Sharif Digital Repository

The effect of quenching wheel speed on the structure and Curie temperature of Fe73.5Si13.5B9Nb3Cu1 alloy has been investigated using X-ray diffraction, differential scanning calorimetry, transition electron microscopy and a SQUID magnetometer. Ribbons were melt-spun at different wheel speeds and then were annealed to nucleate nano crystals embedded in the amorphous matrix. The results indicated that the thickness of the ribbons was inversely proportional to the wheel speed following the power law of the type t ∝ Vs -1.231. DSC and XRD results showed that at higher wheel speeds the greater potential energy triggers the formation of Fe (Si) crystallites and thus, increases the crystallinity.... 

In this study, the effects of stress-assisted heat treatment on the microstructure and phase transformation of a Ti-rich (Ti-49.52 at.% Ni) shape memory alloy were investigated. For this purpose, the alloy was heat treated at temperature of 500 °C for 10 h under applied stresses of 100 and 200 MPa. XRD, TEM, and repeated thermal cycling were employed to study the microstructure and transformation behavior of the heat-treated materials. Room temperature XRD diffractogram of the stress-free heat-treated material showed a weak reflection of austenite (B2), while that for the stress-assisted heat-treated materials had a high intensity implying the presence of residual austenite in the... 

This paper presents the effect of martensite volume fraction (VM) on mechanical properties of AISI 4340 steel with ferrite-bainite-martensite microstructures. The steel bars were austenitized at 900°C for 1h followed by intercritical annealing at 740°C for 100min and quenching into a salt bath with temperature of 300°C and holding at different times to obtain triple phase (TP) microstructures with 34vol.% fraction ferrite and various martensite (or bainite) contents. Presence of three phases in adjacent to each other was confirmed by metallographic analysis and TEM studies. TEM observation also indicates higher density of dislocations within ferrite near martensite colonies compared to that... 

The field emission properties of MoO2 nanostars grown on a silicon substrate and their emission performance in various vacuum gaps are reported in this article. A new structure of molybdenum oxides, named a nanostar, is grown by thermal vapor deposition with a length of ̃1 μm, a thickness of ̃50 nm, and its width in the range of 500-700 nm. The morphology, structure, composition, and chemical states of the prepared nanostars were characterized by scanning electron microscopy, high-resolution transmission electron microscopy, X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS). According to XRD analysis, the grown nanostructures are composed of both crystalline Mo4O11 and... 

The field-emission properties of molybdenum oxide nanowires grown on a silicon substrate and its emission performance in various vacuum gaps are reported in this article. A new kind of molybdenum oxides named nanowires with nanoscale protrusions on their surfaces were grown by thermal vapor deposition with a length of ~1 μm and an average diameter of ~50 nm. The morphology, structure, composition and chemical states of the prepared nanostructures were characterized by scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). According to XRD, XPS, and TEM analyses, the synthesized samples...