Sharif Digital Repository

In this study the performance of the conventional activated sludge and the membrane bioreactor systems were investigated and their operations were compared. . A membrane bioreactor and a conventional activated sludge system which includes one aeration basin and one settling tank were designed and constructed. The feed was synthetic and the BOD:N:P ratio was 100:5:1. In order to starting the systems, the sludge supplied from the municipal wastewater treatment plant and inoculated. Then, the inoculated sludge was adapted to treat the starch wastewater with step by step increasing the feed COD. . The performance of two systems investigated in inlet COD=2500 mg/L and four hydraulic retention... 

In the present study, effects of Post Aeration stage on moving bed biofilm reactor (MBBR) sludge and effluent quality was investigated by simulated wastewater. Reactors Volume were 3.2 and 5.9 Liter and their filling-fraction were 53% and 29%, respectively. All tests were done at 2.5 and 4.6 volume fraction, in which organic loading rates (OLR) were 2, 4, 6 g/L.d and Hydraulic retention times (HRT) were 3 and 6 hours. Increasing in HRT results in bioreactor efficiency improvement, the most efficiency values were found 81% and 84% for MBBR and MBBR-PA respectively at HRT of 6 hours and 53% filling-fraction. The greatest effect of post aeration on organic removal rate was obtained at HRT of 3... 

The best method for stabilizing sludge is anaerobic digestion, In addition to reducing the amount of volatile solids; it produces biogas, which can be considered as a sustainable energy source for wastewater treatment plants. However, the most important factor limiting the process of digestion is the sludge hydrolysis, the best way to increase the speed of hydrolysis is to pre-treatment the sludge before entering the digester; One of the most effective pretreatment methods is pre-treatment by ozone gas, This gas, which is highly unstable, quickly reacts with the wall of the bacterial cell and oxidizes it due to its high oxidizing properties And accelerates the process of sludge hydrolysis.... 

An increase of wastewater treatment plants and wastewater treatments methods have increased the importance of selection of best wastewater treatment alternative. This selection should not be merely based on the quality of effluent, but the whole factors (economic, environmental, technical and social factor) should be considered. Different methods for the assessment of wastewater treatment plants is used. For example, life cycle assessment is used for the evaluation of environmental impacts or cost-benefit analysis are used for economic analysis. But, for selection of the most sustainable technology whole factors should be evaluated together. Multi-criteria decision-making methods can be... 

Acidizing as the most frequent stimulation technique in the field, has been extensively used to increase the production rate. Even though acidizing treatments is well established, there is still an inherent risk for self-induced formation damage through incompatibilities of the fluids involved in this process.
A main potential problem during acidizing is the incompatibility of the acid and the reservoir’s crude oil. Acid interaction with crude oil can produce two major damage mechanisms that could offset partially, if not totally the benefit of the acid stimulation. These mechanisms are the rigid film emulsion formation and the acid-sludge precipitation, result in well productivity... 

Clean water is a growing need for humanity all around the Earth. Due to the shortage of clean water resources in most parts of our planet, wastewater treatment and reuse has been of great value in past decades. Much research has been conducted to improve treatment systems. One of the most recent advancements in water and wastewater treatment field is application of membrane bioreactor systems. Despite many advantages of these systems, membrane fouling has been the main drawback since the creation and application of them. The main objective of this research is to investigate the probable fouling reduction and head loss in flat sheet UF membranes due to the application of an anaerobic... 

In this study, the use of a fixed bed of the Kaldnes commercial carrier in the activated sludge system has been investigated. In this way, at zero time, a submerged fixed bed of Kaldnes was placed into a completely mixed activated sludge reactor and its various parameters were investigated during the time. During the experiment, the fixed bed (Kaldnes carriers enclosed in a lace) with 20, 35 and 50 percentage of volumes were compared to regular activated sludge reactors (without any carriers). The studied parameters are COD, DO, MLSS, and P-PO43-. Input COD was changed at concentrations of 1200 and 400 mg/L, and the reactor hydraulic time was adjusted to 10 and 16 hours. It was observed that... 

Membrane bioreactors (MBRs) are a combination of activated sludg and mebrane technology. MBRs have been widely used as an advanced process for urban and industrial wastewater-treatment in recent years. Membrane fouling is the main issue that limits their performance and therefor, many studies have concentrated on testing different ways to mitigate the fouling. Ozonation process, that has been proved to reduce the MBR fouling, is studied in this project. Ozonation can provide the conditions for flocculation and therefor improves mixed-liqure properties. Ozon at two concentrations, 0.2 and 0.9 mg/lit was tested. Although results show little change in COD (chemical oxygen demand), but membrane... 

Acidizing is one of the most effective techniques to remove the formation damage and restore (or even increase) the permeability of the near wellbore region. Although this technique is widely used to resolve the skin problem, it could initiate new damages itself that hinder the fluid flow and decrease the well production, consequently. Acid-oil emulsion and sludge formation are known as two major induced formation damage and the main reasons for the oil well acid treatment failures.When the HCl is reacted with asphaltenic crude oil during matrix acidizing, it results in unexpected damage at the near wellbore region and hinder the fluid flow through certain mechanisms include:
1- Pore... 

Phenolic compounds are hazardous pollutants that are released into environment through wastewater discharges from variety of industries. Although good biodegradability has been reported at low concentrations, but at higher concentrations phenols are known to be antibacterial. In this study the Membrane Biological Reactor (MBR) with submerged hallow fiber membrane was operated at 25±2 ºC and pH=7.5±0.5 to treat a synthetic wastewater containing high phenol concentration (up to 5.9 g/l). Removal efficiency of phenol and COD were evaluated at four various “Hydraulic Retention Times” (HRT) of 24, 12, 8 and 4 hours. To test the tolerance of the bioreactor to phenol concentration various loading... 

Biological treatment is an essential part of wastewater treatment. One of the major problems of the biological treatment systems is a solid separation. Filamentous bulking is a type of solid separation problem that settled sludge volume and the turbidity of the effluent will be increase in bulking condition. The presence of excessive Filamentous bacteria causes filamentous bulking. In this thesis, filamentous bulking were studied to understand this phenomena better and tried to control that with the different methods. This research was conducted in laboratory scale Sequencing Batch Reactor (SBR), conventional activated sludge and conventional activated sludge with anaerobic selector with... 

Study of the recycling of acidic sludge waste produced from oil refineries and its application in road pavements is the one of the most important issues. Disposal of this sludge has always put the nature at risk. In this research, preliminary NPS bitumen was derived through neutralization and processes. NPS was modified by some thermoplastic elastomers such as SEBS, SBS, EVA, … and SBR and NBR rubbers. Also as a ionic and surface modified organoclay, C15A was used in three different weight percent. Rheological and performance behavior of pure bitumen and modified ones was studied using of standard tests for simulating traffic load. Behavior evaluation tests was included dynamic frequency... 

The Oil wells are usually damaged because of the drilling process and production scenarios or fluid injection during EOR processes. These damages would critically affect the rate of production and injectivity of the well in the form of plugging damage. Different methods are used to fix these damages and increase the production flow from the oil wells. One of the most widely used well-stimulation methods to remediate this challenge is well acidizing. Although this method has very high efficiency in improving the ability of wells, if it is not designed and implemented correctly and optimally, it can cause induced damage and even lead to the well shutting. This challenge is especially reported... 

This study deals with the treatment of medium density fiberboard (MDF) effluent aiming at the removal of TSS, COD, BOD and Turbidity by means of soil aquifer treatment (SAT). Removal of parameters were evaluated during transport of MDF effluent under unsaturated flow conditions in 1-m soil (sandy-clay soil) depth. The experimental results showed that the new process with SAT to be very effective. The TSS, COD, BOD and turbidity removal average was about 99%, 30%, 89 and 98.5% at the optimum operation condition, respectively. The SAT should be added before the UASB in order to achieve high removal rate of COD and BOD. The UASB (concentration sludge 40000 mg/l) after SAT treatment MDF... 

Laboratory experiments were carried out to investigate the effect of ultrasound waves on sludge reduction in MBBR bioreactor for industrial wastewater. The experiments were performed using two identical 20L MBBR bioreactor under same operational conditions. In MBBR with return sludge, sludge was collected from clarifier and after being sonicated, returned to the system by pump.
For determining optimum intensity and time duration of ultrasound, 0.3lit of MBBR sludge was sonicated with intensities of 20, 30, 60, 120, 150, 250 w/cm2 and time duration of 5, 10, 15, 20, 30 min. Afterward, these two parameters were optimized with Energy Efficiency Index. As the results shown, intensity of 120... 

Formation damage is probable to occur while drilling, work-over operations, and well completion in near wellbore zone due to different reasons; which leads to excess pressure drop through this area. Well stimulation operations are proposed to remove these damages and improve oil production; among which, acidizing is known as a traditional applicable method to stimulate oil and gas wells. Although this approach is accepted and chosen as a well stimulation method to remove formation damages, its poor design and implementation results in new formation damages. One of these arises when acid contacts asphaltic oil, which causes asphaltene particle instability and asphaltic sludge rapid... 

Oil refineries, petrochemical factories and oil platforms produce a large amount of oily wastewater every day. If these wastewaters are released in environment, it can damage soil and water seriously. Although, Biological treatment of oily wastewaters is a well-established method for remediation of these wastes, efficiency of conventional systems such as Activated Sludge, aren’t very high. Also these systems have many problems such as instability during hydraulics shocks and bulking phenomena. the hybrid bioreactor system are designed to increase the efficiency of treatment by allowing greater organic loads, increasing microbial concentration by using attached and suspended bacteria, and... 

There are a lot of industry, including refineries with saline wastewater. Biological wastewater treatment saline pose particular problems and leads to plasmolysis microorganisms in the presence of salt. Remove salt from the wastewater before biological treatment by reverse osmosis or ion exchange and other methods are expensive and often impossible. Remove nutrients from wastewater before disposal and give up their saline for nature is essential. Because the these materials, especially nitrogen and phosphorus can degrade water quality and even make it unusable. So that by increasing the concentration of the algae production is also too much and cause eutrophication of water tanks are grown.... 

A major environmental challenge for wastewater treatment in Iran and other countries is the disposal of excess sludge produced during the biological process. This project has been developing and testing a technology that will help to overcome this challenge in Kish Island wastewater plant. Results demonstrate it can perform highly effective treatment of municipal wastewater while producing low levels of sludge.Applicationofvermifiltrationfor treatment of wastewater sludge using the Eiseniafetida earthworm species. The earthworms’ gut acted as a biofilter whereby there was reduction in the sewage wastewater’s solid and liquid organic and inorganic wastes through ingestion and expelling these... 

Over 90 percent of the wastewater treatment systems use activated sludge which, yields to increase in organic loadings, these systems do not have appropriate performance. For upgrading of these systems a UASB reactor has been used prior to the activated sludge system, to improve the system performance and also reduce the excess sludge production. A membrane was also used instead of the sedimentation tank, to betterment the effluent quality. COD influent concentration was about 600 to 2400 mg/l, up to 98 percent of COD reduction obtain in this system. Also excess sludge reduction was over 90%. Such a system upgrading will increase treatment capacity by factor of 5. As it was shown, for UASBR,...