Sharif Digital Repository

The interfacial properties of crude oil are highly complex and are not yet well understood. This study aimed to evaluate the effect of temperature (30-80°C) and pressure (3.44-27.58MPa) on the dynamic interfacial tension (IFT) of crude oil/aqueous solutions consisting of 15000ppm of salt containing different chloride anions, e.g. NaCl, KCl, MgCl2, and CaCl2. To reach this goal, several parameters, such as dynamic and equilibrium IFT, adsorption time, diffusivity of resin, and asphaltene as surface-active agents from bulk of crude oil towards fluid/fluid interface and surface excess concentration of them at the interface, were compared as a function of temperature, pressure, and ion type. The... 

The interfacial properties of crude oil are highly complex and are not yet well understood. This study aimed to evaluate the effect of temperature (30–80 °C) and pressure (3.44–27.58 MPa) on the dynamic interfacial tension (IFT) of crude oil/aqueous solutions consisting of 15 000 ppm of salt containing different chloride anions, e.g. NaCl, KCl, MgCl2, and CaCl2. To reach this goal, several parameters, such as dynamic and equilibrium IFT, adsorption time, diffusivity of resin, and asphaltene as surface-active agents from bulk of crude oil towards fluid/fluid interface and surface excess concentration of them at the interface, were compared as a function of temperature, pressure, and ion type.... 

CO2 gas injection is known as one of the most popular enhanced oil recovery techniques for light and medium oil reservoirs, therefore providing an acceptable mass transfer mechanism for CO2–oil systems seems necessary. In this study, interfacial mass transfer coefficient has been evaluated for CO2–normal heptane and CO2–normal hexadecane systems using equilibrium and dynamic interfacial tension data, which have been measured using the pendant drop method. Interface mass transfer coefficient has been calculated as a function of temperature and pressure in the range of 313–393 K and 1.7–8.6 MPa, respectively. The results showed that the interfacial resistance is a parameter that can control... 

This study investigates dynamic interfacial tension (DIFT) of acidic crude oil (ACO) and non acidic/basic crude oils (BCO) + deionized water (DW) as a function of pressure from 500 to 4000 psi, and temperature from 30 to 80 °C using an axisymmetric drop shape analysis (ADSA) technique. DIFTs are also modeled using dynamic adsorption model, mono-exponential decay model, and empirical equations. The results showed that if a reduction in the surface excess concentration due to increasing temperature overlooks the total entropy of the molecules in the system, an increase in IFT would be expected  

The main objectives of this study are to determine the influence of crude oil type, salinity, temperature and pressure on the dynamic interfacial tension (DIFT) of crude oil based on the experiments and modeling approaches. DIFT is also modeled using dynamic adsorption models, mono-exponential decay model as well as empirical equations. The results showed that when temperature increases, unlike deionized water which inversion phase temperature was observed, the equilibrium IFT of crude oils/sea water increases due to reduction of surface excess concentration of natural surfactants at the fluid/fluid interface as a dominant mechanism  

Using our recently developed model, for the first time in the literature, the effect of fluid/fluid and rock/fluid interactions on the performance of Low Salinity Waterflooding (LSWF, as an Enhanced Oil Recovery process) at pore-doublet scale is investigated. The model is incorporated into OpenFOAM and both the Navier-Stokes equation for oil/water two-phase flow and the advection-diffusion equation for ion transport (at both fluid/fluid and rock/fluid interface) are solved via direct numerical simulation (DNS). The model is validated against imbibition and drainage pore-doublet experiments reported in the literature, and then applied to investigate the sole effect of wettability alteration... 

Using our recently developed model, for the first time in the literature, the effect of fluid/fluid and rock/fluid interactions on the performance of Low Salinity Waterflooding (LSWF, as an Enhanced Oil Recovery process) at pore-doublet scale is investigated. The model is incorporated into OpenFOAM and both the Navier-Stokes equation for oil/water two-phase flow and the advection-diffusion equation for ion transport (at both fluid/fluid and rock/fluid interface) are solved via direct numerical simulation (DNS). The model is validated against imbibition and drainage pore-doublet experiments reported in the literature, and then applied to investigate the sole effect of wettability alteration... 

Concerns about climate change have persuaded the researchers to examine CO2 injection in the form of carbonated water (CW) into oil reservoir as a safe and effective CO2 storage and enhanced oil recovery process. Although interfacial tension (IFT) between crude oil and injected fluid has a vital role on the displacement of fluids in porous media, the effect of CO2 and crude oil type on the dynamic IFT of crude oil under different operational conditions is not well understood. Accordingly, this study was carried out to assess the effects of temperature, pressure, crude oil type and CO2 on the dynamic IFT of crude oil/CW. To achieve this goal, two types of crude oil were provided from southern... 

Low salinity waterflooding (LSWF) is a process in which by lowering the ionic strength and/or manipulation of the composition of the injection water, the long term equilibrium in oil/brine/rock system is disturbed to reach a new state of equilibrium through which the oil production will be enhanced due to fluid/fluid and/or rock/fluid interactions. In spite of recent advances in the simulation of the LSWF at core scale and beyond, there are very few works that have modelled and simulated this process at the pore scale specially using direct numerical simulation (DNS). As a result the effects of wettability alteration and/or Interfacial Tension (IFT) change on the distribution of the phases... 

Low salinity water flooding (LSWF) has the potential to enhance the oil recovery by affecting the fluid-fluid and rock-fluid interactions. Therefore, a systematic investigation on the effect of initial wetting state (water-wet or oil-wet) of pure calcite is conducted to study the importance of these interactions on the effectiveness of LSWF. In the case of initially water-wet cores, more oil recovery efficiency is observed for more saline water cases. To shed light on the possible involved mechanisms, dynamic IFT, dynamic contact angle (CA), oil/brine and rock/brine surfaces zeta potentials, and effluent pH are measured. It is shown that the short-term effect of IFT reduction and long-term... 

Dynamic behavior of fluid-fluid interactions can potentially affect the performance of any enhanced oil recovery (EOR) process including low salinity water flooding. In this work, dynamic interfacial tension (IFT) of crude-oil/brine system is measured in a wide range of salinity of sea water (SW), from 50-time diluted sea water (SW50D) to 2-time concentrated sea water (SW2C). Contrary to the most of published IFT trends in the literature, for the system under investigation here, as the brine salinity increases the crude-oil/brine IFT reduces, which cannot be explained using the existing theories. The lack of a physical model to explain the observed phenomena was the motivation to develop a... 

The oscillating drop and bubble analyzer (ODBA) is an experimental set-up based on the measurement of capillary pressure under static and dynamic conditions. It allows studies of slow and fast dynamic surface and interfacial tensions, following different growing and oscillating drop or bubble protocols, as well as determination of the dilational interfacial visco-elasticity of liquid interfacial layers. For the visco-elasticity studies, drops or bubbles are subjected to harmonic oscillations of area or volume in a broad frequency range, and the resulting harmonic capillary pressure response is analyzed by Fourier analysis. Also, transient relaxations can be easily performed, which are of... 

Capillary pressure experiments were performed at the water/hexane interface including adsorption and mass exchange of hexanol under different conditions. The results from growing drop experiments show that instabilities due to Marangoni convection not only depend on the same parameters as have been reported for quasi-static interfaces, such as direction of mass transfer, distribution coefficient and ratio of diffusion coefficients, but also on the experimental conditions such as dispersed phase flow rate, capillary tip size, size of growing drop and its lifetime. Based on a new flow expansion model for mass transfer, a new approach is presented for data analysis, which includes the various... 

In this research purely oscillation fluid flow in two microtubes 150 and 250 μM(3.5 mm length) is studied using computational fluid dynamic (CFD) approach and utilizing a new experimental setup developed for dynamic interfacial tension measurement (capillary pressure technique) in the frequency range between 0.2 and 80 Hz. The experiments are done with pure water at a mean temperature of about 25 °C. The results of oscillatory conditions for microtubes of 0.5 mm in diameter have been compared with experimental results for several frequencies. The computational approach was validated by comparison with experimental data of the continuous constant flow through microtubes and also with... 

The interaction between polymer and surfactant molecules affects the physical properties of liquids, which could be of great importance in an abundance of processes related to drop formation. Polymer and surfactant concentration is a factor that dramatically impacts the shape of molecular networks formed in the fluid bulk and the characteristics of a forming drop. In this study, the deformation and detachment of aqueous carboxymethyl cellulose (CMC) solutions' drops containing different concentrations of sodium dodecyl sulfate (SDS) are studied experimentally. Our purpose is to determine the effects of CMC and SDS concentrations on the parameters related to the formation process, including... 

Carbonated water has been recently proposed as an enhanced oil recovery method for crude oil reservoirs. Interfacial tension (IFT) plays a crucial rule on the displacement of trapped oil ganglia in the porous media. This investigation is designed to systematically assess the dynamic interfacial tension (DIFT) of two different types of crude oils with carbonated water (CW). In addition, the measured experimental data were applied into specified models. The DIFT behavior of acidic and non-acidic crude oil samples/CW and deionized water (DW) are also compared to find the effect of dissolved carbon dioxide in water on IFT. At the next stage, DIFT of all the results were used through three... 

In this way, after experimental measurement of interfacial tension, different models including mono-exponential decay, dynamic adsorption models and empirical equation are used to correlate this time-dependent behavior of interfacial tension (IFT). During the modeling approach, the induction, adsorption, equilibrium, and meso-equilibrium times as well as diffusivity of surface active components known as natural surfactant including asphaltene and resin from crude oil to the interface are obtained. In addition, the surface excess concentration of surface active components at the interface and Gibbs adsorption isotherm are utilized to analyze the measured dynamic IFTs. Finally, the mechanisms...