Loading...
Search for: wide-bandwidth
0.01 seconds

    Performance analysis of time-hopping spread-spectrum multiple-access systems: Uncoded and coded schemes

    , Article IEEE Transactions on Wireless Communications ; Volume 1, Issue 4 , 2002 , Pages 671-681 ; 15361276 (ISSN) Forouzan, A. R ; Nasiri Kenari, M ; Salehi, J. A ; Sharif University of Technology
    2002
    Abstract
    In [Scholtz (1993)], an ultra-wide bandwidth time-hopping spread-spectrum code division multiple-access system employing a binary PPM signaling has been introduced, and its performance was obtained based on a Gaussian distribution assumption for the multiple-access interference. In this paper, we begin first by proposing to use a practical low-rate error correcting code in the system without any further required bandwidth expansion. We then present a more precise performance analysis of the system for both coded and uncoded schemes. Our analysis shows that the Gaussian assumption is not accurate for predicting bit error rates at high data transmission rates for the uncoded scheme.... 

    A compact microstrip combline filter for microwave S-band

    , Article 29th Iranian Conference on Electrical Engineering, ICEE 2021, 18 May 2021 through 20 May 2021 ; 2021 , Pages 891-894 ; 9781665433655 (ISBN) Rezaee, S ; Memarian, M ; Sharif University of Technology
    Institute of Electrical and Electronics Engineers Inc  2021
    Abstract
    In this paper, a wideband coupled-resonator microstrip bandpass filter is designed and experimentally demonstrated in the S-Band. The filter is comprised of quarter-wavelength hair-pin resonators, reducing resonator and filter footprint compared to conventional hairpin designs. Additionally, it is considerably forgiving to fabrication tolerances and yields remarkably close matched results between theory, simulation, and measured results. One demonstration presented has minimal insertion loss ${(< 1{dB})}$ for the entire wide bandwidth of 3.4 GHz to 4.2 GHz. Wider bandwidths up to 60% are also observed using the design. The proposed filter is an attractive solution when space is a critical... 

    A 6-bit active digital phase shifter

    , Article IEICE Electronics Express ; Volume 8, Issue 3 , 2011 , Pages 121-128 ; 13492543 (ISSN) Asoodeh, A ; Atarodi, M ; Sharif University of Technology
    2011
    Abstract
    This paper presents the design of a 6-bit active digital phase shifter in 0.18-μm CMOS technology. The active phase shifter synthesizes the required phase using a phase interpolation process by adding quadrature phased input signals. It uses a new quadrature all-pass filter for quadrature signaling with a wide bandwidth and low phase error. The phase shifter has simulated RMS phase error of <0.85° at 2.4-5 GHz. The average voltage gain ranges from 1.7 dB at 2.4GHz to -0.14 dB at 5 GHz. Input P1 dB is typically 1.3±0.9 dBm at 3.5 GHz for overall phase states  

    A full 360° vector-sum phase shifter with very low rms phase error over a wide bandwidth

    , Article IEEE Transactions on Microwave Theory and Techniques ; Volume 60, Issue 6 PART 1 , 2012 , Pages 1626-1634 ; 00189480 (ISSN) Asoodeh, A ; Atarodi, M ; Sharif University of Technology
    2012
    Abstract
    An innovative vector-sum phase shifter with a full 360° variable phase-shift range in 0.18-μm CMOS technology is proposed and experimentally demonstrated in this paper. It employs an I/Q network with high I/Q accuracy over a wide bandwidth to generate two quadrature basis vector differential signals. The fabricated chip operates in the 2.3-4.8 GHz range. The root-mean-square gain error and phase error are less than 1.1 dB and 1.4° over the measured frequency span, respectively. The total current consumption is 10.6 mA (phase shifter core: ∼2.6 mA) from a 1.8 V supply voltage and overall chip size is 0.87 × 0.75 mm 2. To the best of the authors' knowledge, this circuit is the first...