Sharif Digital Repository

This paper seeks to make a study on flow control in two-dimensional square cavities having obstacles on their walls. The goal of using these passive controllers is to enhance mixing in an enclosed space. Lattice Boltzmann method is used to simulate the problem. Results are presented for various Reynolds numbers, 400≤Re≤4000 and different arrangements of tiny-obstacles with different heights. To give a perspective on the physics of this problem, time evolution of the flow is studied at Re= 1000. Then, the flow structure is studied for different Reynolds numbers. Findings show that the interaction of the main vortex with the tiny-obstacles inserted on the wall cavity changes the flow pattern... 

This paper seeks to make a study on flow control in two-dimensional square cavities having obstacles on their walls. The goal of using these passive controllers is to enhance mixing in an enclosed space. Lattice Boltzmann method is used to simulate the problem. Results are presented for various Reynolds numbers, 400≤Re≤4000 and different arrangements of tiny-obstacles with different heights. To give a perspective on the physics of this problem, time evolution of the flow is studied at Re= 1000. Then, the flow structure is studied for different Reynolds numbers. Findings show that the interaction of the main vortex with the tiny-obstacles inserted on the wall cavity changes the flow pattern... 

The concentration distribution and microstructure of NiTi shape memory alloys produced in vacuum induction furnaces operating at high and medium frequencies are compared with those of materials melted in vacuum resistance furnaces. The production procedure consisted of charging pure metals into a graphite crucible; raising the temperature to 1450°C under vacuum; holding the materials in high and medium frequency induction and resistance furnaces for 3, 5, and 120 min under vacuum; and allowing alloys to solidify in the crucibles under the same vacuum. The procedures in each of the three furnaces were made as similar as possible. Chemical composition, microstructure, and surface hardness of... 

The fabrication of TixNi1-x shape memory films using simultaneous magnetron sputtering from two separate, elemental targets was investigated. The films were deposited at room temperature and then annealed at 500 °C to achieve the shape memory effect. The influence of sputtering parameters such as power ratio to the targets (to control the composition) and Ar gas pressure (to control the film structure) were studied. It was found that the Ar gas pressure had a critical influence on the shape memory effect of the films. Characterization of the films was carried out by energy dispersive X-ray spectroscopy in a scanning electron microscope (to measure the film composition and uniformity), in...