Sharif Digital Repository

The effect of temperature and impeller speed on the performance of induced gas flotation (IGF) systems for the removal of oil from produced water in different ranges (5-300 g/L) of total dissolved solids (TDS) was investigated in a pilot plant study. Furthermore, it was evaluated whether the IGF pilot plant effluent could reach the 15 mg/L outlet oil content as required by Article VI of the Kuwait Convention for Persian Gulf region, before being discharged to the sea. The results showed that oil removal efficiencies up to 90% could be reached at high temperature (80°C) in just one single flotation cell without adding any chemicals. Flotation unit, however, should be followed by at least one... 

With the decline in oil discoveries over recent decades, it is believed that enhanced oil recovery (EOR) technologies will play a key role to meet energy demand in the coming years. Polymer flooding is used commonly worldwide as an EOR process. In this work, we propose the synthesis of protected polyacrylamide (PAM) nanoparticles (PPNs) with a hydrophobic polystyrene (PSt) shell by one-pot two-step inverse emulsion polymerization, in which the PSt shell was created by surface polymerization. The shell protects the active PAM chains from premature degradation caused by the harsh environment in the reservoirs, controls the release of the chains as rheological modifiers, and additionally, it... 

Water quality is one of the most important factors contributing to a healthy life. From the water quality management point of view, TDS (total dissolved solids) is the most important factor and many water developing plans have been implemented in recognition of this factor. However, these plans have not been perfect and very successful in overcoming the poor water quality problem, so there are a good volume of related studies in the literature. We study TDS and the water flow of the Karoun river in southwest Iran. We collected the necessary time series data from the Harmaleh station located in the river. We present two Univariate Seasonal Autoregressive Integrated Movement Average (ARIMA)... 

Two main reservoir mechanisms that impact oil recovery factors are wettability alteration and interfacial tension (IFT) change. In this study, these two key mechanisms are evaluated experimentally for samples from the Asmari (carbonate) oil reservoir utilizing silica nanoparticles in the presence of low-salinity water. The nanofluid, rock formation and crude oil samples were prepared meticulously to ensure meaningful experimental could be conducted over a range of low-salinity conditions. The results show that across the range of salinities studied, the absolute value of zeta potential of nanofluids decreases with increasing total dissolved solids (TDS) in the water treated with silica... 

Dynamic hydrosalinity models are available, but are not used extensively on a large scale soil which receives wastewater from industrial areas, partly because adequate database are expensive to be obtained. Thus, for this reason, there is an urgent need to assess the salt and other pollutant loads collected in wastewater flows into the soil and/ or ground water systems. A conceptual hydrosalinity model was used on two major underlying principals of mass balance and steady state. This model was initially tested on the 4,117 km2 plains west of the Yazd-Ardakan district in the central part of Iran. This model was used at a time when the soil and ground water salinity problem was serious due to... 

Water-quality modeling and prediction is a complicated task because of inherent randomness and uncertainties associated with various processes and variables throughout the stream environment and the lack of appropriate data. Hence, the results of mathematical models are always approximate, lying within an uncertainty. This paper describes and demonstrates the application of the U.S. Environmental Protection Agency's water-quality model, QUAL2E-UNCAS, to the Zayandeh-Rood River in Iran. First-order reliability analysis is used to examine the variability of predicted water-quality parameters of total dissolved solids, dissolved oxygen, and biochemical oxygen demand. This analysis also...