Sharif Digital Repository

A series of experiments were conducted on an oscillating airfoil in subsonic flow. The model was oscillated in two types of motions, pitch and plunge, at different velocities, and reduced frequencies. In addition, steady data were acquired and examined to furnish a baseline for analysis and comparison. The imposed variables of the experiment were reduced frequency, mean incident angle, amplitude of motion, and free stream velocity as well as the surface grit roughness. The unsteady aerodynamic loads were calculated using surface pressure measurements, 64 ports, along the chord for both upper and lower surfaces of the model. Particular emphases were placed on the effects of different type of... 

An extensive experimental test to study the flow behavior over a rectangular wing in the subsonic wind tunnel in Iran was conducted. The tests included, surface pressure measurements at three locations and wake study at different angles of attack and free-stream Reynolds number. Further, to investigate the sidewall effects on the model pressure and wake, suction were applied at the wing root, where the model was attached to the tunnel wall. Suction affected surface pressure at all three locations by increasing the model pressure peak, preventing separation near the T. E., etc. at low angles of attack. However at moderate to high angles of attack, suction affected only the root pressure... 

A series of experiments were carried out to investigate unsteady behavior of the flow field as well as the boundary layer of an airfoil oscillating in plunging-type motion in a subsonic wind tunnel. The measurements involved surface-mounted hot films complimented with surface pressure. In addition, wind tunnel wall pressure distribution was acquired to furnish a baseline for the wall interference corrections. The airfoil is the section of a 660-kW wind turbine blade. The experiments were conducted at a Reynolds number of 0.42 million, and over two reduced frequencies of k = 0.06 and 0.085, at prestall, nearstall, and poststall regions. The unsteady aerodynamic loads were calculated from the... 

A series of low speed wind tunnel tests were conducted to study the unsteady aerodynamic behavior of an airfoil sinusoidally oscillating in plunge. The experiments included measuring the surface pressure distribution over a range of reduced frequencies, k = 0.03 - 0.06. In addition, steady state data were acquired and were used to furnish a baseline for further analysis and comparison. The model was oscillated with amplitude of ±15 cm and at three different mean angles of attack of 0, 10° and 18°. The unsteady aerodynamic loads were calculated from the surface pressure measurements, 64 ports, along the chord for both upper and lower surfaces. The plunging displacements were transformed into... 

Numerous experiments were conducted on an oscillating airfoil in a subsonic wind tunnel. The experiments involved measuring the surface pressure distribution when the model oscillated in two types of motion, pitch and plunge, at three different Reynolds numbers, 0.42, 0.63 and 0.84 million, and over a range of reduced frequencies, k = 0.03 0.09. The unsteady aerodynamic loads were calculated from the surface pressure measurements, 64 ports, along the chord for both upper and lower surfaces of the model. Particular emphasis was placed on the effects of different types of motion on the unsteady pressure distribution of the airfoil at pre-stall, near-stall and post-stall conditions. It was...