Loading...
Search for: stable-suspensions
0.006 seconds

    A study of the electrophoretic deposition of bioactive glass-chitosan composite coating

    , Article Ceramics International ; Volume 38, Issue 1 , January , 2012 , Pages 471-476 ; 02728842 (ISSN) Mehdipour, M ; Afshar, A ; Sharif University of Technology
    2012
    Abstract
    Bioactive glass is coated on implant's surface to improve corrosion resistance and osseointegration, when placed in the body. Bioactive glass particles were synthesized through a sol-gel process and deposited along with chitosan to form a composite coating on a stainless steel substrate using electrophoretic deposition technique. Stable suspensions of chitosan-bioactive glass were prepared using bioactive glass particles (<1 μm) and 0.5 g/l chitosan solution. The influence of ethanol-water ratio on deposition yield was investigated. For all process conditions, best results were achieved with suspension of 30 vol% water in ethanol-water containing 2 g/l bioactive glass. FTIR studies showed... 

    Electrophoretic deposition of bioactive glass coating on 316L stainless steel and electrochemical behavior study

    , Article Applied Surface Science ; Volume 258, Issue 24 , 2012 , Pages 9832-9839 ; 01694332 (ISSN) Mehdipour, M ; Afshar, A ; Mohebali, M ; Sharif University of Technology
    Elsevier  2012
    Abstract
    In this research, submicron bioactive glass (BG) particles were synthesized by a sol-gel process and were then coated on a 316L stainless steel substrate using an electrophoretic deposition (EPD) technique. Stable suspension of bioactive glass powders in ethanol solvent was prepared by addition of triethanol amine (TEA), which increased zeta potential from 16.5 ± 1.6 to 20.3 ± 1.4 (mv). Thickness, structure and electrochemical behavior of the coating were characterized. SEM studies showed that increasing EPD voltage leads to a coating with more agglomerated particles, augmented porosity and micro cracks. The results of Fourier transformed infrared (FTIR) spectroscopy revealed the adsorption... 

    Fabrication of aluminum nitride coatings by electrophoretic deposition: Effect of particle size on deposition and drying behavior

    , Article Ceramics International ; Volume 37, Issue 1 , 2011 , Pages 313-319 ; 02728842 (ISSN) Abdoli, H ; Zarabian, M ; Alizadeh, P ; Sadrnezhaad, S. K ; Sharif University of Technology
    Abstract
    Electrophoretic technique was used to deposit micro- and nano-sized aluminum nitride coatings on stainless steel surfaces by using a well-dispersed stable suspension produced by addition of AlN powder plus a small amount of iodine to ethanol. Parabolic regime governed the deposition. Electrophoretic deposition for 240 s at 100 V resulted in formation of a uniformly dense film on the top, but a porous inhomogeneous layer at the bottom. This was attributed to fast deposition of coarse particles and/or agglomerates at large electric fields. After drying, micro-sized particles led to a uniform crack-free interface while nano-particles resulted in fragmented non-cohesive layers. Weight loss...