Sharif Digital Repository

The analysis of gravitational wave (GW) data from advanced LIGO provides the mass of each companion of binary black holes as the source of GWs. The mass of events corresponding to the binary black holes from GW is above 20 M Δ which is much larger than the mass of astrophysical black holes detected by x-ray observations. In this work, we examine primordial black holes (PBHs) as the source of LIGO events. Assuming that 100% of the dark matter is made of PBHs, we estimate the rate at which these objects make binaries, merge, and produce GWs as a function of the redshift. The gravitational lensing of GWs by PBHs can also enhance the amplitude of the strain. We simulate GWs sourced by binary... 

The flow through an axisymmetric supersonic mixed-compression air inlet has been simulated numerically to investigate the effects and the necessity of the three-dimensional (3D) modeling in comparison with the axisymmetric one. For this purpose, a supersonic inlet has been simulated numerically via axisymmetric and 3D CFD solvers, using the steady state Reynolds-averaged Navier-Stokes equations along with the SST k-ω turbulence model, for a free-stream Mach number of 2.0 and at zero degrees angle of attack. The grid for the 3D cases was a 14.4-degree sector, instead of a 360-degree domain one, with rotational periodic boundary condition for the side boundaries. The results show that both... 

A hot gas generator is a compact heat exchanger that produces high temperature or enthalpy gases. This paper presents two methods for controlling the system. The first one is an adaptive sliding mode controller that is a Lyapunov based method and proposed to confront the dynamic modeling deficiencies and system uncertainties. The second one is a linear adaptive controller that gives a new attractive ability to the system which can track a complicated requested path. Each of the presented controllers has some capabilities that may be preferred to other. In this paper, these methods are extensively compared by several transient inputs. On the other hand, since heat exchangers are typically... 

In this paper the question of the emission of fermions in the process of dilaton black hole evolution and its characteristics for different dilaton coupling constants α are studied. The main quantity of interest, the greybody factors, are calculated both numerically and in analytical approximation. The dependence of the rates of evaporation and behaviour on the dilaton coupling constant is analysed. Having calculated the greybody factors, we are able to address the question of the final fate of the dilaton black hole. For that we also need to perform dynamical treatment of the solution by considering the backreaction, which will show a crucial effect on the final result. We find a transition... 

In pebble bed reactors, the core is filled with thousands of graphite and fuel pebbles. Fuel pebbles in these reactors consist of TRISO particles, which are embedded in a graphite matrix stochastically. The reactor core is also stochastically filled with pebbles. These two stochastic geometries comprise the so-called double heterogeneous nature of this type of reactor. In this paper, a pebble bed reactor, the HTR-10, is used to demonstrate a treatment of this double heterogeneity using the MCNP5 Monte Carlo code and MATLAB programming. In this technique, TRISO particles are modeled in a pebble using the expanded FILL and LATTICE features of MCNP5. MATLAB is used to generate random numbers... 

The aim of this research is bonding of three-layered St/AZ31/St composite by roll-bonding process. The roll-bonding process was performed at three preheating temperatures, 340, 400 and 450°C, with thickness reduction of 30 to 68% and different thicknesses of intermediate layer (AZ31). In order to improve the bonding strength, the as-rolled specimens were annealed at constant temperature of 375°C. For evaluation of bond strength and investigating the formation of a diffusion layer, the results of peel test and microscopic images were studied. Tensile specimens were prepared along the rolling direction to measure the mechanical properties of the composite. The results showed that by increasing... 

Abstract: We consider the back reaction of the energy due to quantum fluctuation of the background fields considering the trace anomaly for Schwarzschild black hole. It is shown that it will result in modification of the horizon and also formation of an inner horizon. We show that the process of collapse of a thin shell stops before formation of the singularity at a radius slightly smaller than the inner horizon at the order of (Formula presented.). After the collapse stops the reverse process takes place. Thus we demonstrate that without turning on quantum gravity and just through the effects the coupling of field to gravity as trace anomaly of quantum fluctuations the formation of the... 

In this work, cold rolling behavior of stainless steel 304L is investigated and the effects of different process parameters on the occurrence of strain-induced martensite and mechanical properties are studied. The rolling experiments are conducted under different rolling speeds and reductions in which a set of samples is deformed at room temperature and the other set is first cooled to the temperature of − 10 °C and then rolled. Afterward, the developed microstructures and mechanical properties of the rolled steel are evaluated employing different testing techniques. In order to justify the results, mathematical modeling of cold rolling operation is also performed using Abaqus/Explicit to... 

Background: Although kinematic assessment has potentials for better evaluation of the movement quality, they are not widely used in clinics. Besides the equipment cost, the contradictory results of their clinimetric analysis are presumed as a major reason. This raises concerns about whether the current kinematic indices are intrinsically sound and truly reflect the quality of the subjects’ movement. Methods: A list of essential requirements for the kinematic indices (KIs) was proposed. Monotonic response to the change in the movement quality, independence from the task geometry and the subjects’ upper limb dimensions and speed, and robustness against the measurement error was investigated.... 

Petroleum contamination of soil is a serious problem throughout oil-producing countries. One of the cost-effective options for removing contaminants from shallow soils is phytoremediation. Vegetation, by stimulating the microorganisms via releasing root exudates near the rhizosphere, may play an important role in the biodegradation of toxic organic chemicals in soil. This experiment investigates the efficiency of this emerging technology following the implementation of five plant species. The study was carried out in a greenhouse using crude oil-contaminated soil from sites around the Tehran Refinery. To study the effect of a water-absorbent agent, we also used hydrogel in this experiment.... 

We use the Fokker-Planck equation and its moment equations to study the collective behavior of interacting particles in unsteady one-dimensional flows. Particles interact according to a longrange attractive and a short-range repulsive potential field known as Morse potential. We assume Stokesian drag force between particles and their carrier fluid and find analytic single-peaked traveling solutions for the spatial density of particles in the catastrophic phase. In steady flow conditions the streaming velocity of particles is identical to their carrier fluid, but we show that particle streaming is asynchronous with an unsteady carrier fluid. Using linear perturbation analysis, the stability... 

This paper addresses a nonlinear model predictive controller design for a single-phase PFC rectifier exploiting the Sheppard-Taylor converter. After approximation of the tracking error in the receding horizon by its Taylor-series expansion to any specified order, an analytic solution to the MPC is developed and a closed-form nonlinear predictive controller is introduced. The proposed nonlinear model predictive control (NMPC) derived using approximation can stabilize the original nonlinear systems if certain conditions, which can be met by properly choosing predictive times and the order for Taylor expansion, are satisfied. The main advantage of this digital control method is that unity power... 

In this paper CCM/CVM operation and modeling of the Sheppard-Taylor topology is reviewed and a predictive control strategy is applied for a Sheppard-Taylor-based power factor correction (PFC) rectifier. Compared to conventional boost or buck - boost PFC's, this topology allows a better current tracking at the AC side, with a relatively reduced voltage at the DC side. Consequently, the high frequency AC filters required by the buck PECs are avoided, and the voltage stresses on the boost switches are significantly reduced. Furthermore In predictive control strategy the duty cycle required to achieve unity power factor in a half line period can be calculated in advance. The main advantage of...