Search for: three-phase-model
M.Sc. Thesis Sharif University of Technology ; Naghdabadi, Reza ; Bagheri, Reza
The improved properties of nanocomposites are not achievable with conventional composites. Scale effect is one the most important parameters in the physical and mechanical properties of polymeric nanocomposites. One of the physical phenomena, which can be related to the scale effect, is the very large interface between the nanoparticles and the polymeric matrices. Motional behavior and conformation of polymeric chains change near the nanoparticles surfaces. Due to high interface of the nanoparticles with the polymeric matrices the amount of these types of changes in the polymeric chains are so large that can change the physical and mechanical properties of polymeric nanocomposites. In this...
Mechanical properties and structure of solvent processed novolac resin/layered silicate: Development of interphase region, Article RSC Advances ; Volume 5, Issue 98 , Jun , 2015 , Pages 80875-80883 ; 20462069 (ISSN) ; Shojaei, A ; Sharif University of Technology
Royal Society of Chemistry 2015
Composites of phenol-formaldehyde (PF) resin with Closite Na+ and Closite 30B up to 20 wt% loadings were prepared by solution mixing. Tensile testing showed that both pristine and organically modified clays increased considerably the mechanical properties of PF resin at 2.5 wt% loading followed by marginal improvement or even sacrificed properties at high loadings. DMA and DSC analyses suggested development of a highly crosslinked and well adhered interphase around silicate layers. A novel three-phase model considering the interphase region was proposed to predict composite modulus. The model was successfully employed to correlate morphological characteristics and mechanical properties of...
Article 2009 Asia-Pacific Power and Energy Engineering Conference, APPEEC 2009, Wuhan, 27 March 2009 through 31 March 2009 ; 2009 ; 21574839 (ISSN); 9781424424870 (ISBN) ; Mokhtari, H ; Wuhan University; IEEE Power and Energy Society; Chinese Society for Electrical Engineering; Scientific Research Publishing ; Sharif University of Technology
Load flow problems have always been an important issue in power system analysis and require proper modeling of system components. In this regard Flexible AC Transmission System (FACTS) controllers are modern devices that their modeling specially the series type is a challenging topic. This paper describes a three-phase model for Distributed Static Series Compensator (DSSC) based on extending the Static Synchronous Series Compensator (SSSC) model in Newton power flow. To extend the SSSC model the following two differences must be considered; three completely independent phases and the existence of several modules in a DSSC system. Simulation results on the IEEE 30-bus system and a five bus...