Sharif Digital Repository

Dynamic hydrosalinity models are available, but are not used extensively on a large scale soil which receives wastewater from industrial areas, partly because adequate database are expensive to be obtained. Thus, for this reason, there is an urgent need to assess the salt and other pollutant loads collected in wastewater flows into the soil and/ or ground water systems. A conceptual hydrosalinity model was used on two major underlying principals of mass balance and steady state. This model was initially tested on the 4,117 km2 plains west of the Yazd-Ardakan district in the central part of Iran. This model was used at a time when the soil and ground water salinity problem was serious due to... 

Semiconducting lead sulfide film was deposited on Stainless Steel (SS) electrode by cyclic voltammetry (CV) at room temperature. Electrochemical impedance spectroscopy (EIS) and cyclic voltammetry were used to investigate the electrochemical properties of PbS film in Na2SO4 solution. The voltammetric results showed that oxidative dissolution of PbS film occurred at about 0.21 V vs. Ag/AgCl and total film detachment from the surface occurs with increasing potential. It is concluded that the electrode surface was not passivated by sulfur produced from oxidative dissolution of PbS film. Also, cathodic reduction of the film continued to beyond the hydrogen evolution at -1.35 V vs. Ag/AgCl.... 

Effects of cooling slope angle and the temperature of molten metal on the globular structure of M2 high speed steel after holding at the semisolid state have been investigated. The globular structure was achieved by pouring the molten metal at 1595 °C on the ceramic cooling slope with the length of 200 mm and the angle of 25°. The globular structure of M2 high speed steel in the form of rolled-annealed and as cast condition after holding at semisolid state has been achieved. The size of globular grains of cooling slope sample was smaller than that of the rolled-annealed and as cast samples. Solid particles of rolled-annealed sample after holding at semisolid state had better roundness... 

The globular structure of M2 high speed steel in the rolled - annealed and as cast conditions was investigated in the semisolid state. Metallographic observations resulted in globular austenite particles that were surrounded by a liquid phase. Dissolution of various carbides in the austenite phase at semisolid temperatures led to grain boundary liquation and formation of near-spherical solid grains in a liquid matrix. Therefore, at the semisolid state, the solid particles were free from carbides. MC-type and M6C-type eutectic carbides re-precipitated at the grain boundaries during cooling of the samples from the semisolid temperature. The variation of shape factor versus holding time and... 

The current study proposes a simple constitutive model that integrates the kinetics of precipitation during static aging and the kinetics of precipitate dissolution during preheating to deformation temperature to predict the hot flow behavior of AA6063 alloy. The model relates the flow behavior of the age-hardenable alloy to the alloy chemistry, thermal history as well as deformation temperature, strain, and strain rate by means of a physically based model. Different aging conditions, including supersaturated solid solution and overaging conditions with different deformation parameters, were assessed. Each part of the model was in good agreement with those of experimental and other model... 

Hydroxyapatite (HAp) nanostrips were rapidly obtained during a mild microwave heating method. Applying microwave irradiation to Ca(NO3)2·4H2O/CTAB/Na2HPO4 precursor solution, the HAp precipitation process was occurred directly and without common crystallographic transformations including dissolution and slow recrystallization. The cationic surfactant CTAB was used as a soft template to modify nucleation and growth process. TEM investigations showed that the fabricated nanostrips had a width and length of about 10 and 55 nm, respectively. The X-ray diffraction pattern revealed that the fabricated well-crystallized and high purity hydroxyapatite nanostrips had a pattern similar to the bone... 

Gradual chemical (displacement) reaction between CuO and Al powders during high-energy attrition milling under a high purity argon atmosphere was studied. Differential thermal analysis (DTA), X-ray diffraction (XRD) and transmission electron microscopy (TEM) techniques were employed to study the solid-state reaction. It was shown that the solid-state reaction occurred during mechanical alloying (MA) and resulted in the dissolution of copper into the aluminum lattice and formation of nanometric alumina particles. The reinforcement particles were mostly distributed at the grain boundaries of Al matrix with an average crystallite size of about 50 nm. In DTA curve of the milled powders, a small... 

The high amount of base metals poses an important challenge in gold bioleaching from spent printed circuit boards (PCBs). This study aims to investigate the bioleaching of important base metals (Cu, Ni, and Fe) from a mixture of spent PCBs (E-waste) using adapted Acidithiobacillus ferrooxidans in the bubble column bioreactors. Firstly, the adaptation process is done from 1 to 15 g/L in Erlenmeyer flasks in 187 days, then the concentration of E-waste increased to 40 g/L in bubble column bioreactors in 44 days. The concurrent recovery of copper, nickel, and iron using adapted bacterium in a bioreactor was optimized by central composite design. Various effective parameters such as aeration... 

The main purpose of this paper is modeling and simulation of in-situ releasing of smart nano-sized core-shell particles at the water-oil interface during polymer flooding. During the polymer flooding process, when these nano-particles reach the water-oil interface, migrate to the oil phase and the hydrophobic layer of them dissolves in this phase. After dissolution of this protective nano-sized layer, the hydrophilic core containing a water-soluble ultra high molecular weight polymer diffuses back into the water phase and with dissolving in this phase, dramatically increases viscosity of flooding water in the neighborhood of the water-oil interface. In this study, two different... 

Two-segmented gold-copper nanorods were electrodeposited inside the pores of polycarbonate track-etched membranes from two separate solutions. The PCT membranes were dissolved in dichloromethane (CH2Cl2) and the solvent was replaced by methanol solution. Optical absorption spectra of two-segmented Au-Cu nanorods dispersed in methanol showed two peaks which were related to the transverse mode of copper and the longitudinal mode of gold. By increasing the length of the gold segment, when the total length of both metals was fixed at 1 μm, the copper and gold peaks shifted to the blue and red wavelengths, respectively. We observed that the wavelengths of the extinction peaks are not in good... 

Platinum content of two commercial spent reforming catalysts were extracted in aqua-regia solutions under atmospheric pressure and at temperatures up to 100 °C. Three factors, including presence of coke, catalyst particle size, and impeller agitation speed were first tested to study the relative importance of mass-transfer resistances during Pt extraction reaction. Catalyst particle sizes < 100 μm and agitation speeds > 700 rpm eliminated the internal and external mass-transfer resistances, respectively. The effect of other factors, including HNO3-to-HCl volume ratio, liquid-to-solid mass ratio, and the reaction temperature on the extraction rate of platinum were then examined. Pt extraction... 

The Ni-P/Zn-Ni compositionally modulated multilayer coatings CMMCs were electrodeposited from a single bath by switching the deposition current density. The corrosion resistance of the deposits was studied and compared with that of monolayers of Ni-P and Zn-Ni alloys via Tafel polarization, EIS and salt spray tests. Characterization of corrosion products by means of EDS and XRD revealed more details from the corrosion mechanism of the monolayers and multilayers. The corrosion current density of Ni-P/Zn-Ni CMMCs were around one tenth of Zn-Ni monolayer. The CMMC with incomplete layers performed lower polarization resistance and higher corrosion current density compared to the CMMC with... 

Purpose. Drug release from nanosystems at the sites of either absorption or effect biophase is a major determinant of its biological action. Thus, in vitro drug release is of paramount importance in gaining insight for the systems performance in vivo. Methods. A novel in vitro in vivo correlation, IVIVC, model denoted as double reciprocal area method was presented and applied to 19 drugs from 55 nano formulations with total 336 data, gathered from literature. Results. The proposed model correlated the in vitro with in vivo parameters with overall error of 12.4 ± 3.9%. Also the trained version of the model predicted the test formulations with overall error of 15.8 ± 3.7% indicating the... 

Dissolved air precipitation/solvent sublation (DAP/SS) was used for treatment of simulated and real oilfield produced water to generate very fine bubbles which are necessary for effective separation. In this method micro bubbles produced by saturation of air in a pressurized packed column were released in an atmospheric column leading the bubbles to raise resulting trapped contaminants in the Gibbs layer around them to be removed by a layer of immiscible solvent at the top of column. The method was conducted to solutions including Benzene, Toluene and Chlorobenzene (ClB) as part of BTEX contaminants in produced water, mixture of them as simulated produced water and real oilfield produced... 

The spatiotemporal dynamic of salinity concentration (SC) in saline lakes is strongly dependent on the rate of water flow into the lake, water circulation, wind speed, evaporation rate, and the phenomenon of salt precipitation and dissolution. Although in-situ observations most reliably quantify water quality metrics, the spatiotemporal distribution of such data are typically limited and cannot be readily extrapolated for either long-term projections or extensive areas. Alternatively, remotely sensed imagery has facilitated less expensive and a stronger ability to estimate water quality over a wide range of spatiotemporal resolutions. This study introduces an adaptive learning model that... 

In this article, oxygen barrier properties of nanocomposite films composed of organoclay (OC), high-density polyethylene (HDPE), and ethylene vinyl acetate (EVA) copolymer have been investigated. The nanocomposite films whose EVA forms a dominant fraction were prepared using the solution method. The dispersion of the OC in the HDPE/EVA blend was improved through taking two-step procedure in the preparation of nanocomposite. First, the OC and EVA were dissolved in chloroform. Then, the resulting product, after evaporating most of the solvent, along with HDPE was dissolved in xylene. The obtained nanocomposite films underwent a number of tests in order to examine their barrier properties... 

The leaching kinetics of stibnite in basic solution has been investigated. Spherical pellets of antimony sulphide were dissolved in 1 molar sodium hydroxide solutions at different temperatures. It was found that the shrinking core with ash layer model could satisfactorily explain the dissolution process. Using this model, it was found that initially the rate controlling step was a chemical reaction with activation energy of 10.2 kJ/mol. As the ash layer built up, diffusion through the ash layer became the rate controlling step. The activation energy for this step was found to be 33.4 kJ/mol. It was also observed that smaller particle size, larger solid to liquid ratio, and higher NaOH... 

Understanding controls of P movement through watersheds are essential for improved landscape management in intensively managed regions. Here, we analyze observational data from 104 gaged river sites and 176 nongaged river sites within agriculturally dominated watersheds of Minnesota, USA, to understand the role of landscape features, land use practices, climate variability, and biogeochemical processes in total, dissolved and particulate P dynamics at daily to annual scales. Our analyses demonstrate that factors mediating P concentration-discharge relationships varied greatly across watersheds and included near-channel sediment sources, lake and wetland interception, assimilation by algal P,... 

Enhanced Oil Recovery from carbonate reservoirs is a major challenge especially in naturally fractured formations where spontaneous imbibition is a main driving force. The Low Salinity Water Injection (LSWI) method has been suggested as one of the promising methods for enhanced oil recovery. However, the literature suggests that LSWI method, due to high dependence on rock mineralogy, injected and formation water salt concentration, and complexity of reactions is not a well-established technology in oil recovery from carbonate reservoirs. The underlying mechanism of LSWI is still not fully understood. Due to lack of LSWI study in free clay dolomite fractured reservoir, and to investigate of... 

Zinc exists as smithsonite and hemimorphite in the lead flotation tailings from the Dandi mineral processing plant in north western Iran. In this research, zinc-rich tailings produced in the Dandi plant were characterized mineralogically and a leaching study was carried out to assess the effect of several parameters on the kinetics of zinc dissolution. Parameters studied included: sulfuric acid concentration, reaction time, temperature and slurry density. It was found that leaching is controlled by a single rate-controlling step with an activation energy of 23.5 kJ/mol. To overcome some of the filtration problems associated with polymerization of silicic acid, lime was added as a coagulant....