Sharif Digital Repository

This paper presents an RF Front-END for an 860-960thinspaceMHz passive RFID Reader. The direct conversion receiver architecture with the feedback structure in the RF front-end circuit is used to give good immunity against the large transmitter leakage and to suppress leakage. The system design considerations for receiver on NF and IIP3 have been discussed in detail. The RF Front-END contains a power amplifier (PA) in transmit chain and receive front-end with low-noise amplifier, up/down mixer, LP filter and variable-gain amplifier. In the transmitter, a differential PA with a new power combiner is designed and fabricated in a 0.18-μm technology. The chip area is 2.65 mm × 1.35 mm including... 

In this paper, a new fully analog technique is proposed by means of which the adverse effects of frequency dependent gain/phase errors in quadrature transmitters are suppressed. Two separate phase and gain mismatch cancellation loops are implemented which search for the minimum side-band component. A new sign detection method is also introduced which makes sure the direction of the loop is correct. Analytical models and mathematical derivations have been presented which corroborates the circuit implementation. A proof of concept prototype using off-the-shelf components have also been measured which suggests 38-dB side-band rejection (SBR). Furthermore, the measured TX EVM and BER are... 

A dynamic model of oxidation of methane to methanol has been developed in a fixed-bed reactor applying V2O5/SiO2 as the reaction catalyst. The standard k-? model with 10% turbulence amount performed. The effects of temperature (450- 500°C) and pressure (20-120 bar) with residence time of 3 seconds, on methane conversion and methanol or formaldehyde selectivity examined. Oxygen used as an oxidant and the amount of oxygen in feed was 5% mol/mol of methane amount. The results showed with increasing the conversion of methane from 0.66 to 1.52%, the selectivity to methanol decreased from 93.4% to 91.9%. The CFD modeling results showed reasonable agreement with the obtained experimental data of... 

A compact low power circuit for implementation of a direct conversion OQPSK modulator is proposed. The circuit consists of a digital to analog converter, a low pass filter and an up-converter mixer. By embedding these three blocks, the circuit performance is enhanced and the total power consumption is reduced. The mixer is designed base on a Gilbert cell with on chip inductor loads. Instead of transconductance transistors of Gilbert cell, a fully deferential current mode DAC is used and proficiently a low pass filter is embedded between them and therefore the linearity of total system is improved. All of circuits are designed based on 0.18 μm CMOS technology with a single 1.8 volt power... 

Direct conversion of methane to methanol is a more recently developed technique by which the intermediate and expensive process of formation of synthesis gas is eliminated. On the other hand, fluidized-bed technology for heterogeneous reversible reactions posses a couple of key advantages in comparison to the commonly used fixed bed reactors. These include, pore diffusion resistances being largely eliminated due to small catalyst pellet sizes utilized. In other words, industrial fixed bed pellets are in the order of 6-12 mm diameter, whereas fluidized catalyst used may be smaller than 100 μm. In addition, equilibrium limitations induced by the reversibility of the reaction(s) are broken in...