Sharif Digital Repository

Recently, considerable attentions have been paid to alloy Mg-4Zn-0.2Ca for biomedical applications due to its suitable biocompatibility and acceptable mechanical properties. In this work, the effects of the addition of different amounts of Al on microstructure, mechanical properties, degradation behavior, and biocompatibility of this alloy were investigated. The corrosion behaviors of the alloys were investigated through polarization tests, chronoamperometry analysis, immersion tests, and EIS experiments. The mechanical properties were analyzed by using tensile tests and compression tests. The results showed that the addition of Al up to 3 wt.% considerably modifies the degradation behaviors... 

The Multi-walled carbon nanotube (MWCNT)/WO3 nanocomposite thin films with different MWCNT's weight percentages were prepared by sol-gel method as visible light induced photoanode in water splitting reaction. Weight percentage of MWCNT in the all nanocomposite thin films was confirmed by TGA/DSC analysis. According to XPS analysis, oxygenated groups at the surface of the MWCNT and stoichiometric formation of WO3 thin films were determined, while the crystalline structure of the nanocomposite samples was studied by XRD indicating (0 0 2) peak of MWCNT in the monoclinic phase of WO3. The influence of different weight percentage (wt%) of MWCNT on WO3 photoactivity showed that the electron... 

Nickel-modified glassy carbon electrode (GC/Ni) prepared by galvanostatic deposition was used for the electrocatalytic oxidation of glucose in alkaline solutions where different electrochemical methods were employed. In cyclic voltammetry studies, in the presence of glucose an increase in the peak current of the oxidation of nickel hydroxide is followed by a decrease in the corresponding cathodic current. This suggests that the oxidation of glucose is being catalyzed through mediated electron transfer across the nickel hydroxide layer comprising nickel ions of various valence states. Under the chronoamperometric regime, the reaction followed a Cottrellian behavior and the diffusion... 

Nickel modified graphite electrodes (G/Ni) prepared by galvanostatic deposition were examined for their redox process and electrocatalytic activities towards the oxidation of methanol, ethanol, 1-propanol and 2-propanol in alkaline solutions. The methods of cyclic voltammetry (CV), chronoamperometry (CA) and impedance spectroscopy (EIS) were employed. In CV studies, the electrochemical response, peak current varied in the order of MeOH > EtOH > 1-PrOH > 2-PrOH. Under the CA regime, a higher catalytic rate constant obtained for methanol oxidation was in agreement with CV measurements. Lower charge transfer resistance was obtained for low carbon alcohols oxidation and significantly higher... 

Electro-oxidation of methanol in alkaline solution at a glassy carbon electrode electrochemically modified by a conductive polymeric meso-tetra(4-carboxyphenyl)porphyrinato nickel(II), abbreviated as poly-NiTCPP and also meso-tetra(4-carboxyphenyl)porphyrin with incorporated nickel(II) cations, abbreviated as, poly-TCPP/Ni, were investigated and compared. Both films were prepared by oxidative electro-polymerization of complexes by repetitive cyclic voltammetry (RCV) in 0.1 M NaOH aqueous solution. The electrochemical properties and behaviors and also kinetic values of both films have been characterized and compared using cyclic voltammetry (CV), chronoamperometry (CA) and electrochemical... 

The most applications of gold nanoparticles are in the photo-electronical accessories and bio-chemical sensors. Chloride solution with cysteine additive was used as electrolyte in gold nanoparticles electrodeposition. The nucleation and growing mechanism were studied by electrochemical techniques such as cyclic voltammetry and chronoamperometry, in order to obtain a suitable nano structure. The deposition mechanism was determined as instantaneous nucleation and the dimension of particles was controlled in nanometric particle size range. Atomic Force Microscope was used to evaluate the effect of cysteine on the morphology and topography of gold nanoparticles. Finally the catalytic property of... 

Carbon nanotubes were electrodeposited in acetonitrile solution at room temperature using Cu, and Fe-Ni nanoparticles as nucleation sites on HF-etched Si(100) wafer substrate. The electrochemical behavior of the deposition was investigated by voltammetry and chronoamperometry techniques. In order to obtain the optimum growth condition, the deposition critical parameters including current density range, potential and time were studied and calculated. Carbon nanotubes with approximate external diameter of 40-100 nm were fabricated under potentiostatic condition and diffusion control at - 20 V in 4-6 h. The film crystallinity was investigated by means of X-ray diffraction and the tubes... 

Electro-oxidation of alcohols (methanol, ethanol, 1-propanol and 2-propanol) on nickel dispersed into a thick layer of poly-o-aminophenol on graphite electrode (GE/POAP-SDS/Ni) was investigated. Ni-doping into the polymeric film was achieved chemically followed by enrichment of Ni(III) through cycling the potential. The electro-oxidation of alcohols on GE/POAP-SDS/Ni were found to be dominated by direct electro-oxidation with some contribution from Ni(II)/Ni(III) couple. Rate constants for the electro-oxidation of methanol, ethanol, 1-propanol and 2-propanol as derived by chronoamperometry were 1.65 × 105, 1.31 × 105, 2.53 × 104 and 1.40 × 104 cm3 mol-1 s-1, respectively. Impedance... 

The electrocatalytic oxidation of methanol was studied over Ni, Co and Cu binary or ternary alloys on graphite electrodes in a NaOH solution (0.1 mol/L). The catalysts were prepared by cycling the graphite electrode in solutions containing Ni, Cu and Co ions at cathodic potentials. The synergistic effects and catalytic activity of the modified electrodes were investigated by cyclic voltammetry (CV), chronoamperometry (CA) and electrochemical impedance spectroscopy (EIS). It was found that, in the presence of methanol, the modified Ni-based ternary alloy electrode (G/NiCuCo) exhibited a significantly higher response for methanol oxidation compared to the other samples. The anodic peak... 

Platinum nanowires (PtNWs) were electrodeposited on the polycarbonate templates (PCTs) in aqueous solution of H2PtCl6 in triply distilled water. Nanowires with diameters of 50 and 100 nanometers were electrodeposited on the same condition. The kinetics of electrodeposition process was studied by electrochemical techniques such as voltammetry and chronoamperometry methods. Increasing the scan rate, the peaks shifted to more negative potentials and the current density also increased in each peak which was typical for a diffusion-control process. The potential range for the deposition of platinum nanowires was specified and consequently the potentiostatic i-t transients were utilized to produce... 

A stable copper (hydr)oxide-modified electrode was prepared in 0.5 mol/L NaOH solution by cyclic voltammetry in the range of -250 to 1000 mV. It can be used for electrochemical studies in the range of -250 to 1000 mV without interfering peaks because there is no oxidation of copper. During an anodic potential sweep, the electro-oxidation of saccharose on Cu occurred by the formation of CuIII and this reaction also occurred in the early stages of the reversed cycle until it is stopped by the negative potentials. A mechanism based on the electro-chemical generation of CuIII active sites and their subsequent consumption by saccharose was proposed, and the rate law and kinetic parameters were... 

Nickel and nickel-manganese alloy modified graphite electrodes (G/Ni and G/NiMn) prepared by galvanostatic deposition were examined for their redox process and electrocatalytic activities towards the oxidation of methanol in alkaline solutions. The methods of cyclic voltammetery (CV), chronoamperometry (CA) and impedance spectroscopy (EIS) were employed. In CV studies, in the presence of methanol NiMn alloy modified electrode shows a significantly higher response for methanol oxidation. The peak current of the oxidation of nickel hydroxide increase is followed by a decrease in the corresponding cathodic current in presence of methanol. The anodic peak currents show linear dependency upon the... 

Electrochemical oxidation of l-ascorbic acid on polycrystalline silver in alkaline aqueous solutions is studied by cyclic voltammetry (CV), chronoamperometry (CA) and impedance spectroscopy (IS). The anodic electro-oxidation starts at -500 mV versus SCE and shows continued anodic oxidation in the cathodic half cycle in the CV regime signifying slowly oxidizing adsorbates. Diffusion coefficient of ascorbate ion measured under both voltammetric regimes is around 1.4 × 10-5 cm2 s-1. Impedance spectroscopy measures the capacitances associated with double layer and adsorption around 50 μF cm-2 and 4 mF cm-2 as well as the adsorption and decomposition resistances (rates). © 2009 Elsevier B.V. All... 

The electrocatalytic oxidation of hydrazine was studied over Ni, Cu, Co and Ni-based ternary alloy on graphite electrodes in alkaline solution. The catalysts were prepared by cycling the graphite electrode in solutions containing Ni, Cu and Co ions at cathodic potentials. The synergistic effects and the catalytic activity of the modified electrodes were investigated by cyclic voltammetry (CV), chronoamperometry (CA) and electrochemical impedance spectroscopy (EIS). It was found that, in the presence of hydrazine, the modified Ni-based ternary alloy electrode (G/NiCuCo) exhibited a good catalytic activity for the oxidation of hydrazine at a reduced overpotential and it has a significant high... 

Polyaniline/graphene oxide (PANI/GO) co-doped with Zn2+ and Fe3+ was synthesized via a simple and low cost one-step chronoamperometry method on stainless steel (SS) as the substrate. The Fe3+-Zn2+-PANI/GO nanocomposite is characterized using X-ray diffraction as well as Fourier transform infrared spectroscopy, energy-dispersive X-ray spectroscopy, transmission electron microscopy, and field emission scanning electron microscopy. Also, cyclic voltammetry, galvanostatic charge-discharge, and electrochemical impedance spectroscopy are used to study the electrochemical performance of the as-prepared electrode materials. Significantly, the Fe3+-Zn2+-PANI/GO nanocomposite exhibits a specific... 

Abstract: The electrodeposition of platinum nanoparticles (PtNPs) on multiwall carbon nanotubes (MWCNTs)/fluorine-doped tin oxide glass (FTO) was investigated. Nucleation and growth mechanisms were studied via Scharifker and Hills model. Chronoamperometry results clearly show that the electrodeposition processes are diffusion-controlled and the diffusion coefficient is 1.5×10-5cm2/s. The semi-spherical particles with lamellar morphology were observed in 1M H 2SO 4, while a petal shape was discerned in 0.5M H 2SO 4. Also, dispersion, size, and uniformity of PtNPs were investigated, where the finer distribution of PtNPs with the average size less than 100 nm was obtained in 0.5M H 2SO 4... 

Hydrogen storage/evolution behavior of nafion/NaCl/graphene quantum dot (GQD) mixed matrix as selective hydrogen capacitor (power source) was evaluated in detail through an electrochemical process at two independent potential ranges. For this purpose, a three-electrode system included Pt disk as counter electrode, Ag/AgCl as reference electrode and GQD-based mixed matrix-modified Pt disk as working electrode. For hydrogen storage, the deposition potential and time were evaluated to −1.0 V (vs. Ag/AgCl) and 120 s, respectively under high basic solution generated using NaOH (1.0 M) solution, followed by evolution of hydrogen at +0.8 V (vs. Ag/AgCl) during formation of hydrogen bubbles. The...