Sharif Digital Repository

Propane dehydrogenation was carried over a commercial Pt-Sn/γ-Al 2O3 catalyst at atmospheric pressure and reaction temperatures of 580, 600, and 620°C and WHSV of 11 h-1 in an experimental tubular quartz reactor. Propane conversions were measured for catalyst time on stream of up to nine days. The amounts of coke deposited on the catalyst were measured after one, three, six, and nine days on stream using a thermogravimetric differential thermal analyzer (TG-DTA) for each reaction temperature. The coke formation kinetics was successfully described by a coke formation model based on a monolayer-multilayer mechanism. In addition, catalyst deactivation was presented by a time-dependant... 

From gas-solid carbonation studies and product characterization by XRD, carbon elemental analysis, and TG-FTIR profiling of evolved CO2, the presence of water vapour at high relative humidity (>25% RH) was shown to cause a drastic acceleration in the rate of CO2 absorption into MgO and Mg(OH)2 producing magnesite and hydrocarbonated precursors. From thermogravimetric experiments in the vicinity of the dew point, carbonation was shown to proceeded in steps triggered by spontaneous condensation (and re-evaporation) of water. Almost complete conversion to magnesite (MgCO3) and/or hydromagnesite [HM = 4MgCO3·Mg(OH)2·4H2O] was observed in a few hours under rather mild conditions of pressure (PCO2... 

The effects of graphite content on the density and oxidation behavior of MgO-C refractory samples were studied. The samples were formulated with various amounts of graphite and their oxidation behavior was investigated (in an isothermal condition); using a Thermo Gravimetric system (TG), in air and at temperatures ranging from 900"C to 1450"C. The preliminary results showed that the porosity and density of tempered samples were decreased when the graphite content was increased. However, after heating the samples at higher temperatures, the decreasing rate of porosity was lowered. At the beginning of the oxidation process, the rate of weight loss was high, but was gradually decreased when the... 

A new heterogeneous copper catalyst was synthesized by immobilization of copper ions onto magnetic nanoparticles with a new ligand based on triazole. The catalyst was characterized using scanning and transmission electron microscopies, atomic absorption and Fourier transform infrared spectroscopies, and thermogravimetric, elemental and energy-dispersive X-ray analyses. The results confirmed that a good level of organic groups was immobilized on the magnetic nanoparticles. Huisgen cycloaddition reaction was chosen as a model reaction for the investigation of catalyst activity under green conditions. Phenylacetylene and benzyl bromide derivatives were used for the synthesis of triazoles. The... 

The pyrolysis of low-volatile Tabas anthracite coal was investigated by thermogravimetric technique (TGA) in the temperature range from ambient to 1100 °C under non-isothermal heating conditions (1.5, 3, and 7 °C/min heating rates). Higher heating rates showed a small retarding effect on devolatilization toward higher temperatures. Iso-conversional method was used for the kinetic study of non-isothermal Thermogravimetric data. Activation energy calculated for coal conversion of 20–80% was about 319 kJ/mol which may be a result of stable ordered structure of this type of coal. Analysis of evolved gases by Fourier transform infrared spectrometry (FTIR) in 7 °C/min heating rate was conducted... 

CaO derived from calcined eggshell was doped with Na–K by wet impregnation method and the effect of different Na/K molar ratios was investigated on biodiesel production from canola oil. The catalysts were characterized by X-ray Powder Diffraction (XRD), Brunauer–Emmett–Teller (BET), Scanning Electron Microscopy (SEM), Energy Dispersive X-ray (EDX), and Thermogravimetric (TGA) analyses. FAME yields were determined by Gas Chromatography-Mass Spectrometry (GC-MS). The Na–K/CaO catalyst with Na/K molar ratio of 1 showed the highest FAME yield of 97.6% at optimum reaction conditions. Structural investigation of materials revealed that FAME yield was proportional to the number of basic sites on... 

The bidentate carboxamide ligand N-(thiazole-2-yl) picolinamide (LH) was synthesized in the environmentally friendly ionic liquid TBAB, and the five-coordinated CuII-complex, [Cu(L)2(H2O)].CHCl3 (1) was synthesized from LH and copper(II)acetate. Cupric oxide [CuO] nanoparticles (2) have been prepared by the thermal decomposition of (1) as a new precursor at 600 °C for 3 h under air atmosphere. (1) was characterised using FT-IR spectroscopy, elemental analyses and its solid state structure was confirmed by single crystal X-ray diffraction. (2) were identified by FT-IR spectroscopy, X-ray powder diffraction, scanning electron microscopy, energy dispersive X-ray analysis and thermo-gravimetric...