Inc  2019
    Abstract
    In the present research, the rising behavior of air bubble in a viscous liquid is investigated experimentally. Aqueous solutions of glycerol and CMC were used as the Newtonian and shear-thinning non-Newtonian viscous liquids, respectively. The bubble is formed via injection of air by a syringe pump and rises in the quiescent viscous liquid. The process was captured using a high-speed camera (1000 fps) and was post processed to obtain the bubble characteristics such as the center of mass and aspect ratio. The experimental results were verified using the existing literatures and the non-dimensional numbers were reduced to two (Velocity number and Flow number) by lumping the parameters. In... 

    Investigation of bubble formation and its detachment in shear-thinning liquids at low capillary and Bond numbers

    , Article Theoretical and Computational Fluid Dynamics ; Volume 33, Issue 5 , 2019 , Pages 463-480 ; 09354964 (ISSN) Oshaghi, M. R ; Afshin, H ; Firoozabadi, B ; Sharif University of Technology
    Springer New York LLC  2019
    Abstract
    In the present paper, the formation of an air bubble in a shear-thinning non-Newtonian fluid was investigated numerically. For modeling, an algebraic volume of fluid (VOF) solver of OpenFOAM ® was improved by applying a Laplacian filter and was evaluated using the experimental results from the literature. The enhanced solver could compute the surface tension force more accurately, and it was important especially at low capillary and Bond numbers due to the dominance of surface tension force relative to the other forces. The adiabatic bubble growth was simulated in an axisymmetric domain for Bo = 0.05 , 0.1 , 0.5 and Ca = 10 - 1, 10 - 2, 10 - 3, 10 - 4, and the bubble detachment time and... 

    On the motion of Newtonian and non-Newtonian liquid drops

    , Article Scientia Iranica ; Volume 19, Issue 5 , 2012 , Pages 1265-1278 ; 10263098 (ISSN) Aminzadeh, M ; Maleki, A ; Firoozabadi, B ; Afshin, H ; Sharif University of Technology
    2012
    Abstract
    In the present study, the motion of Newtonian and non-Newtonian liquid drops has been investigated experimentally. In order to investigate the effect of bulk fluid on drops, we have used water and air, as two fluids with different properties, and various industrial and biological applications. Image processing is utilized to analyze the images obtained by a high speed camera. The research has been separated into two parts. The first part has been devoted to the experiments in which air is the bulk fluid, and the second is related to the experiment carried out in water. The range of Reynolds number is, approximately, 50

    Electroosmotic flow of power-law fluids with temperature dependent properties

    , Article Journal of Non-Newtonian Fluid Mechanics ; Volume 185-186 , 2012 , Pages 49-57 ; 03770257 (ISSN) Babaie, A ; Saidi, M. H ; Sadeghi, A ; Sharif University of Technology
    Elsevier  2012
    Abstract
    The influence of variable fluid properties on mixed electroosmotic and pressure driven flow of non-Newtonian fluids is investigated in this paper. The non-linear coupled energy and momentum equations are solved by means of an iterative numerical approach. The results reveal that the temperature dependent effects only become significant at very high values of the Debye-Hückel parameter in case of combined electroosmotic and pressure driven flow and could safely be neglected in other cases. It is observed that the physical properties variation lead to a higher mean velocity in case of pressure assisted flow and a lower mean velocity in case of pressure opposed flow. Furthermore, the... 

    Effect of temperature and concentration on thermal conductivity and viscosity of ferrofluid loaded with carbon nanotubes

    , Article Heat and Mass Transfer/Waerme- und Stoffuebertragung ; 2015 , Pages 1-9 ; 09477411 (ISSN) Shahsavar, A ; Saghafian, M ; Salimpour, M. R ; Shafii, M. B ; Sharif University of Technology
    Springer Verlag  2015
    Abstract
    The aim of this paper is to investigate the thermal conductivity and viscosity of a hybrid nanofluid containing tetramethylammonium hydroxide (TMAH) coated Fe3O4 nanoparticles and gum arabic (GA) coated carbon nanotubes (CNTs), experimentally. The magnetic nanoparticles and CNTs are physically attached as the result of interaction between the TMAH and GA molecules. The morphology and structure of the samples are characterized with X-ray diffraction (XRD) and transmission electron microscopy (TEM). The experiments are carried out in the magnetic nanoparticles volume concentration range of 0.1–0.9 %, CNT volume concentration range of 0.05–1.35 % and the temperature range of 25–55 °C. The... 

    Synthesis and analysis of the properties of ferro-fluids

    , Article ICONN 2010 - Proceedings of the 2010 International Conference on Nanoscience and Nanotechnology, 22 February 2010 through 26 February 2010, Sydney, NSW ; 2010 , Pages 91-93 ; 9781424452620 (ISBN) Maleki Jirsaraei, N ; Ghane Motlagh, B ; Ghane Golmohamadi, F ; Ghane Motlagh, R ; Rouhani, S ; Sharif University of Technology
    2010
    Abstract
    We report the rheological properties of ferro-fluid (FF) containing iron oxide nano-particles. At first, a FF was synthesized by using chemical co-precipitaton[1]. The microstructure study using SEM revealed that the FF contained nano-particles with the mean particle size of 35nm. The XRD study revealed that we have well crystallized structures of magnetite; they appeared to be approximately single crystalline structures. The rheological results proved that the FF has non Newtonian behavior, it is a shear thinning fluid in all magnetic fields, Moreover, the magnetic field increases the viscosity in a definite shear rate due to the nano-particles agglomerations and formation of chain-like... 

    Effect of magnetic field on thermal conductivity and viscosity of a magnetic nanofluid loaded with carbon nanotubes

    , Article Journal of Mechanical Science and Technology ; Volume 30, Issue 2 , 2016 , Pages 809-815 ; 1738494X (ISSN) Shahsavar, A ; Salim Pour, M. R ; Saghafian, M ; Shafii, M. B ; Sharif University of Technology
    Korean Society of Mechanical Engineers 
    Abstract
    The present work examines experimentally the effect of magnetic field on the viscosity and thermal conductivity of a hybrid nanofluid containing tetramethylammonium hydroxide (TMAH) coated Fe3O4 nanoparticles and Gum arabic (GA) coated carbon nanotubes (CNTs). The hybrid nanofluid was prepared by using ultrasonic dispersion method. Magnetic field was created by a pair of spaced apart magnet plates. The effect of temperature on the time variation of thermal conductivity under applied magnetic field was also investigated. According to the results of this study, viscosity of the hybrid nanofluid increases with the strength of magnetic field, while it decreases with the increase of temperature.... 

    Effect of temperature and concentration on thermal conductivity and viscosity of ferrofluid loaded with carbon nanotubes

    , Article Heat and Mass Transfer/Waerme- und Stoffuebertragung ; Volume 52, Issue 10 , 2016 , Pages 2293-2301 ; 09477411 (ISSN) Shahsavar, A ; Saghafian, M ; Salimpour, M. R ; Shafii, M. B ; Sharif University of Technology
    Springer Verlag  2016
    Abstract
    The aim of this paper is to investigate the thermal conductivity and viscosity of a hybrid nanofluid containing tetramethylammonium hydroxide (TMAH) coated Fe3O4 nanoparticles and gum arabic (GA) coated carbon nanotubes (CNTs), experimentally. The magnetic nanoparticles and CNTs are physically attached as the result of interaction between the TMAH and GA molecules. The morphology and structure of the samples are characterized with X-ray diffraction (XRD) and transmission electron microscopy (TEM). The experiments are carried out in the magnetic nanoparticles volume concentration range of 0.1–0.9 %, CNT volume concentration range of 0.05–1.35 % and the temperature range of 25–55 °C. The... 

    Pressure drop reduction of power-law fluids in hydrophobic microgrooved channels

    , Article Physics of Fluids ; Volume 31, Issue 7 , 2019 ; 10706631 (ISSN) Javaherchian, J ; Moosavi, A ; Sharif University of Technology
    American Institute of Physics Inc  2019
    Abstract
    Using hydrophobic surfaces is one of the efficient methods to preserve energy in fluid transfer systems. However, the studies have been concentrated on Newtonian fluids despite the wide applications of non-Newtonian fluids in daily life and many industries such as the biological, foodstuff, chemical, petroleum, cosmetic, and lab on a chip fields. In this study, we consider power-law fluids as a typical example of non-Newtonian fluids and investigate the effect of hydrophobic microgrooves on the pressure drop in channels by utilizing the phase field method. We demonstrate that the optimum size of the rectangular microgrooves in which the maximum pressure drop reduction (PDR) happens for both... 

    Electrowetting of power-law fluids in microgrooved channels

    , Article Physics of Fluids ; Volume 32, Issue 7 , July , 2020 Izadi, R ; Moosavi, A ; Sharif University of Technology
    American Institute of Physics Inc  2020
    Abstract
    Studying the dynamic behavior of droplets is of great importance in the electrowetting phenomena. However, despite the widespread use of non-Newtonian fluids in industry and daily life including medicine, food, petroleum, environmental biomass, and lab on a chip, most studies have focused on Newtonian fluids. In this study, a power-law fluid is considered as a typical example of non-Newtonian fluids and its dynamic behavior is investigated within a microchannel, and the results are compared with those of the Newtonian fluids. Both the grooved and non-grooved substrates are considered. For this purpose, the governing equations for the two phase fluid flow are solved using the finite element... 

    Shear-thinning droplet formation inside a microfluidic T-junction under an electric field

    , Article Acta Mechanica ; Volume 232, Issue 7 , 2021 , Pages 2535-2554 ; 00015970 (ISSN) Amiri, N ; Honarmand, M ; Dizani, M ; Moosavi, A ; Kazemzadeh Hannani, S ; Sharif University of Technology
    Springer  2021
    Abstract
    Researchers usually simplify their simulations by considering the Newtonian fluid assumption in microfluidic devices. However, it is essential to study the behavior of real non-Newtonian fluids in such systems. Moreover, using the external electric or magnetic fields in these systems can be very beneficial for manipulating the droplet size. This study considers the simulation of the process of non-Newtonian droplets’ formation under the influence of an external electric field. The novelty of this study is the use of a shear-thinning fluid as the droplet phase in this process, which has been less studied despite its numerous applications. The effects of an external electric field on this... 

    Modelling of power-law fluid flow through porous media using smoothed particle hydrodynamics

    , Article Transport in Porous Media ; Volume 74, Issue 3 , 2008 , Pages 331-346 ; 01693913 (ISSN) Vakilha, M ; Manzari, M. T ; Sharif University of Technology
    2008
    Abstract
    The flow of non-Newtonian fluids through two-dimensional porous media is analyzed at the pore scale using the smoothed particle hydrodynamics (SPH) method. A fully explicit projection method is used to simulate incompressible flow. This study focuses on a shear-thinning power-law model (n < 1), though the method is sufficiently general to include other stress-shear rate relationships. The capabilities of the proposed method are demonstrated by analyzing a Poiseuille problem at low Reynolds numbers. Two test cases are also solved to evaluate validity of Darcy's law for power-law fluids and to investigate the effect of anisotropy at the pore scale. Results show that the proposed algorithm can...