Loading...

Optimizing the mechanical and physical properties of thermoplastic starch via tuning the molecular microstructure through co-plasticization by sorbitol and glycerol

Esmaeili, M ; Sharif University of Technology | 2017

879 Viewed
  1. Type of Document: Article
  2. DOI: 10.1002/pi.5319
  3. Publisher: John Wiley and Sons Ltd , 2017
  4. Abstract:
  5. Nowadays, environmental hazards caused by plastic wastes are a major concern in academia and industry. Utilization of biodegradable polymers derived from renewable sources for replacing common petroleum-based plastics is a potential solution for reducing the problem. In this regard, starch has become one of the most promising alternatives to non-biodegradable polymers for depleting plastic waste thanks to its low expense, abundance, renewability and biodegradability. However, the main drawbacks of starch are its poor processability, weak mechanical properties and severe hydrophilicity. In this work, thermoplastic starch (TPS) samples have been prepared using glycerol and sorbitol as co-plasticizers in a laboratory co-rotating twin screw extruder. Based on the mechanical test results, glycerol caused higher elongation to break but had lower tensile strength and elastic modulus compared to sorbitol plasticized starch. Fourier transform infrared spectroscopy and DSC results indicated that the hydrogen bond interaction between starch chains and plasticizers could be improved by replacing glycerol by sorbitol, which resulted in higher resistance against retrogradation proved by XRD results. TGA illustrated that the higher the sorbitol to glycerol ratio was, the more stable was the TPS. Using a proper amount of plasticizers (42 wt% total plasticizer, sorbitol to glycerol ratio 2:1) led to the preparation of a TPS sample with optimized properties including enhanced mechanical properties, high thermal stability, strong hydrogen bond formation and high resistance against retrogradation. © 2017 Society of Chemical Industry. © 2017 Society of Chemical Industry
  6. Keywords:
  7. Co-plasticization ; Retrogradation ; Alcohols ; Biodegradability ; Fourier transform infrared spectroscopy ; Glycerol ; Hydrogen bonds ; Mechanical properties ; Plasticizers ; Plastics ; Reinforced plastics ; Solvents ; Starch ; Tensile strength ; Co-rotating twin screw extruders ; Hydrogen bond interaction ; Mechanical and physical properties ; Molecular microstructure ; Non-biodegradable polymers ; Retrogradation ; Sorbitol ; Thermoplastic starch ; Biodegradable polymers
  8. Source: Polymer International ; Volume 66, Issue 6 , 2017 , Pages 809-819 ; 09598103 (ISSN)
  9. URL: https://onlinelibrary.wiley.com/doi/abs/10.1002/pi.5319