Loading...

Sensor performance of nanostructured TiO2 thin films derived from particulate sol-gel route and polymeric fugitive agents

Mohammadi, M. R ; Sharif University of Technology | 2007

288 Viewed
  1. Type of Document: Article
  2. DOI: 10.1016/j.snb.2006.11.048
  3. Publisher: 2007
  4. Abstract:
  5. High specific surface area (SSA) nanocrystalline powders and dip-coated TiO2 thin films have been prepared by a particulate sol-gel route with added polymeric fugitive agents (PFAs), namely trehalose dihydrate (THD), polyethylene glycol (PEG6000) and hydroxypropyl cellulose (HPC). One of the highest SSA reported in the literature, obtained without PFA, was achieved (i.e., 181 m2/g), a value that could be increased up to 304 m2/g, 274 m2/g and 200 m2/g for PEG/TiO2, HPC/TiO2 and THD/TiO2 powders, respectively. Furthermore, the crystallite size varied from 1 nm for as-produced powders up to 4 nm for powders heat-treated at 600 °C. Thin films produced under optimised conditions showed excellent microstructural properties for gas sensing applications. They exhibited a stable and reproducible response towards CO and NO2 at a low operating temperature of 200 °C. Calibration curves revealed that all sensors followed the power law (S = A[gas]B) (where S is sensor response, and coefficients A and B are constants) for the two kinds of gases and they have good capability for the detection of low gas concentrations (25 ppm CO and 0.5 ppm NO2). Amongst all sensors, HPC/TiO2 sensor showed the highest response towards CO ≤ 100 ppm and NO2 ≤ 2 ppm, whereas PEG/TiO2 sensor had the highest response towards CO > 100 ppm and NO2 > 2 ppm operated at 200 °C. The response of the sensors to both CO and NO2 changed with operating temperature reaching a maximum at a specific temperature. Moreover, the sensor response decreased by increasing the film annealing temperature. The response magnitude and response time of the sensors obtained in this work are superior to those reported in previous studies. Furthermore, their low power consumption as a result of their low operating temperature manifests their good potential for industrial application. © 2006 Elsevier B.V. All rights reserved
  6. Keywords:
  7. Chemical sensors ; Mesoporous materials ; Nanostructured materials ; Polyethylene glycols ; Sol-gel process ; Titanium dioxide ; Calibration curves ; Gas sensing ; Hydroxypropyl cellulose (HPC) ; Polymeric fugitive agents (PFA) ; Thin films
  8. Source: Sensors and Actuators, B: Chemical ; Volume 124, Issue 1 , 2007 , Pages 74-83 ; 09254005 (ISSN)
  9. URL: https://www.sciencedirect.com/science/article/abs/pii/S0925400506007994