Sharif Digital Repository

In this work the effect of composition changes of the injection gas (Hydrocarbon gas + carbon dioxide) on Water Alternating Gas (WAG) performance in immiscible flooding which has been rarely attended in the available literature is investigated. Core flood experiments are conducted on a 10 cm length Sarvak sandstone core sample at 46 degree C and at immiscible condition, i.e., below the minimum miscible pressure (MMP) of the oil sample using pure CO2 as injected Gas.The influence of injection WAG ratio on oil recovery also is investigated. Artificial injection brine which is made by dissolving NaCl into distilled water with 5000 ppm (mg/L), NaftShahr oil which has about 41 API gravity and... 

Increasing the global demand for energy and decreasing the production rate of oil reservoirs have forced the oil companies to focus on enhanced oil recovery (EOR) extensively. This paper summarizes the design, reservoir simulation, and results of different gas injection scenarios in one of the Iranian complex oil reservoirs. This complex reservoir is located in the south west of Iran and is made up of sandstone, limestone, and dolomite layers. It is an under saturated reservoir with no gas cap but with a strong aquifer. Oil production has started in 1977, but due to strong aquifer the production is still in the plateau period. In this study, by simulation, it is estimated that natural... 

Most of the Iranian oil reservoirs are reaching end of their natural production life, hence they are suitable candidates for EOR common processes like gas injection and WAG injection. Studies have shown that gas and WAG injection can be applied for optimal oil production. Past studies have been mainly on gas and WAG injection in immiscible or fully miscible conditions and there is a limited amount of data available on performance of these methods in near miscible conditions. Miscible injection is not feasible in old Iranian oil reservoirs due to their depleted pressure. Moreover injection in lower pressures is attractive from both economical and operational standpoints since this reduces the... 

Considering that hydrocarbon production, reduces energy of reservoir and causes part of the valuable compounds remaining in the oil or gas reservoir and can not be extracted by reservoir energy, so optimization of production by control flow rate, drilling new wells and applying lOR and EOR methods in order to increase hydrocarbon recovery is necessary. Gas and water inject through injection well into the reservoir for improve oil recovery. As implementation of different production and injection scenario is very expensive. Simulation of different method and applying the best is very helpful and necessary. In this study we use Eclipse software that is one of the best software that can simulate... 

Gas injection processes are considered as the second largest Enhanced Oil Recovery processes after thermal processes. In Dealing with the problems of Continuous Gas Injection (CGI) processes, the substitute method of Water Alternating Gas (WAG) is gaining ever increasing attention in field applications. The Hybrid method has the advantages both CGI and WAG processes. Laboratory studies of gas injection methods to show the optimum method and the effect of pressure on the performance of this method is the main objective of this project. Results obtained from these tests can be used in the Enhanced Oil Recovery scenarios for this reservoir. In this project, experiments for Continuous Gas...