Sharif Digital Repository

The main objectives of this study are to determine the influence of crude oil type, salinity, temperature and pressure on the dynamic interfacial tension (DIFT) of crude oil based on the experiments and modeling approaches. DIFT is also modeled using dynamic adsorption models, mono-exponential decay model as well as empirical equations. The results showed that when temperature increases, unlike deionized water which inversion phase temperature was observed, the equilibrium IFT of crude oils/sea water increases due to reduction of surface excess concentration of natural surfactants at the fluid/fluid interface as a dominant mechanism  

This study investigates dynamic interfacial tension (DIFT) of acidic crude oil (ACO) and non acidic/basic crude oils (BCO) + deionized water (DW) as a function of pressure from 500 to 4000 psi, and temperature from 30 to 80 °C using an axisymmetric drop shape analysis (ADSA) technique. DIFTs are also modeled using dynamic adsorption model, mono-exponential decay model, and empirical equations. The results showed that if a reduction in the surface excess concentration due to increasing temperature overlooks the total entropy of the molecules in the system, an increase in IFT would be expected  

In this way, after experimental measurement of interfacial tension, different models including mono-exponential decay, dynamic adsorption models and empirical equation are used to correlate this time-dependent behavior of interfacial tension (IFT). During the modeling approach, the induction, adsorption, equilibrium, and meso-equilibrium times as well as diffusivity of surface active components known as natural surfactant including asphaltene and resin from crude oil to the interface are obtained. In addition, the surface excess concentration of surface active components at the interface and Gibbs adsorption isotherm are utilized to analyze the measured dynamic IFTs. Finally, the mechanisms... 

The interfacial properties of crude oil are highly complex and are not yet well understood. This study aimed to evaluate the effect of temperature (30-80°C) and pressure (3.44-27.58MPa) on the dynamic interfacial tension (IFT) of crude oil/aqueous solutions consisting of 15000ppm of salt containing different chloride anions, e.g. NaCl, KCl, MgCl2, and CaCl2. To reach this goal, several parameters, such as dynamic and equilibrium IFT, adsorption time, diffusivity of resin, and asphaltene as surface-active agents from bulk of crude oil towards fluid/fluid interface and surface excess concentration of them at the interface, were compared as a function of temperature, pressure, and ion type. The... 

The interfacial properties of crude oil are highly complex and are not yet well understood. This study aimed to evaluate the effect of temperature (30–80 °C) and pressure (3.44–27.58 MPa) on the dynamic interfacial tension (IFT) of crude oil/aqueous solutions consisting of 15 000 ppm of salt containing different chloride anions, e.g. NaCl, KCl, MgCl2, and CaCl2. To reach this goal, several parameters, such as dynamic and equilibrium IFT, adsorption time, diffusivity of resin, and asphaltene as surface-active agents from bulk of crude oil towards fluid/fluid interface and surface excess concentration of them at the interface, were compared as a function of temperature, pressure, and ion type.... 

Sulfate anion is well-known for being one of the most active agents to be injected into the oil reservoirs and being capable of not only altering the interfacial properties of crude oil but also enhancing the water solution properties in oil recovery. In the current study, the effects of temperature and pressure were studied on interfacial tension (IFT) as well as the adsorption behavior of two different solutions containing sulfate anion using experimental measurements and modeling approaches. Although it was expected that IFT values of the studied systems might decrease as temperature increased due to the improvement in the molecule mobility and solubility of crude oil in water, which... 

The separation of xylene isomers is an important application in separation processes that is based on their adsorption properties on different adsorbents. In this work, the Price and Danner method was employed with a neural network to investigate the adsorption behavior of binary systems of p-xylene/m-xylene, p-diethyl benzene/m-xylene, and p-diethyl benzene/p-xylene and the ternary system of p-diethyl benzene/m-xylene/p-xylene at 130 and 175°C. The Redlich-Kister, Wilson, and NRTL models were used to determine the activity coefficients in the adsorbed phase. Comparison with experimental data from the literature indicated that the proposed thermodynamic model would best determine surface... 

Carbonated water has been recently proposed as an enhanced oil recovery method for crude oil reservoirs. Interfacial tension (IFT) plays a crucial rule on the displacement of trapped oil ganglia in the porous media. This investigation is designed to systematically assess the dynamic interfacial tension (DIFT) of two different types of crude oils with carbonated water (CW). In addition, the measured experimental data were applied into specified models. The DIFT behavior of acidic and non-acidic crude oil samples/CW and deionized water (DW) are also compared to find the effect of dissolved carbon dioxide in water on IFT. At the next stage, DIFT of all the results were used through three...